- 您现在的位置：买卖IC网 > PDF目录22111 > LTC4261IUFD#PBF (Linear Technology)IC CTRLR HOTSWAP W/ADC 24-QFN PDF资料下载
参数资料
| 型号： | LTC4261IUFD#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 17/34页 |
| 文件大小： | 361K |
| 描述： | IC CTRLR HOTSWAP W/ADC 24-QFN |
| 标准包装： | 73 |
| 类型： | 热交换控制器 |
| 应用： | 通用 |
| 内部开关： | 无 |
| 电源电压： | 9 V ~ 11.2 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 24-WFQFN 裸露焊盘 |
| 供应商设备封装： | 24-QFN（5x4） |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页当前第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页
LTC4261/LTC4261-2
17
42612fc
EN and ON
Figure 5 shows a logic diagram for EN and ON as they
relate to GATE, ALERT and internal registers A4, A7, B4,
C4 and D3. Also affecting GATE is the status of UV, OV
and several other fault conditions. The EN and ON pins
have 0.8V to 2V logic thresholds relative to V
EE
with a
maximum input leakage current of ?礎.
Register bit A4 indicates the present state of EN, and B4
is set high whenever EN changes state. Rising and falling
edges at the ON pin set and clear FET-on control bit, D3.
Another path allows a falling edge at EN to latch a high
state at the ON pin (such as when ON is permanently
pulled high) into D3 after a time delay. Both B4 and D3
can be set or cleared directly by I
2
C, and both are cleared
low whenever INTV
CC
drops below its UVLO threshold.
The condition of the GATE pin output is controlled by
register bit A7, which is the AND of A4, D3 and the ab-
sence of UV, OV and other faults.
Overcurrent Protection and Overcurrent Fault
The LTC4261/LTC4261-2 feature two levels of protec-
tion from short-circuit and overcurrent conditions. Load
current is monitored by the SENSE pin and resistor
R
S
. There are two distinct thresholds for the voltage at
SENSE: 50mV for engaging the active current limit loop
and starting a 530祍 circuit breaker timer and 250mV for
a fast GATE pull-down to limit peak current in the event
of a catastrophic short circuit or an input step.
In an overcurrent condition, when the voltage drop across
R
S
exceeds 50mV, the current limit loop is engaged and
an internal 530祍 circuit breaker timer is started. The
current limit loop servos the GATE to maintain a constant
output current of 50mV/R
S
. When the circuit breaker
timer expires, the FET is turned off by pulling GATE down
with a 110mA current, the capacitors at SS and TMR are
discharged and the power good signals are reset. At this
time, the overcurrent present bit A2 and the overcurrent
fault bit B2 are set, and the circuit breaker timer is reset.
After the FET is turned off, the overcurrent present bit
A2 is cleared. If the overcurrent auto-retry bit D2 has
been set, the FET will turn on again automatically after
a cooling time of 4t
D
. Otherwise, the FET will remain off
until the overcurrent fault bit B2 is reset. When the over-
current fault bit is reset (see Resetting Faults), the FET
is allowed to turn on again after a delay of 4t
D
. The 4t
D
cooling time associated with the overcurrent fault will not
be interrupted by any other fault condition. See Figure 6
for operation of LTC4261/LTC4261-2 under overcurrent
condition followed by auto-retry.
Figure 5. Logic Block Diagram of EN and ON Pins
APPLICATIONS INFORMATION
R/W
I
2
C
CLR
Q
S
R
R/W
CLR
INTV
CC
UVLO
INTV
CC
UVLO
ABSENCE OF UV/OV AND OTHER FAULTS
Q
S
CLR
Q
S
1 t
D
TIMER
DELAY
EDGE
DETECTOR
STATE-CHANGE
DETECTOR
EN
ON
B4
C4
ALERT*
GATE ON
ALERT
42612 F05
READ ANY REGISTER
*B4 "燙4 IS ONE OF SEVEN CONDITIONS
THAT CAN GENERATE AN ALERT OUTPUT.
SEE TABLE 5
I
2
C ALERT RESPONSE
A4
A7
D3
相关PDF资料 |
PDF描述 |
|---|---|
| ISPLSI 2032E-135LJ44 | IC PLD ISP 32I/O 7.5NS 44PLCC |
| VI-2WF-CY-F2 | CONVERTER MOD DC/DC 72V 50W |
| ECC22DCSD-S288 | CONN EDGECARD 44POS .100 EXTEND |
| LTC4245CUHF#TRPBF | IC CNTRLR HOT SWAP 38-QFN |
| TOP265VG | IC OFFLINE SW PWM OCP OVP 12EDIP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC4263 | 制造商:LINER 制造商全称:Linear Technology 功能描述:12-Port PoE/PoE+/LTPoE++ PSE Controller |
| LTC4263-1 | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Power Single PSE Controller with Internal Switch |
| LTC4263CDE | 制造商:Linear Technology 功能描述:Compliant PSE Controller 14-Pin DFN EP |
| LTC4263CDE#PBF | 功能描述:IC IEEE 803.2AF CNTRLR 14DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 热交换 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:119 系列:- 类型:热交换控制器 应用:通用型，PCI Express? 内部开关:无 电流限制:- 电源电压:3.3V，12V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:80-TQFP 供应商设备封装:80-TQFP（12x12） 包装:托盘 产品目录页面:1423 (CN2011-ZH PDF) |
| LTC4263CDE#TRPBF | 功能描述:IC IEEE 803.2AF CNTRLR 14-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 热交换 系列:- 产品培训模块:Obsolescence Mitigation Program 标准包装:100 系列:- 类型:热插拔开关 应用:通用 内部开关:是 电流限制:可调 电源电压:9 V ~ 13.2 V 工作温度:-40°C ~ 150°C 安装类型:表面贴装 封装/外壳:10-WFDFN 裸露焊盘 供应商设备封装:10-TDFN-EP（3x3） 包装:管件 |
发布紧急采购，3分钟左右您将得到回复。