- 您现在的位置：买卖IC网 > PDF目录80394 > M41T83ZM6F (STMICROELECTRONICS) 1 TIMER(S), REAL TIME CLOCK, PDSO8 PDF资料下载
参数资料
| 型号： | M41T83ZM6F |
| 厂商： | STMICROELECTRONICS |
| 元件分类： | 时钟/数据恢复及定时提取 |
| 英文描述： | 1 TIMER(S), REAL TIME CLOCK, PDSO8 |
| 封装： | 0.150 INCH, ROHS COMPLIANT, PLASTIC, SOP-8 |
| 文件页数： | 5/61页 |
| 文件大小： | 983K |
| 代理商： | M41T83ZM6F |
第1页第2页第3页第4页当前第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页
M41T82-M41T83
Operation
Doc ID 12578 Rev 12
2.1
2-wire bus characteristics
The bus is intended for communication between different ICs. It consists of two lines: a bi-
directional data signal (SDA) and a clock signal (SCL). Both the SDA and SCL lines must be
connected to a positive supply voltage via a pull-up resistor.
The following protocol has been defined:
●
Data transfer may be initiated only when the bus is not busy.
●
During data transfer, the data line must remain stable whenever the clock line is high.
●
Changes in the data line, while the clock line is high, will be interpreted as control
signals.
Accordingly, the following bus conditions have been defined:
2.1.1
Bus not busy
Both data and clock lines remain high.
2.1.2
Start data transfer
A change in the state of the data line, from high to low, while the clock is high, defines the
START condition.
2.1.3
Stop data transfer
A change in the state of the data line, from low to high, while the clock is high, defines the
STOP condition.
2.1.4
Data valid
The state of the data line represents valid data when after a start condition, the data line is
stable for the duration of the high period of the clock signal. The data on the line may be
changed during the low period of the clock signal. There is one clock pulse per bit of data.
Each data transfer is initiated with a start condition and terminated with a stop condition.
The number of data bytes transferred between the start and stop conditions is not limited.
The information is transmitted byte-wide and each receiver acknowledges with a ninth bit.
By definition a device that gives out a message is called “transmitter,” the receiving device
that gets the message is called “receiver.” The device that controls the message is called
“master.” The devices that are controlled by the master are called “slaves.”
相关PDF资料 |
PDF描述 |
|---|---|
| MPC740PRX400RE | 32-BIT, 400 MHz, RISC PROCESSOR, CBGA255 |
| MPC8555EVTALF | 32-BIT, 667 MHz, RISC PROCESSOR, PBGA783 |
| MB88152APNF-G-110-JN-ERE1 | 16.6 MHz, OTHER CLOCK GENERATOR, PDSO8 |
| MPC8547PXATGB | 32-BIT, 1200 MHz, MICROPROCESSOR, PBGA783 |
| MPC8547VTAQGB | 32-BIT, 1000 MHz, MICROPROCESSOR, PBGA783 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| M41T83ZMY6E | 功能描述:实时时钟 Serial I2C bus RTC RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube |
| M41T83ZMY6F | 功能描述:实时时钟 Serial I2C bus RTC RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube |
| M41T83ZQ6E | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:Serial RTC with battery switchover |
| M41T83ZQ6F | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:Serial RTC with battery switchover |
| M41T83ZQA6E | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:Serial I2C bus RTC with battery switchover |
发布紧急采购，3分钟左右您将得到回复。