- 您现在的位置：买卖IC网 > PDF目录369885 > LXT363PE PCM TRANSCEIVER|SINGLE|T-1(DS1)|CMOS|LDCC|28PIN|PLASTIC PDF资料下载
参数资料
| 型号： | LXT363PE |
| 英文描述： | PCM TRANSCEIVER|SINGLE|T-1(DS1)|CMOS|LDCC|28PIN|PLASTIC |
| 中文描述： | 的PCM收发器|单|的T 1（DS1的）|的CMOS | LDCC | 28脚|塑料 |
| 文件页数： | 24/52页 |
| 文件大小： | 1187K |
| 代理商： | LXT363PE |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页当前第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页
LXT361
—
Integrated T1/E1 LH/SH Transceiver for DS1/DSX-1 or PRI Applications
24
Datasheet
3.5.5
Other Diagnostic Reports
3.5.5.1
Receive Line Attenuation Indication
The Equalizer Status Register (ESR) provides an approximation of the line attenuation encountered
by the device. The four most significant bits of the register (ESR.LATN7:4) indicate line
attenuation in approximately 2.9 dB steps for both T1 and E1 operation of the receive equalizer.
For instance, if ESR.LATN7:4 is 10 (decimal), then the receiver is seeing a signal attenuated by
approximately 29 dB (2.9 dB x 10) of cable loss.
3.5.5.2
Built-In Self Test
LXT361 provides a Built-In Self Test (BIST) capability. The BIST exercises the internal circuits by
providing an internal QRSS pattern, running it through the encoders and the transmit drivers then
looping it back through the receive equalizer, jitter attenuator and decoders to the QRSS pattern
detection circuitry. If all the blocks in this data path function correctly, the receive pattern detector
locks onto the pattern. It then pulls INT Low and sets the following bits:
TSR.TQRSS = 1
PSR.QRSS = 1
PSR.BIST = 1
Note that during BIST, the TPOS/TNEG inputs must remain at logic level = 0
The most reliable test will result when a separate TCLK and MCLK are applied and the Line
Build-Out (LBO) is set to -22.5 dB (CR1.EC4:1 = 011x).
3.6
Parallel Microprocessor Interface
The LXT361 multiplexed address/data bus and timing/control signals are compatible with both the
Intel and Motorola microprocessors. See
Figure 16
and
Figure 17
for the I/O timing diagram for
each bus. The LXT361 detects and distinguishes between Intel and Motorola timing and then
automatically selects the appropriate bus timing. The maximum recommended processor speed for
an Intel device is 20 MHz; for a Motorola device, 16.78 MHz. See
“
Test Specifications
”
on
page 36
for microprocessor interface timing details.
The LXT361 contains five read/write and three read-only registers for control and status purposes.
Table 6 on page 26
is a summary of the registers.
Table 7
through
Table 15
identify and explain the
function of the register bits.
3.6.1
Interrupt Handling
The LXT361 provides a latched interrupt output pin (INT). When enabled, a change in any of the
Performance Status Register bits will generate an interrupt. An interrupt can also be generated
when the elastic store overflows (TSR.ESOVR) or underflows (TSR.ESUNF). When an interrupt
occurs, the INT output pin is pulled Low. Note that the output stage of the INT pin has internal
pull-down only. Therefore, each device that shares the INT line
requires an
external pull-up
resistor
.
相关PDF资料 |
PDF描述 |
|---|---|
| LXT363QE | PCM TRANSCEIVER|SINGLE|T-1(DS1)|CMOS|QFP|44PIN|PLASTIC |
| LXT360LE | PCM TRANSCEIVER|SINGLE|CEPT PCM-30/E-1|CMOS|QFP|44PIN|PLASTIC |
| LXT360PE | PCM TRANSCEIVER|SINGLE|CEPT PCM-30/E-1|CMOS|LDCC|28PIN|PLASTIC |
| LXT384BE | Telecomm/Datacomm |
| LXT384LE | Telecomm/Datacomm |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LXT363QE | 制造商:未知厂家 制造商全称:未知厂家 功能描述:PCM TRANSCEIVER|SINGLE|T-1(DS1)|CMOS|QFP|44PIN|PLASTIC |
| LXT36X/35X | 制造商:未知厂家 制造商全称:未知厂家 功能描述:LXT36x/35x - LXT36x/35x Master Clock Requirements |
| LXT380/4 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:LXT380/4 - LXT380/4 Octal T1/E1 LIUs Interfacing with the Transwitch Octal Framers |
| LXT380/LXT381 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:LXT380/LXT381 - LXT380/1 Frequently Asked Questions |
| LXT381 | 制造商:INTEL 制造商全称:Intel Corporation 功能描述:Octal E1 Line Interface Unit |
发布紧急采购，3分钟左右您将得到回复。