参数资料
| 型号： | LTC6247IMS8#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 22/24页 |
| 文件大小： | 0K |
| 描述： | IC OPAMP DUAL 180MHZ 8MSOP |
| 标准包装： | 2,500 |
| 放大器类型： | 通用 |
| 电路数： | 2 |
| 输出类型： | 满摆幅 |
| 转换速率： | 90 V/µs |
| 增益带宽积： | 180MHz |
| -3db带宽： | 120MHz |
| 电流 - 输入偏压： | 400nA |
| 电压 - 输入偏移： | 100µV |
| 电流 - 电源： | 1.25mA |
| 电流 - 输出 / 通道： | 100mA |
| 电压 - 电源，单路/双路(±)： | 2.5 V ~ 5.25 V，±1.25 V ~ 2.625 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-TSSOP，8-MSOP（0.118"，3.00mm 宽） |
| 供应商设备封装： | 8-MSOP |
| 包装： | 带卷 (TR) |
LTC6246/LTC6247/LTC6248
624678fa
elecTrical characTerisTics
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 2: The inputs are protected by back-to-back diodes. If any of
the input or shutdown pins goes 300mV beyond either supply or the
differential input voltage exceeds 1.4V the input current should be limited
to less than 10mA. This parameter is guaranteed to meet specified
performance through design and/or characterization. It is not production
tested.
Note 3: A heat sink may be required to keep the junction temperature
below the absolute maximum rating when the output current is high.
Note 4: The LTC6246C/LTC6247C/LTC6248C and LTC6246I/LTC6247I/
LTC6248I are guaranteed functional over the temperature range of –40°C
to 85°C. The LTC6246H/LTC6247H/LTC6248H are guaranteed functional
over the temperature range of –40°C to 125°C.
Note 5: The LTC6246C/LTC6247C/LTC6248C are guaranteed to meet
specified performance from 0°C to 70°C. The LTC6246C/LTC6247C/
LTC6248C are designed, characterized and expected to meet specified
performance from –40°C to 85°C but are not tested or QA sampled at
these temperatures. The LTC6246I/LTC6247I/LTC6248I are guaranteed
to meet specified performance from –40°C to 85°C. The LTC6246H/
LTC6247H/LTC6248H are guaranteed to meet specified performance from
–40°C to 125°C.
Note 6: Minimum supply voltage is guaranteed by power supply rejection
ratio test.
Note 7: The input bias current is the average of the average of the currents
through the positive and negative input pins.
Note 8: Matching parameters are the difference between amplifiers A and
D and between B and C on the LTC6248; between the two amplifiers on the
LTC6247.
Note 9: Thermal resistance varies with the amount of PC board metal
connected to the package. The specified values are with short traces
connected to the leads with minimal metal area.
Note 10: The output voltage is varied from 0.5V to 4.5V during
measurement.
Note 11: Middle 80% of the output waveform is observed. RL = 1k at half
supply.
Note 12: The output voltage is varied from 0.5V to 2.2V during
measurement.
Note 13: FPBW is determined from distortion performance in a gain of +2
configuration with HD2, HD3 < –40dBc as the criteria for a valid output.
Note 14: Differential gain and phase are measured using a Tektronix
TSG120YC/NTSC signal generator and a Tektronix 1780R video
measurement set.
VOS Distribution, VCM = VS/2
(MS, PNP Stage)
VOS Distribution, VCM = VS/2
(TSOT-23, PNP Stage)
VOS Distribution, VCM = V+ – 0.5V
(MS, NPN Stage)
Typical perForMance characTerisTics
(VS = 2.7V) The l denotes the specifications which apply across the
specified temperature range, otherwise specifications are at TA = 25°C. For each amplifier VS = 2.7V, 0V; VSHDN = 2V; VCM = VOUT =
1.35V, unless otherwise noted.
