- 您现在的位置：买卖IC网 > PDF目录380325 > MAS9090BJ (MICRONAS SEMICONDUCTOR HOLDING AG) LOW VOLTAGE 14-BIT LINEAR CODEC PDF资料下载
参数资料
| 型号： | MAS9090BJ |
| 厂商： | MICRONAS SEMICONDUCTOR HOLDING AG |
| 元件分类： | 编解码器 |
| 英文描述： | LOW VOLTAGE 14-BIT LINEAR CODEC |
| 中文描述： | LINEAR CODEC, PQFP44 |
| 封装： | TQFP-44 |
| 文件页数： | 17/30页 |
| 文件大小： | 459K |
| 代理商： | MAS9090BJ |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页当前第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页
DA9090B.001
January 14, 1998
17
FUNCTIONAL DESCRIPTION
N
TX Audio Path
Analog front end provides three identical differential
inputs
(MIC1,
MIC2,
connection of microphones or auxiliary audio
circuits. Desired input signal is selected with bits VS
and TE (6 and 7) of register CR4 and forwarded to a
low noise preamplifier.
Preamplifier has 15.7 dB gain and its output is fed
to the programmable gain amplifier which provides
an additional gain from 0 to 22.5 dB in 1.5 dB steps.
Gain is controlled with bits 4-7 of register CR5.
MIC3)
for
capacitive
An active RC anti alias filter is used to prevent
signal folding during the sampling. Accurate analog
to digital conversion is done by using a sigma-delta
modulator followed by a decimation filter.
Digital multiplexer (bit DE (0) in CR 7) is used to
select the input of a digital bandpass filter (300-
3400 Hz). The input can be taken from the output of
the decimator or from an internal ring/tone
generator. The bandpass filter output contains hard
clipping saturation logic for signals exceeding
overload level (+3.14 dB). Highpass part of the
bandpass filter can be bypassed with bit HPT of
register CR10.
Output data can be compressed by using CCITT A-
law or
μ
255-law coding. The compression code is
selected with bits CM (5), MA (4) and IA (3) of
register CR0.
N
RX Audio Path
Received signal is transferred into RX register in 8
bit encoded format or in 16 bit linear format. The
data is expanded by using A-law or
μ
-law signal
encoding according to CCITT A and
μ
255 laws. The
expansion code is selected with bits CM (5), MA (4)
and IA (3) of register CR0. Signal is then passed
through a bandpass filter (bandpass 300-3400 Hz).
The high pass section of the filter can be bypassed
with bit HPR of register CR4.
The input signal of RX gain3 is controlled with bits
SI (5), RTE (2) and SE (0) of register CR4. Bit SI
activates the transmit side tone signal, bit RTE
activates the ring/tone generator and bit SE
activates the received signal to be summed to the
gain input. RX gain3 can be programmed with bits
4-7 of register CR6 from 0 dB to -30 dB with -2dB
steps. It contains also hard-clipping saturation logic.
After gain adjustment the signal is fed to a digital
sigma-delta modulator followed by a switched
capacitor (SC) reconstruction filter and a continuous
time smoothing filter. Filtered analog signal can be
directed to a speaker amplifier (SP1) or to an extra
analog output amplifier (SP2) with bits OE1 (4) and
OE2 (3) of register CR4. Gains can be set with
register CR6 in the range of 0 to -30 dB in -2 dB
steps.
Differential analog outputs (SP1, SP2) are capable
of directly driving output load of 30
with power
level up to 66mW. Also ceramic receivers up to
50nF can be used. Power up transient noise
suppression is used in both outputs.
N
Ring and tone generator
Ring/tone generator is able to generate one or two
sinewave or squarewave frequencies (including
DTMF tones) to the transmit (TX) receive (RX) or
buzzer paths. Generated frequencies can be
programmed with registers CR8 and CR9. One of
the three frequency ranges can be selected with bits
DFT and HFT of register CR10. Output signal level
of the tone generator can be selected from 0 to -27
dB with -3dB steps with bits 4-7 of register CR7.
Single ended BZ output is used to drive a buzzer by
using an external bipolar transistor with pulse width
modulated (PWM) squarewave signal f1 (CR8).
This PWM signal can also be amplitude modulated
with signal f2 (CR9). Maximum load for BZ is 5 k
and 50pF. Implementation of tone generator is fully
digital. Therefore no amplitude or frequency
response
variations
(at
temperature, power supply or from unit to unit exist.
TX
output)
over
相关PDF资料 |
PDF描述 |
|---|---|
| MAS9090BJ-T | LOW VOLTAGE 14-BIT LINEAR CODEC |
| MAS9090BS | LOW VOLTAGE 14-BIT LINEAR CODEC |
| MAS9128A | LDO Voltage Regulator IC |
| MAS9128AS | LDO Voltage Regulator IC |
| MAS9128AS-T | LDO Voltage Regulator IC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAS9090BJ-T | 制造商:MICRONAS 制造商全称:MICRONAS 功能描述:LOW VOLTAGE 14-BIT LINEAR CODEC |
| MAS9090BS | 制造商:MICRONAS 制造商全称:MICRONAS 功能描述:LOW VOLTAGE 14-BIT LINEAR CODEC |
| MAS9090BS-T | 制造商:MICRONAS 制造商全称:MICRONAS 功能描述:LOW VOLTAGE 14-BIT LINEAR CODEC |
| MAS9116 | 制造商:MAS 制造商全称:MAS 功能描述:Stereo Digital Volume Control |
| MAS9116AAHV06 | 制造商:MAS 制造商全称:MAS 功能描述:Stereo Digital Volume Control |
发布紧急采购，3分钟左右您将得到回复。