- 您现在的位置：买卖IC网 > PDF目录45051 > M48T212Y-70MH1TR (STMICROELECTRONICS) 0 TIMER(S), REAL TIME CLOCK, PDSO44 PDF资料下载
参数资料
| 型号： | M48T212Y-70MH1TR |
| 厂商： | STMICROELECTRONICS |
| 元件分类： | 时钟/数据恢复及定时提取 |
| 英文描述： | 0 TIMER(S), REAL TIME CLOCK, PDSO44 |
| 封装： | 0.330 INCH, PLASTIC, SOH-44 |
| 文件页数： | 9/32页 |
| 文件大小： | 473K |
| 代理商： | M48T212Y-70MH1TR |
第1页第2页第3页第4页第5页第6页第7页第8页当前第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
17/32
M48T212Y, M48T212V
Figure 9. Back-up Mode Alarm Waveforms
Watchdog Timer
The watchdog timer can be used to detect an out-
of-control microprocessor. The user programs the
watchdog timer by setting the desired amount of
time-out into the Watchdog Register, address 7h.
Bits BMB4-BMB0 store a binary multiplier and the
two lower-order bits RB1-RB0 select the resolu-
tion, where 00=1/16 second, 01=1/4 second, 10=1
second, and 11=4 seconds. The amount of time-
out is then determined to be the multiplication of
the five-bit multiplier value with the resolution. (For
example: writing 00001110 in the Watchdog Reg-
ister = 3*1 or 3 seconds).
Note: Accuracy of timer is within ± the selected
resolution.
If the processor does not reset the timer within the
specified period, the M48T212Y/V sets the WDF
(Watchdog Flag) and generates a watchdog inter-
rupt or a microprocessor reset. WDF is reset by
reading the Flags Register (Address 0h).
The most significant bit of the Watchdog Register
is the Watchdog Steering Bit (WDS). When set to
a '0.' the watchdog will activate the IRQ/FT pin
when timed-out. When WDS is set to a '1,' the
watchdog will output a negative pulse on the RST
pin for 40 to 200 ms. The Watchdog register, AFE,
ABE, and FT Bits will reset to a '0' at the end of a
Watchdog time-out when the WDS Bit is set to a
'1.'
The watchdog timer can be reset by two methods:
1.
a transition (high-to-low or low-to-high) can be
applied to the Watchdog Input pin (WDI) or
2.
the microprocessor can perform a WRITE of
the Watchdog Register.
The time-out period then starts over. The WDI pin
should be tied to VSS if not used. The watchdog
will be reset on each transition (edge) seen by the
WDI pin. In the order to perform a software reset
of the watchdog timer, the original time-out period
can be written into the Watchdog Register, effec-
tively restarting the count-down cycle.
Should the watchdog timer time-out, and the WDS
Bit is programmed to output an interrupt, a value of
00h needs to be written to the Watchdog Register
in order to clear the IRQ/FT pin. This will also dis-
able the watchdog function until it is again pro-
grammed correctly. A READ of the Flags Register
will reset the Watchdog Flag (Bit D7; Register 0h).
The watchdog function is automatically disabled
upon power-down and the Watchdog Register is
cleared. If the watchdog function is set to output to
the IRQ/FT pin and the frequency test function is
activated, the watchdog or alarm function prevails
and the frequency test function is denied.
AI03622
VCC
IRQ/FT
HIGH-Z
VPFD (max)
VPFD (min)
AFE Bit/ABE Bit
AF Bit in Flags Register
HIGH-Z
tREC
相关PDF资料 |
PDF描述 |
|---|---|
| M48T212Y-70MH1F | REAL TIME CLOCK, PDSO44 |
| M48T212Y-70MH1 | 0 TIMER(S), REAL TIME CLOCK, PDSO44 |
| M48T212V-85MH6E | REAL TIME CLOCK, PDSO44 |
| M48T212V-85MH6F | REAL TIME CLOCK, PDSO44 |
| M48T212Y-70MH6 | 0 TIMER(S), REAL TIME CLOCK, PDSO44 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| M48T212Y-70MH6 | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:5V/3.3V TIMEKEEPER[ CONTROLLER |
| M48T212Y-70MH6E | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:5V/3.3V TIMEKEEPER CONTROLLER Supervisor |
| M48T212Y-70MH6F | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:5V/3.3V TIMEKEEPER CONTROLLER Supervisor |
| M48T212Y-70MH6TR | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:5V/3.3V TIMEKEEPER[ CONTROLLER |
| M48T212Y-85MH1 | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:5V/3.3V TIMEKEEPER[ CONTROLLER |
发布紧急采购，3分钟左右您将得到回复。