- 您现在的位置：买卖IC网 > PDF目录80586 > M48T37V-10MH1TR (STMICROELECTRONICS) 0 TIMER(S), REAL TIME CLOCK, PDSO44 PDF资料下载
参数资料
| 型号： | M48T37V-10MH1TR |
| 厂商： | STMICROELECTRONICS |
| 元件分类： | 时钟/数据恢复及定时提取 |
| 英文描述： | 0 TIMER(S), REAL TIME CLOCK, PDSO44 |
| 封装： | 0.330 INCH, ROHS COMPLIANT, PLASTIC, SOH-44 |
| 文件页数： | 9/30页 |
| 文件大小： | 515K |
| 代理商： | M48T37V-10MH1TR |
第1页第2页第3页第4页第5页第6页第7页第8页当前第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页
M48T37Y, M48T37V
Clock operations
Doc ID 7019 Rev 9
The watchdog timer is disabled by writing a value of 00000000 to the eight bits in the
watchdog register. Should the watchdog timer time out, a value of 00h needs to be written to
the watchdog register in order to clear the IRQ/FT pin.
The watchdog function is automatically disabled upon power-down and the watchdog
register is cleared. If the watchdog function is set to output to the IRQ/FT pin and the
frequency test function is activated, the watchdog or alarm function prevails and the
frequency test function is denied. The WDI pin should be connected to VSS if not used.
3.7
Power-on reset
The M48T37Y/V continuously monitors VCC. When VCC falls to the power fail detect trip
point, the RST pulls low (open drain) and remains low on power-up for tREC after VCC
passes VPFD. RST is valid for all VCC conditions. The RST pin is an open drain output and
page 22).
3.8
Programmable interrupts
The M48T37Y/V provides two programmable interrupts: an alarm and a watchdog. When an
interrupt condition occurs, the M48T37Y/V sets the appropriate flag bit in the flag register
7FF0h. The interrupt enable bits (AFE and ABE) in 7FF6h and the watchdog steering
(WDS) bit in 7FF7h allow the interrupt to activate the IRQ/FT pin.
The alarm flag and the IRQ/FT output are cleared by a READ to the flags register. An
interrupt condition reset will not occur unless the addresses are stable at the flag location for
at least 15 ns while the device is in the READ mode as shown in Figure 7 on page 14.
The IRQ/FT pin is an open drain output and requires a pull-up resistor (10 k
Ω
recommended) to VCC. The pin remains in the high impedance state unless an interrupt
occurs or the frequency test mode is enabled.
相关PDF资料 |
PDF描述 |
|---|---|
| MC68HC711KA2VFS2 | 8-BIT, UVPROM, 4 MHz, MICROCONTROLLER, CQFP64 |
| MC68HC711KA2VFS3 | 8-BIT, UVPROM, 3 MHz, MICROCONTROLLER, CQFP64 |
| M37700SAFP | 16-BIT, 16 MHz, MICROCONTROLLER, PQFP80 |
| MPC603FIM233C | 32-BIT, 233 MHz, RISC PROCESSOR, CPGA288 |
| MPC603VIP266C | 32-BIT, 266 MHz, RISC PROCESSOR, CPGA288 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| M48T37V-10MH6 | 功能描述:实时时钟 256K (32Kx8) 100ns RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube |
| M48T37V-10MH6E | 功能描述:实时时钟 256K (32Kx8) 100ns RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube |
| M48T37V-10MH6F | 功能描述:实时时钟 256K (32Kx8) 100ns RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube |
| M48T37V-10MH6TR | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:3.3V-5V 256 Kbit 32Kb x8 TIMEKEEPER SRAM |
| M48T37V-70MH1 | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:3.3V-5V 256 Kbit 32Kb x8 TIMEKEEPER SRAM |
发布紧急采购，3分钟左右您将得到回复。