SYMBOL
PARAMETER
CONDITIONS
MIN
TYP
MAX
UNITS
FPBW
Full Power Bandwidth
VOUT = 2VP-P (Note 13)
3.3
MHz
Crosstalk
AV = –1, RL = 1k to Half Supply,
VOUT = 2VP-P, f = 1MHz
–90
dB
INPUT OFFSET VOLTAGE (V)
PERCENT
OF
UNITS
(%)
22
20
16
12
8
2
18
14
10
6
4
0
–50
–150
150
624678 G01
350
250
–250
–375
50
VS = 5V, 0V
VCM = 2.5V
INPUT OFFSET VOLTAGE (V)
PERCENT
OF
UNITS
(%)
25
15
5
20
10
0
–125
–25
–75
624678 G02
75
125
25
175
–175
VS = 5V, 0V
VCM = 2.5V
INPUT OFFSET VOLTAGE (V)
PERCENT
OF
UNITS
(%)
16
12
8
2
14
10
6
4
0
–1200
400
–400
624678 G03
1200
2000
–2000
VS = 5V, 0V
VCM = 4.5V
相关PDF资料 |
PDF描述 |
|---|---|
| NE5532AN | IC OPAMP DUAL LOW NOISE 8-DIP |
| NE5517DR2 | IC AMP XCONDUCTANCE DUAL 16-SOIC |
| LTC1992HMS8 | IC AMP DIFF I/O ADJ OUT 8-MSOP |
| AS168X-CB1DF040 | CIRCUIT BRKR THERMAL 4.0A 1POLE |
| NE5532AD8R2 | IC OPAMP DUAL LOW NOISE 8-SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC6247ITS8 | 制造商:LINER 制造商全称:Linear Technology 功能描述:180MHz, 1mA Power Efficient Rail-to-Rail I/O Op Amps |
| LTC6247ITS8#PBF | 制造商:Linear Technology 功能描述:OP Amp Dual GP R-R I/O 5.25V 8-Pin TSOT-23 制造商:Linear Technology 功能描述:IC OP-AMP 180MHZ 90V/ us TSOT-23-8 制造商:Linear Technology 功能描述:IC, OP-AMP, 180MHZ, 90V/ us, TSOT-23-8 制造商:Linear Technology 功能描述:IC, OP-AMP, 180MHZ, 90V/ us, TSOT-23-8; Op Amp Type:Low Power; No. of Amplifiers:2; Slew Rate:90V/s; Supply Voltage Range:2.5V to 5.25V; Amplifier Case Style:TSOT-23; No. of Pins:8; Bandwidth:180MHz; Operating Temperature Min:-40C ;RoHS Compliant: Yes |
| LTC6247ITS8#TRMPBF | 功能描述:IC OPAMP RRIO 180MHZ DL TSOT23-8 RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 其它有关文件:Automotive Product Guide 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1 系列:- 放大器类型:通用 电路数:1 输出类型:满摆幅 转换速率:3 V/µs 增益带宽积:10MHz -3db带宽:- 电流 - 输入偏压:1pA 电压 - 输入偏移:70µV 电流 - 电源:2.5mA 电流 - 输出 / 通道:48mA 电压 - 电源，单路/双路(±):2.7 V ~ 5.5 V，±1.35 V ~ 2.75 V 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:SOT-23-6 供应商设备封装:SOT-6 包装:Digi-Reel® 其它名称:MAX4475AUT#TG16DKR |
| LTC6247ITS8#TRPBF | 功能描述:IC OPAMP RRIO 180MHZ DL TSOT23-8 RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 其它有关文件:Automotive Product Guide 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1 系列:- 放大器类型:通用 电路数:1 输出类型:满摆幅 转换速率:3 V/µs 增益带宽积:10MHz -3db带宽:- 电流 - 输入偏压:1pA 电压 - 输入偏移:70µV 电流 - 电源:2.5mA 电流 - 输出 / 通道:48mA 电压 - 电源，单路/双路(±):2.7 V ~ 5.5 V，±1.35 V ~ 2.75 V 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:SOT-23-6 供应商设备封装:SOT-6 包装:Digi-Reel® 其它名称:MAX4475AUT#TG16DKR |
| LTC6247ITS8TRMPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:180MHz, 1mA Power Efficient Rail-to-Rail I/O Op Amps |
发布紧急采购，3分钟左右您将得到回复。