- 您现在的位置：买卖IC网 > PDF目录79876 > LTH2911HDDB-5#TR (LINEAR TECHNOLOGY CORP) POWER SUPPLY SUPPORT CKT, PDSO8 PDF资料下载
参数资料
| 型号： | LTH2911HDDB-5#TR |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 电源管理 |
| 英文描述： | POWER SUPPLY SUPPORT CKT, PDSO8 |
| 封装： | 3 X 2 MM, PLASTIC, MO-229, DFN-8 |
| 文件页数： | 4/20页 |
| 文件大小： | 245K |
| 代理商： | LTH2911HDDB-5#TR |
LTC2911
12
2911f
Again, to minimize errors arising from the PFI input bias
current, a value of less than 100k is recommended for
R3.
R4 can be chosen either using the PFI falling threshold or
the PFI rising threshold.
For the falling edge threshold, use the equation:
R4
=R3
VTRIP_ PFI_FALL
0.5V
– 1
Alternatively, for the rising edge threshold, use the
equation:
R4
=R3
VTRIP_ PFI_RISE
0.515V
– 1
where VTRIP_PFI_FALL is the supply threshold when the PFI
pinfallsbelowthe0.5Vfallingthreshold,andVTRIP_PFI_RISE
is the supply threshold when the PFI pin rises above the
0.515V rising threshold.
Note that VTRIP_PFI_RISE is typically 3% above the
VTRIP_PFI_FALL due to the fact that the PFI 515mV rising
threshold is 3% above its 500mV falling threshold.
In applications that require an accurate trip point, the R4
and R3 resistors should have small tolerances.
Hysteresis for Power-Fail Comparator
The power-fail comparator uses a positive 3% accurate
hysteresis to combat spurious triggering while maintain-
ing accurate thresholds for both the rising and falling
edges. The nominal threshold is 500mV at the falling edge
and 515mV at the rising edge. The hysteresis prevents
oscillation when the monitored voltage passes through
the thresholds. If the PFI pin is connected to an external
resistive divider, it may be bypassed with a capacitor for
additional noise filtering.
Increasing the Power-Fail Hysteresis
The power-fail comparator hysteresis can be increased by
adding two resistors, R5 and R6, as shown in Figure 3b.
When PFO is low, R5 sinks current from the center tap
of the R3 and R4 resistive divider. The upper threshold is
therefore given by:
VH = 0.515V 1+
R4
R3
+
R4
R5
When PFO is high, the series combination of R5 and R6
sources current into the center tap of the R3 and R4 resis-
tive divider. This leads to a lower threshold of:
VL = 0.5V 1+
R4
R3
–
3.3V – 0.5V
(
)R4
R5
+R6
The addition of R5 and R6 increases the hysteresis to:
VHYST = VH – VL
= 0.015 1+
R4
R3
+ 0.515
R4
R5
+
3.3V – 0.5V
(
)R4
R5
+R6
APPLICATIONS INFORMATION
Figure 3a. Setting the Power-Fail (PFI) Trip Point
–
+
+–
0.5V
2911 F03a
PFI
V1
114k
PFO
LTC2911
R4
R3
VTRIP
Figure 3b. Increasing Power-Fail Hysteresis
–
+
+–
0.5V
2911 F03b
PFI
V1
PFO
LTC2911
R4
R6
R5
R3
VTRIP
114k
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3872IDDB#TRPBF | SWITCHING CONTROLLER, 650 kHz SWITCHING FREQ-MAX, PDSO8 |
| LED15-48S15W-A | 1-OUTPUT 15 W DC-DC REG PWR SUPPLY MODULE |
| LED15-48S15W | 1-OUTPUT 15 W DC-DC REG PWR SUPPLY MODULE |
| LPT53 | 3-OUTPUT 50 W AC-DC REG PWR SUPPLY MODULE |
| LX1555CM | 1 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDIP8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTH-301-05 | 功能描述:光学开关（透射型，光电晶体管输出） Photointerrupter Phototransistor RoHS:否 制造商:Omron Electronics 输出设备:Phototransistor 槽宽:3.4 mm 光圈宽度:0.5 mm 集电极—发射极最大电压 VCEO:30 V 最大集电极电流:20 mA 正向电流: 安装风格:Through Hole 最大工作温度:+ 85 C 最小工作温度:- 25 C 封装: |
| LTH-301-07 | 功能描述:光学开关（透射型，光电晶体管输出） Photointerrupter Phototransistor RoHS:否 制造商:Omron Electronics 输出设备:Phototransistor 槽宽:3.4 mm 光圈宽度:0.5 mm 集电极—发射极最大电压 VCEO:30 V 最大集电极电流:20 mA 正向电流: 安装风格:Through Hole 最大工作温度:+ 85 C 最小工作温度:- 25 C 封装: |
| LTH301-07 | 制造商:Lite-On Semiconductor Corporation 功能描述: |
| LTH-301-07P1 | 制造商:LITEON 制造商全称:Lite-On Technology Corporation 功能描述:Property of LITE-ON Only |
| LTH-301-07P2 | 制造商:LITEON 制造商全称:Lite-On Technology Corporation 功能描述:Property of LITE-ON Only |
发布紧急采购，3分钟左右您将得到回复。