- 您现在的位置：买卖IC网 > PDF目录80396 > M38C29MC-XXXHP 8-BIT, MROM, 4 MHz, MICROCONTROLLER, PQFP64 PDF资料下载
参数资料
| 型号： | M38C29MC-XXXHP |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 8-BIT, MROM, 4 MHz, MICROCONTROLLER, PQFP64 |
| 封装： | 10 X 10 MM, 0.50 MM PITCH, PLASTIC, LQFP-64 |
| 文件页数： | 17/91页 |
| 文件大小： | 1867K |
| 代理商： | M38C29MC-XXXHP |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页当前第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页
23
38C2 Group
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
MITSUBISHI MICROCOMPUTERS
PRELIMINAR
Y
Notice:
This
is not
a final
specification.
Some
parametric
limits
are
subject
to change.
TIMERS
8-Bit Timer
The 38C2 group has four built-in timers : Timer 1, Timer 2, Timer 3,
and Timer 4.
Each timer has the 8-bit timer latch. All timers are down-counters.
When the timer reaches “0016,” the contents of the timer latch is
reloaded into the timer with the next count pulse. In this mode, the
interrupt request bit corresponding to that timer is set to “1.”
The count can be stopped by setting the stop bit of each timer to “1.”
q Frequency Divider For Timer
Timer 1, timer 2, timer 3 and timer 4 have the frequency divider for
the count source. The count source of the frequency divider is switched
to XIN or XCIN by the CPU mode register. The frequency divider is
controlled by the 3-bit register. The division ratio can be selected
from as follows;
1/1, 1/2, 1/16, 1/32, 1/64, 1/128, 1/256, 1/1024 of f(XIN) or f(XCIN).
qTimer 1, Timer 2
The count sources of timer 1 and timer 2 can be selected by setting
the timer 12 mode register.
When f(XCIN) is selected as the count source, counting can be per-
formed regardless of XCIN oscillation. However, when XCIN is stopped,
the external pulse input from XCIN pin is counted. Also, by the timer
12 mode register, each time timer 2 underflows, the signal of which
polarity is inverted can be output from P36/T2OUT pin.
At reset, all bits of the timer 12 mode register are cleared to “0,” timer
1 is set to “FF16,” and timer 2 is set to “0116.”
When executing the STP instruction, previously set the wait time at
return.
q Timer 3, Timer 4
The count sources of timer 3 and timer 4 can be selected by setting
the timer 34 mode register. Also, by the timer 34 mode register, each
time timer 3 or timer 4 underflows, the signal of which polarity is
inverted can be output from P52/T3OUT pin or P53/T4OUT pin.
q Timer 3 PWM0 Mode, Timer 4 PWM1 Mode
A PWM rectangular waveform corresponding to the 10-bit accuracy
can be output from the P52/PWM0 pin and P53/PWM1 pin by set-
ting the timer 34 mode register and PWM01 register (refer to Figure
21).
The “n” is the value set in the timer 3 (address 002216) or the timer
4 (address 002316). The “ts” is one period of timer 3 or timer 4
count source.
One output pulse is the short interval. Four output pulses are the
long interval. “H” width of the short interval is obtained by n ts.
However, in the long interval, “H” width of output pulse is extended
for ts which is set by the PWM01 register (address 002416).
q Writing to Timer 2, Timer 3, Timer 4
When writing to the latch only, if the write timing to the reload latch
and the underflow timing are almost the same, the value is set into
the timer and the timer latch at the same time. In this time, counting
is stopped during writing to the reload latch.
相关PDF资料 |
PDF描述 |
|---|---|
| M32176F4TFP | 32-BIT, FLASH, 40 MHz, RISC MICROCONTROLLER, PQFP144 |
| M38039MC-XXXHP | 8-BIT, MROM, 8.4 MHz, MICROCONTROLLER, PQFP64 |
| M38044M4-XXXFP | 8-BIT, MROM, 8.4 MHz, MICROCONTROLLER, PQFP64 |
| M37221M8-XXXSP | 8-BIT, MROM, 8.1 MHz, MICROCONTROLLER, PDIP42 |
| M30625MGP-XXXGP | 16-BIT, MROM, 24 MHz, MICROCONTROLLER, PQFP128 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| M38C29RLFS | 功能描述:EMULATOR MCU FOR A-VERSION 38C2 RoHS:否 类别:编程器，开发系统 >> 内电路编程器、仿真器以及调试器 系列:- 产品变化通告:Development Systems Discontinuation 19/Jul/2010 标准包装:1 系列:* 类型:* 适用于相关产品:* 所含物品:* |
| M38C29T-64FPD | 功能描述:DEV 100-PIN RFS/MCU TO 64-PIN 0. RoHS:否 类别:编程器，开发系统 >> 配件 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program RoHS指令信息:IButton RoHS Compliance Plan 标准包装:1 系列:- 附件类型:USB 至 1-Wire? RJ11 适配器 适用于相关产品:1-Wire? 设备 产品目录页面:1429 (CN2011-ZH PDF) |
| M38C29T-64LCA | 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:Converter from 100-pin RFS Type Emulator MCU to 64-pin 0.8mm-pitch QFP (for 38C1, 38C2, 38K0 and 38K2 Group of 38000 Series) |
| M38C29T-ADF | 功能描述:DEV TEMPORARY TARGET BOARD FOR M RoHS:否 类别:编程器，开发系统 >> 配件 系列:- 标准包装:1 系列:- 附件类型:适配器板 适用于相关产品:RCB230，RCB231，RCB212 配用:26790D-ND - RCB BREAKOUT BOARD RS232 CABLE |
| M38C2XMX | 制造商:MITSUBISHI 制造商全称:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER |
发布紧急采购，3分钟左右您将得到回复。