参数资料
| 型号： | LTC4081EDD#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 13/24页 |
| 文件大小： | 0K |
| 描述： | IC USB POWER MANAGER 10-DFN |
| 标准包装： | 2,500 |
| 功能： | 电源管理 |
| 电池化学： | 锂离子（Li-Ion）、锂聚合物（Li-Pol） |
| 电源电压： | 3.75 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-WFDFN 裸露焊盘 |
| 供应商设备封装： | 10-DFN（3x3） |
| 包装： | 带卷 (TR) |
LTC4081
OPERATIO
Timer and Recharge
The LTC4081’s battery charger has an internal charge
termination timer that starts when the input voltage is
greater than the undervoltage lockout threshold and at
least 82mV above BAT, and the battery charger is leaving
shutdown.
At power-up or when exiting shutdown, the charge time
is set to 4.5 hours. Once the charge cycle terminates, the
battery charger continuously monitors the BAT pin voltage
using a comparator with a 2ms ?lter time. When the aver-
age battery voltage falls below 4.1V (which corresponds
to 80%-90% battery capacity), a new charge cycle is initi-
ated and a 2.25 hour timer begins. This ensures that the
battery is kept at, or near, a fully charged condition and
eliminates the need for periodic charge cycle initiations.
The ? C ? H ? R ? G output assumes a strong pulldown state dur-
ing recharge cycles until C/10 is reached or the recharge
cycle terminates.
Battery Temperature Monitoring via NTC
The battery temperature is measured by placing a nega-
When the charger is in Hold mode (battery temperature
is either too hot or too cold) the ? C ? H ? R ? G pin pulses in a
2Hz, 25% duty cycle frequency unless the charge task is
?nished or the battery is assumed to be defective. If the
NTC pin is grounded, the NTC function will be disabled.
SWITCHING REGULATOR OPERATION:
The switching buck regulator in the LTC4081 can be turned
on by pulling the EN_BUCK pin above V IH . It has two user-
selectable modes of operation: constant-frequency (PWM)
mode and Burst Mode Operation. The constant-frequency
mode operation offers low noise at the expense of ef?ciency
whereas the Burst Mode operation offers higher ef?ciency
at light loads at the cost of increased noise, higher output
voltage ripple, and less output current. A detailed descrip-
tion of different operating modes and different aspects of
operation follow. Operations can best be understood by
referring to the Block Diagram.
V CC
tive temperature coef?cient (NTC) thermistor close to the
battery pack. The NTC circuitry is shown in Figure 2.
R NOM
0.76 ? V CC
To use this feature, connect the NTC thermistor, R NTC , be-
tween the NTC pin and ground and a resistor, R NOM , from
6
NTC
TOO COLD
the NTC pin to V CC . R NOM should be a 1% resistor with a
value equal to the value of the chosen NTC thermistor at
25°C (this value is 10k for a Vishay NTHS0603NO1N1002J
thermistor). The LTC4081 goes into hold mode when the
value of the NTC thermistor drops to 0.53 times the value
T R NTC
0.35 ? V CC
TOO HOT
of R NOM , which corresponds to approximately 40°C, and
when the value of the NTC thermistor increases to 3.26
times the value of R NOM , which corresponds to approxi-
mately 0°C. Hold mode freezes the timer and stops the
0.016 ? V CC
+
–
NTC_ENABLE
charge cycle until the thermistor indicates a return to a
valid temperature. For a Vishay NTHS0603NO1N1002J
thermistor, this value is 32.6k which corresponds to ap-
proximately 0°C. The hot and cold comparators each have
Figure 2. NTC Circuit Information
4081 F02
approximately 3°C of hysteresis to prevent oscillation
about the trip point.
4081f
13
相关PDF资料 |
PDF描述 |
|---|---|
| LTC4085EDE#TRPBF | IC USB POWER MANAGER 14-DFN |
| LTC4088EDE#TRPBF | IC BATT CHARGER/USB 14-DFN |
| LTC4089EDJC-5#TRPBF | IC USB POWER MANAGER 22-DFN |
| LTC4090EDJC-5#TRPBF | IC USB POWER MANAGER 22-DFN |
| LTC4095EDC#TRPBF | IC CHARGER LI-ION/POLY 8-DFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC4085 | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Efficiency Battery Charger/USB Power Manager |
| LTC4085-1 | 制造商:LINER 制造商全称:Linear Technology 功能描述:USB Power Manager with Ideal Diode Controller and 4.1V Li-Ion Charger |
| LTC4085-3 | 制造商:LINER 制造商全称:Linear Technology 功能描述:USB Power Manager with Ideal Diode Controller and 3.95V Li-Ion Charger |
| LTC4085EDE | 制造商:Linear Technology 功能描述:USB Power Manager 14-Pin DFN EP |
| LTC4085EDE#PBF | 功能描述:IC USB POWER MANAGER 14-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:- 其它有关文件:STC3100 View All Specifications 特色产品:STC3100 - Battery Monitor IC 标准包装:4,000 系列:- 功能:燃料，电量检测计/监控器 电池化学:锂离子（Li-Ion） 电源电压:2.7 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-TSSOP，8-MSOP（0.118"，3.00mm 宽） 供应商设备封装:8-MiniSO 包装:带卷 (TR) 其它名称:497-10526-2 |
发布紧急采购，3分钟左右您将得到回复。