- 您现在的位置：买卖IC网 > PDF目录44995 > LTC4012IUF-3#TRPBF (LINEAR TECHNOLOGY CORP) BATTERY CHARGE CONTROLLER, 633 kHz SWITCHING FREQ-MAX, PQCC20 PDF资料下载
参数资料
| 型号： | LTC4012IUF-3#TRPBF |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | BATTERY CHARGE CONTROLLER, 633 kHz SWITCHING FREQ-MAX, PQCC20 |
| 封装： | 4 X 4 MM, 0.75 MM HEIGHT, LEAD FREE, PLASTIC, MO-220WGGD-1, QFN-20 |
| 文件页数： | 13/28页 |
| 文件大小： | 369K |
| 代理商： | LTC4012IUF-3#TRPBF |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页当前第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
0
40123fb
LTC4012-3
applicaTions inForMaTion
Table 4. Digital Read Back State (IN, Figure 10)
LTC4012-3
CHARGER STATE
OUT STATE
Hi-Z
1
Off
1
C/10 Charge
0
1
Bulk Charge
0
Input and Output Capacitors
In addition to typical input supply bypassing (0.1F) on
DCIN, the relatively high ESR of aluminum electrolytic ca-
pacitors is helpful for reducing ringing when hot-plugging
the charger to the AC adapter. Refer to LTC Application
Note 88 for more information.
The input capacitor between system power (drain of top
FET, Figure 1) and GND is required to absorb all input PWM
ripplecurrent,thereforeitmusthaveadequateripplecurrent
rating. Maximum RMS ripple current is typically one-half
of the average battery charge current. Actual capacitance
value is not critical, but using the highest possible voltage
rating on PWM input capacitors will minimize problems.
Consult with the manufacturer before use.
Figure 10. Microprocessor Status Interface
33k
200k
4012-3 F10
VDD
3.3V
P
IN
OUT
LTC4012-3
CHRG 7
C/10 CHRG Indicator
The value chosen for RPROG has a strong influence on
charge current monitoring and the accuracy of the C/10
charge indicator output (CHRG). The LTC4012-3 uses the
voltageonthePROGpintodeterminewhenchargecurrent
has dropped to the C/10 threshold. The nominal threshold
of 400mV produces an accurate low charge current indi-
cation of C/10 as long as RPROG = 26.7k, independent of
all other current programming considerations. However,
it may sometimes be necessary to deviate from this value
to satisfy other application design goals.
If RPROG is greater than 26.7k, the actual level at which
low charge current is detected will be less than C/10. The
highest value of RPROG that can be used while reliably
indicating low charge current before reaching final VBAT
is 30.1k. RPROG can safely be set to values higher than
this, but low current indication will be lost.
If RPROG is less than 26.7k, low charge current detection
occurs at a level higher than C/10. More importantly, the
LTC4012-3 becomes increasingly sensitive to reverse cur-
rent. The lowest value of RPROG that can be used without
the risk of erroneous boost operation detection at end of
charge is 26.1k. Values of RPROG less than this should not
be used. See the Operation section for more information
about reverse current.
The nominal fractional value of IMAX at which C/10 indica-
tion occurs is given by:
I
mV R
A
V R
C
MAX
PROG
10
400
11 67
1 2085
=
(
)
–
.
.
–
.
11 67A
(
)
Direct digital monitoring of C/10 indication is possible
with an external application circuit like the one shown in
Figure 9.
By using two different value pull-up resistors, a micro-
processor can detect three states from this pin (charging,
C/10 and not charging). See Figure 10. When a digital
output port (OUT) from the microprocessor drives one
of the resistors and a second digital input port polls the
network, the charge state can be determined as shown
in Table 4.
Figure 9. Digital C/10 Indicator
17
7
INTVDD
CHRG
Q1
TP0610T
Q2
2N7002
100k
LTC4012-3
4012-3 F09
100k
VLOGIC
100k
C/10
CHRG
100k
Q3
2N7002
相关PDF资料 |
PDF描述 |
|---|---|
| LTC4012IUF#TRPBF | SWITCHING CONTROLLER, 633 kHz SWITCHING FREQ-MAX, PQCC20 |
| LTC4012IUF-1#TRPBF | SWITCHING CONTROLLER, 633 kHz SWITCHING FREQ-MAX, PQCC20 |
| LTC4012IUF#PBF | SWITCHING CONTROLLER, 633 kHz SWITCHING FREQ-MAX, PQCC20 |
| LTC4065EDC-4.4#PBF | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO6 |
| LTC4070IDDB#TRPBF | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC4020EUHF#PBF | 制造商:Linear Technology 功能描述:Battery Charger Lead-Acid/Li-FePO4/Li-Ion/Li-Pol 20000mA 55V 38-Pin QFN EP 制造商:Linear Technology 功能描述:IC BATT CHARGER 55V BB 38QFN 制造商:Linear Technology 功能描述:BATTERY CHARGER, 20A, QFN-38 制造商:Linear Technology 功能描述:BATTERY CHARGER, 20A, QFN-38, Input Voltage:55V, Battery Charge Voltage:55V, Charge Current Max:20A, Battery IC Case Style:QFN, No. of Pins:38, No. of Series Cells:12, Operating Temperature Min:-40C, Operating Temperature Max:125C , RoHS Compliant: Yes |
| LTC4020EUHF#TRPBF | 制造商:Linear Technology 功能描述:Battery Charger Lead-Acid/Li-FePO4/Li-Ion/Li-Pol 20000mA 55V 38-Pin QFN EP T/R 制造商:Linear Technology 功能描述:IC BATT CHARGER 55V BB 38QFN 制造商:Linear Technology 功能描述:BATTERY CHARGER, 20A, QFN-38, Input Voltage:55V, Battery Charge Voltage:55V, Charge Current Max:20A, Battery IC Case Style:QFN, No. of Pins:38, No. of Series Cells:12, Operating Temperature Min:-40C, Operating Temperature Max:125C , RoHS Compliant: Yes |
| LTC4020IUHF#PBF | 制造商:Linear Technology 功能描述:Battery Charger Lead-Acid/Li-FePO4/Li-Ion/Li-Pol 20000mA 55V 38-Pin QFN EP 制造商:Linear Technology 功能描述:IC BATT CHARGER 55V BB 38QFN 制造商:Linear Technology 功能描述:BATTERY CHARGER, 20A, QFN-38 制造商:Linear Technology 功能描述:BATTERY CHARGER, 20A, QFN-38, Input Voltage:55V, Battery Charge Voltage:55V, Charge Current Max:20A, Battery IC Case Style:QFN, No. of Pins:38, No. of Series Cells:12, Operating Temperature Min:-40C, Operating Temperature Max:125C , RoHS Compliant: Yes |
| LTC4020IUHF#TRPBF | 制造商:Linear Technology 功能描述:Battery Charger Lead-Acid/Li-FePO4/Li-Ion/Li-Pol 20000mA 55V 38-Pin QFN EP T/R 制造商:Linear Technology 功能描述:IC BATT CHARGER 55V BB 38QFN 制造商:Linear Technology 功能描述:BATTERY CHARGER, 20A, QFN-38, Input Voltage:55V, Battery Charge Voltage:55V, Charge Current Max:20A, Battery IC Case Style:QFN, No. of Pins:38, No. of Series Cells:12, Operating Temperature Min:-40C, Operating Temperature Max:125C , RoHS Compliant: Yes |
| LTC4050 | 制造商:LINEAR 制造商全称:LINEAR 功能描述:Standalone 250mA Li-Ion Battery Charger in 2 × 2 DFN |
发布紧急采购，3分钟左右您将得到回复。