参数资料
型号: LTC4268IDKD-1#TRPBF
厂商: Linear Technology
文件页数: 26/46页
文件大小: 419K
描述: IC PD HIGH POWER W/CNTRL 32-DFN
标准包装: 2,500
类型: 以太网供电开关(PoE)
应用: 远程外设(工业控制,相机,数据访问)
内部开关:
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 32-WFDFN 裸露焊盘
供应商设备封装: 32-DFN(7x4)裸露焊盘
包装: 带卷 (TR)
LTC4268-1
26
42681fc
The flyback voltage is scaled by an external resistive
divider R1/R2 and presented at the FB pin. The feedback
amplifier compares the voltage to the internal bandgap
reference. The feedback amp is actually a transconductance
amplifier whose output is connected to V
CMP
 only during
a period in the flyback time. An external capacitor on
the V
CMP
 pin integrates the net feedback amp current to
provide the control voltage to set the current mode trip
point. The regulation voltage at the FB pin is nearly equal
to the bandgap reference V
FB
 because of the high gain in
the overall loop. The relationship between V
FLBK
 and V
FB
 
is expressed as:
 
V
FLBK
=
R1+R2
R2
V
FB
Combining this with the previous V
FLBK
 expression yields
an expression for V
OUT
 in terms of the internal reference,
programming resistors and secondary resistances:
V
OUT
=
R1+R2
R2
V
FB
N
SF
?/DIV>
?/DIV>
?/DIV>
?/DIV>
?/DIV>
?/DIV>
I
SEC
ESR+R
DS(ON)
(
)
The effect of nonzero secondary output impedance is
discussed in further detail; see Load Compensation Theory.
The practical aspects of applying this equation for V
OUT
 
are found in the Applications Information.
Feedback Amplifier Dynamic Theory
So far, this has been a pseudo-DC treatment of flyback
feedback amplifier operation. But the flyback signal is a
pulse, not a DC level. Provision is made to turn on the
flyback amplifier only when the flyback pulse is present
using the enable signal as shown in the timing diagram
(Figure 13).
Minimum Output Switch On Time (t
ON(MIN)
)
The LTC4268-1 affects output voltage regulation via
flyback pulse action. If the output switch is not turned on,
there is no flyback pulse and output voltage information
is not available. This causes irregular loop response and
start-up/latch-up problems. The solution is to require
the primary switch to be on for an absolute minimum
time per each oscillator cycle. To accomplish this the
current limit feedback is blanked each cycle for t
ON(MIN)
.
If the output load is less than that developed under these
conditions, forced continuous operation normally occurs.
See Applications Information for further details.
Enable Delay Time (ENDLY)
The flyback pulse appears when the primary side switch
shuts off. However, it takes a finite time until the transformer
primary side voltage waveform represents the output
voltage. This is partly due to rise time on the primary
applicaTions inForMaTion
PRIMARY SIDE
MOSFET DRAIN
VOLTAGE
PG VOLTAGE
SG VOLTAGE
V
IN
t
ON(MIN)
ENABLE
DELAY
MIN ENABLE
FEEDBACK
AMPLIFIER
ENABLED
PG DELAY
42681 F13
V
FLBK
0.8 " V
FLBK
Figure 13. LTC4268-1 Switching Regulator Timing Diagram
相关PDF资料
PDF描述
S102M25Z5UN6TJ6R CAP CER 1000PF 1KV 20% RADIAL
MAX8860EUA18+T IC REG LDO 1.8V/ADJ .3A 8-UMAX
VI-J13-CW-B1 CONVERTER MOD DC/DC 24V 100W
F152K43Y5RN6TJ7R CAP CER 1500PF 1KV 10% RADIAL
RSM31DTAI-S189 CONN EDGECARD 62POS R/A .156 SLD
相关代理商/技术参数
参数描述
LTC4269-1 制造商:LINER 制造商全称:Linear Technology 功能描述:IEEE 802.3at PD with Synchronous No-Opto Flyback Controller
LTC4269-2 制造商:LINER 制造商全称:Linear Technology 功能描述:IEEE 802.3at High Power PD and Synchronous Forward Controller with AUX Support
LTC4269CDKD-1#PBF 功能描述:IC PD/OPTO FLYBACK CTRLR 32-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 热交换 系列:- 标准包装:50 系列:- 类型:热交换控制器 应用:-48V 远程电力系统,AdvancedTCA ? 系统,高可用性 内部开关:无 电流限制:可调 电源电压:11.5 V ~ 14.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:10-TFSOP,10-MSOP(0.118",3.00mm 宽) 供应商设备封装:10-MSOP 包装:管件
LTC4269CDKD-1#TRPBF 功能描述:IC PD/OPTO FLYBACK CTRLR 32-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 热交换 系列:- 产品培训模块:Obsolescence Mitigation Program 标准包装:100 系列:- 类型:热插拔开关 应用:通用 内部开关:是 电流限制:可调 电源电压:9 V ~ 13.2 V 工作温度:-40°C ~ 150°C 安装类型:表面贴装 封装/外壳:10-WFDFN 裸露焊盘 供应商设备封装:10-TDFN-EP(3x3) 包装:管件
LTC4269CDKD-1-PBF 制造商:LINER 制造商全称:Linear Technology 功能描述:IEEE 802.3at PD with Synchronous No-Opto Flyback Controller