参数资料
型号: M470L3224BTO
厂商: SAMSUNG SEMICONDUCTOR CO. LTD.
英文描述: 256MB DDR SDRAM MODULE
中文描述: 256MB的DDR内存模块
文件页数: 15/20页
文件大小: 264K
代理商: M470L3224BTO
DDR SDRAM
128MB, 256MB SODIMM Pb-Free
Revision 1.2 Oct. 2004
Component Notes
1. tHZ and tLZ transitions occur in the same access time windows as valid data transitions. these parameters are not referenced to a
specific voltage level but specify when the device output in no longer driving (HZ), or begins driving (LZ).
2. The maximum limit for this parameter is not a device limit. The device will operate with a greater value for this parameter, but sys
tem performance (bus turnaround) will degrade accordingly.
3. The specific requirement is that DQS be valid (HIGH, LOW, or at some point on a valid transition) on or before this CK edge. A
valid transition is defined as monotonic and meeting the input slew rate specifications of the device. when no writes were previ
ously in progress on the bus, DQS will be tran sitioning from High- Z to logic LOW. If a previous write was in progress, DQS could
be HIGH, LOW, or transitioning from HIGH to LOW at this time, depending on tDQSS.
4. A maximum of eight AUTO REFRESH commands can be posted to any given DDR SDRAM device.
5. For command/address input slew rate
1.0 V/ns
6. For command/address input slew rate
0.5 V/ns and
<
1.0 V/ns
7. For CK & CK slew rate
1.0 V/ns
8. These parameters guarantee device timing, but they are not necessarily tested on each device. They may be guaranteed by
device design or tester correlation.
9. Slew Rate is measured between VOH(ac) and VOL(ac).
10. Min (tCL, tCH) refers to the smaller of the actual clock low time and the actual clock high time as provided to the device (i.e. this
value can be greater than the minimum specification limits for tCL and tCH).....For example, tCL and tCH are = 50% of the
period, less the half period jitter (tJIT(HP)) of the clock source, and less the half period jitter due to crosstalk (tJIT(crosstalk)) into
the clock traces.
11. tQH = tHP - tQHS, where:
tHP = minimum half clock period for any given cycle and is defined by clock high or clock low (tCH, tCL). tQHS accounts for 1) The
pulse duration distortion of on-chip clock circuits; and 2) The worst case push-out of DQS on one tansition followed by the worst
case pull-in of DQ on the next transition, both of which are, separately, due to data pin skew and output pattern effects, and p-
channel to n-channel variation of the output drivers.
12. tDQSQ
Consists of data pin skew and output pattern effects, and p-channel to n-channel variation of the output drivers for any given
cycle.
13. tDAL = (tWR/tCK) + (tRP/tCK)
For each of the terms above, if not already an integer, round to the next highest integer. Example: For DDR266B at CL=2.5 and
tCK=7.5ns tDAL = (15 ns / 7.5 ns) + (20 ns/ 7.5ns) = (2) + (3)
tDAL = 5 clocks
相关PDF资料
PDF描述
M470L1624FU0-CA2 DDR SDRAM SODIMM
M470L3224FU0-CA2 Ring Core Bead Ferrite; Impedance:340ohm; Cable Diameter Max:0.203"; Width (Latch Included):1.23"; External Height:1.155"; External Width:1.125"; Length:1.25"
M485L1624FU0-CA2 Ring Core Bead Ferrite; Impedance:200ohm; Cable Diameter Max:0.35"; Latch Height:0.2"; Width (Latch Included):0.885"; External Height:0.79"; External Width:0.77"; Length:1.45"
M470L1624FU0-CB0 Split Core Ferrite Bead; Inner Diameter:0.45"; Package/Case:Split Ferrite Core; External Width:0.93"; Frequency:100MHz; Impedance:238ohm; Latch Height:0.38"; Mounting Type:Surface Mount; Width (Latch Included):1.035" RoHS Compliant: Yes
M470L3224FU0-CB0 DDR SDRAM SODIMM
相关代理商/技术参数
参数描述
M470L3224DT0 制造商:SAMSUNG 制造商全称:Samsung semiconductor 功能描述:256MB DDR SDRAM MODULE
M470L3224DT0-CA0 制造商:SAMSUNG 制造商全称:Samsung semiconductor 功能描述:256MB DDR SDRAM MODULE
M470L3224DT0-CA2 制造商:SAMSUNG 制造商全称:Samsung semiconductor 功能描述:256MB DDR SDRAM MODULE
M470L3224DT0-CB0 制造商:SAMSUNG 制造商全称:Samsung semiconductor 功能描述:256MB DDR SDRAM MODULE
M470L3224DT0-CB3 制造商:SAMSUNG 制造商全称:Samsung semiconductor 功能描述:256MB DDR SDRAM MODULE