参数资料
型号: M38853F1-HP
厂商: Renesas Technology Corp.
英文描述: Dual 2.7-V High Slew Rate Rail-To-Rail Output Operational Amplifier 8-MSOP -40 to 125
中文描述: 单芯片8位CMOS微机
文件页数: 10/73页
文件大小: 1580K
代理商: M38853F1-HP
18
Atmel | SMART SAM D20 [DATASHEET]
Atmel-42129K–SAM-D20_datasheet–06/2014
7.3
Power-Up
This section summarizes the power-up sequence of the SAM D20. The behavior after power-up is controlled by the
Power Manager. Refer to “PM – Power Manager” on page 101 for details.
7.3.1
Starting of Clocks
After power-up, the device is set to its initial state and kept in reset, until the power has stabilized throughout the device.
Once the power has stabilized, the device will use a 1MHz clock. This clock is derived from the 8MHz Internal Oscillator
(OSC8M), which is divided by eight and used as a clock source for generic clock generator 0. Generic clock generator 0
is the main clock for the Power Manager (PM).
Some synchronous system clocks are active, allowing software execution.
Refer to the “Clock Mask Register” section in “PM – Power Manager” on page 101 for the list of default peripheral clocks
running. Synchronous system clocks that are running are by default not divided and receive a 1MHz clock through
generic clock generator 0. Other generic clocks are disabled except GCLK_WDT, which is used by the Watchdog Timer
(WDT).
7.3.2
I/O Pins
After power-up, the I/O pins are tri-stated.
7.3.3
Fetching of Initial Instructions
After reset has been released, the CPU starts fetching PC and SP values from the reset address, which is 0x00000000.
This address points to the first executable address in the internal flash. The code read from the internal flash is free to
configure the clock system and clock sources. Refer to “PM – Power Manager” on page 101, “GCLK – Generic Clock
Reference Manual for more information on CPU startup (http://www.arm.com).
7.4
Power-On Reset and Brown-Out Detector
The SAM D20 embeds three features to monitor, warn and/or reset the device:
POR: Power-on reset on VDDANA
BOD33: Brown-out detector on VDDANA
BOD12: Voltage Regulator Internal Brown-out detector on VDDCORE. The Voltage Regulator Internal BOD is
calibrated in production and its calibration configuration is stored in the NVM User Row. This configuration should
not be changed if the user row is written to assure the correct behavior of the BOD12.
7.4.1
Power-On Reset on VDDANA
POR monitors VDDANA. It is always activated and monitors voltage at startup and also during all the sleep modes. If
VDDANA goes below the threshold voltage, the entire chip is reset.
7.4.2
Brown-Out Detector on VDDANA
BOD33 monitors VDDANA. Refer to “SYSCTRL – System Controller” on page 128 for details.
7.4.3
Brown-Out Detector on VDDCORE
Once the device has started up, BOD12 monitors the internal VDDCORE.
相关PDF资料
PDF描述
M39010/01AR82KS 1 ELEMENT, 0.82 uH, PHENOLIC-CORE, GENERAL PURPOSE INDUCTOR
IMS-5A-ER0.82UH+/-5% 1 ELEMENT, 0.82 uH, PHENOLIC-CORE, GENERAL PURPOSE INDUCTOR
IMS-5A-ER0.82UH+/-10% 1 ELEMENT, 0.82 uH, PHENOLIC-CORE, GENERAL PURPOSE INDUCTOR
IMS-5A-ER0.75UH+/-5% 1 ELEMENT, 0.75 uH, PHENOLIC-CORE, GENERAL PURPOSE INDUCTOR
IMS-5A-ER0.68UH+/-5% 1 ELEMENT, 0.68 uH, PHENOLIC-CORE, GENERAL PURPOSE INDUCTOR
相关代理商/技术参数
参数描述
M38853F2-HP 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M38853F3-HP 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M38853F4-HP 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M38853F5-HP 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M38853F6-HP 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER