参数资料
型号: LX1677CPW-TR
厂商: MICROSEMI CORP-ANALOG MIXED SIGNAL GROUP
元件分类: 稳压器
英文描述: 1.5 A SWITCHING CONTROLLER, 1100 kHz SWITCHING FREQ-MAX, PDSO38
封装: ROHS COMPLIANT, PLASTIC, TSSOP-38
文件页数: 4/16页
文件大小: 320K
代理商: LX1677CPW-TR
LX1677
PRODUCTION DATA SHEET
Microsemi
Integrated Products Division
11861 Western Avenue, Garden Grove, CA. 92841, 714-898-8121, Fax: 714-893-2570
Page 12
WWW
.Microse
m
i
.CO
M
AMD64 Processor VRM Controller
Copyright
2000
Rev 1.1, 2003-03-03
TM
TH EORY OF O PERATION (CONTINUED)
LOOP GAIN AUTOMATIC COMPENSATION
The PWM ramp shown in Figure 5 is automatically
adjusted to keep its amplitude a fixed percentage of Vin
over the range of 6 to 24 V input.
This maintains a constant loop gain that is set by the
feedback networks around the error amplifiers independent
of PWM input voltage.
TRANSIENT CORRECTION LOOP
Phase 3 is a Transient Correction Loop that can sum a
large amount of current into the output node when required
by an out of range condition. The differential feedback
summing amplifier is connected directly to the output
terminals and has sufficient bandwidth to follow any fast
changes in output voltage. The feedback error voltage is
compared to the commanded reference voltage (DACOUT)
by two high speed comparators, I-Max and I-Min. The
other inputs of these
comparators are offset from the
DACOUT as shown in Fig 6. If the error in output voltage
exceeds the offset in either direction the appropriate
MOSFET will be turned on to force current into or out of
the output node to correct the voltage error. The very low
value inductor (100nH) allows large amounts of current to
be forced into or out of the output node very quickly.
When the Transient Correction Loop is switching it
forces the appropriate upper or lower MOSFETs in phases
1 and 2 to stay on (100% or 0% duty cycle) until the error
is corrected.
The two drivers for the Transient Correction Loop have
outputs (I-Max) and (I-Min) that may be used to drive a
half bridge to correct for both low and high output voltage
conditions. This permits pulling the output low if an
overshoot occurs due to a rapid reduction in load current.
With a conventional Buck regulator rapid changes in the
negative direction are not possible due to the low voltage
available as a forcing function.
The two outputs (I-MAX and I-MIN) are completely
independent. A single MOSFET and diode can be used to
correct for voltage droop only or voltage overshoot only
when driven by the appropriate output. If the I-MAX driver
is not used the VC3 and VS3 pins must be connected to +5
volts.
Under normal operation the Transient Correction phase
is only active for a very brief time during high di/dt loads
on the output.
VC3
I-Min
PGN3
Vout
+
-
+
-
35mV
70nH
VS3
I-Max
VCCL
I-Min
Comparator
I-Max
Comparator
+5V
FB -
FB +
+
-
DACOUT
Figure 6 – Phase 3 Transient Correction Loop
AA
PP
LL
IICC
AA
TT
IIOO
NN
SS
相关PDF资料
PDF描述
LX1684CD-TR 1 A SWITCHING CONTROLLER, 200 kHz SWITCHING FREQ-MAX, PDSO14
LX1688IPW-TR FLUORESCENT LIGHT CONTROLLER, 70 kHz SWITCHING FREQ-MAX, PDSO24
LX1689IPWT FLUORESCENT LIGHT CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO20
LX1689CPWT FLUORESCENT LIGHT CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO20
LX1691AIPW-TR 0.1 A FLUORESCENT LIGHT CONTROLLER, 250 kHz SWITCHING FREQ-MAX, PDSO16
相关代理商/技术参数
参数描述
LX1681 制造商:MICROSEMI 制造商全称:Microsemi Corporation 功能描述:VOLTAGE - MODE PWM CONTROLLERS
LX1681_05 制造商:MICROSEMI 制造商全称:Microsemi Corporation 功能描述:Voltage-Mode PWM Controllers
LX1681CDM 功能描述:IC REG CTRLR DIVIDER PWM 8-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,000 系列:- PWM 型:电压模式 输出数:1 频率 - 最大:1.5MHz 占空比:66.7% 电源电压:4.75 V ~ 5.25 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:40-VFQFN 裸露焊盘 包装:带卷 (TR)
LX1681CDMT 制造商:MICROSEMI 制造商全称:Microsemi Corporation 功能描述:Voltage-Mode SMPS Controller
LX1681CDM-TR 制造商:MICROSEMI 制造商全称:Microsemi Corporation 功能描述:Voltage-Mode PWM Controllers