参数资料
| 型号： | LTC4312IMS#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 3/20页 |
| 文件大小： | 0K |
| 描述： | IC MULTIPLEXER 16-MSOP |
| 标准包装： | 2,500 |
| 系列： | * |
LTC4312
11
4312f
APPLICATIONS INFORMATION
Pull-Up Resistor Value Selection
To guarantee that the rise time accelerators are activated
during a rising edge, the bus must rise on its own with
a positive slew rate of at least 0.4V/μs. To achieve this,
choose a maximum RBUS using equation 1:
RBUS(Ω)≤
VDD,BUS(MIN) VRTA(TH)
()
0.4
V
s
CBUS
(1)
RBUS is the bus pull-up resistor, VDD,BUS(MIN) the minimum
bus pull-up supply voltage, VRTA(TH) the voltage at which
the rise time accelerator turns on, which is a function of
ACC,andCBUStheequivalentbuscapacitance.RBUSvalues
on each output channel must also be chosen to ensure
that when all the required output channels are enabled, the
total bus current is ≤4mA. The bus current in each output
channel can be 4mA if only one output channel is enabled
at any given time. The RBUS value on the input side must
also be chosen to limit the bus current to be ≤4mA. The
bus current for a single bus is determined by equation 2:
IBUS(A)=
VDD,BUS 0.4V
RBUS
(2)
Input to Output Offset Voltage and Propagation Delay
The LTC4312 introduces both an offset as well as a
propagation delay for falling edges between the input and
output. When a logic low voltage of ≥200mV is driven
on any of the LTC4312’s data or clock pins, the LTC4312
regulates the voltage on the opposite side to a slightly
higher value. When SCLIN or SDAIN is driven to a logic
low voltage, SCLOUT or SDAOUT is driven to a slightly
higher voltage as directed by equation 3 which uses SDA
as an example:
VSDAOUT(V) = VSDAIN + 45mV
+ (10Ω + RMUX )
VDD,BUS
RBUS
(3)
VDD,BUS is the output bus voltage, RBUS the output bus
pull-up resistance and RMUXistheresistanceofthechannel
transmission gate in the multiplexer shown in the block
diagram. The offset is affected by the VCC2 voltage and bus
current. A higher VCC2 voltage (VCC if VCC2 is grounded)
reduces RMUX leading to a lower offset. See the Typical
Performance Characteristics plots for the variation of RMUX
as a function of VCC2 and temperature. When SDAOUT or
SCLOUT is driven to a logic low voltage ≥ 200mV, SCLIN
Figure 4. Connection of the LTC4312 in a Level Shift Application. VCC Is Less Than or Equal to the Minimum
Bus Supply Voltages on the Output Side. VCC2 Is Grounded to Disable Output Rise Time Accelerators
LTC4312
GND
VCC
VCC2
4312 F04
SCLOUT1
SDAOUT1
SCLOUT2
SDAOUT2
SCLOUT1
SDAOUT1
SCLOUT2
SDAOUT2
SCLIN
SDAIN
ENABLE1
ENABLE2
ACC
DISCEN
FAULT
SCLIN
SDAIN
ENABLE1
ENABLE2
3.3V
FAULT
R3
10k
R2
10k
R1
10k
C1
0.01μF
C2
0.01μF
3.3V
R5
10k
R4
10k
5V
R7
10k
R6
10k
相关PDF资料 |
PDF描述 |
|---|---|
| LTC4313IMS8-1#PBF | IC 2WIRE BUS BUFFER 8MSOP |
| LTC4314IGN#PBF | IC MULTIPLEXER 20-MSOP |
| LTC4315IMS#TRPBF | IC 2WIRE BUS BUFFER 12MSOP |
| LTC485IS8#TRPBF | IC TXRX INTRFC RS485 LOPWR 8SOIC |
| LTC487IN#PBF | IC DVR RS485 LOW PWR QUAD 16-DIP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC4313CDD-1#PBF | 功能描述:IC 2WIRE BUS BUFFER 8DFN RoHS:是 类别:集成电路 (IC) >> 接口 - 信号缓冲器，中继器，分配器 系列:- 标准包装:160 系列:- 类型:转发器 Tx/Rx类型:以太网 延迟时间:- 电容 - 输入:- 电源电压:2.37 V ~ 2.63 V 电流 - 电源:60mA 安装类型:表面贴装 封装/外壳:64-TQFP 裸露焊盘 供应商设备封装:64-TQFP-EP（10x10） 包装:托盘 其它名称:Q5134101 |
| LTC4313CDD-1#TRPBF | 功能描述:IC 2WIRE BUS BUFFER 8DFN RoHS:是 类别:集成电路 (IC) >> 接口 - 信号缓冲器，中继器，分配器 系列:- 标准包装:160 系列:- 类型:转发器 Tx/Rx类型:以太网 延迟时间:- 电容 - 输入:- 电源电压:2.37 V ~ 2.63 V 电流 - 电源:60mA 安装类型:表面贴装 封装/外壳:64-TQFP 裸露焊盘 供应商设备封装:64-TQFP-EP（10x10） 包装:托盘 其它名称:Q5134101 |
| LTC4313CDD-2#PBF | 功能描述:IC 2WIRE BUS BUFFER 8DFN RoHS:是 类别:集成电路 (IC) >> 接口 - 信号缓冲器，中继器，分配器 系列:- 标准包装:160 系列:- 类型:转发器 Tx/Rx类型:以太网 延迟时间:- 电容 - 输入:- 电源电压:2.37 V ~ 2.63 V 电流 - 电源:60mA 安装类型:表面贴装 封装/外壳:64-TQFP 裸露焊盘 供应商设备封装:64-TQFP-EP（10x10） 包装:托盘 其它名称:Q5134101 |
| LTC4313CDD-2#TRPBF | 功能描述:IC 2WIRE BUS BUFFER 8DFN RoHS:是 类别:集成电路 (IC) >> 接口 - 信号缓冲器，中继器，分配器 系列:- 标准包装:160 系列:- 类型:转发器 Tx/Rx类型:以太网 延迟时间:- 电容 - 输入:- 电源电压:2.37 V ~ 2.63 V 电流 - 电源:60mA 安装类型:表面贴装 封装/外壳:64-TQFP 裸露焊盘 供应商设备封装:64-TQFP-EP（10x10） 包装:托盘 其它名称:Q5134101 |
| LTC4313CDD-3#PBF | 功能描述:IC 2WIRE BUS BUFFER 8DFN RoHS:是 类别:集成电路 (IC) >> 接口 - 信号缓冲器，中继器，分配器 系列:- 标准包装:160 系列:- 类型:转发器 Tx/Rx类型:以太网 延迟时间:- 电容 - 输入:- 电源电压:2.37 V ~ 2.63 V 电流 - 电源:60mA 安装类型:表面贴装 封装/外壳:64-TQFP 裸露焊盘 供应商设备封装:64-TQFP-EP（10x10） 包装:托盘 其它名称:Q5134101 |
发布紧急采购，3分钟左右您将得到回复。