- 您现在的位置：买卖IC网 > PDF目录2007 > MAX038CWP+ (Maxim Integrated Products)IC GEN WAVEFORM HI-FREQ 20-SOIC PDF资料下载
参数资料
| 型号： | MAX038CWP+ |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 8/17页 |
| 文件大小： | 0K |
| 描述： | IC GEN WAVEFORM HI-FREQ 20-SOIC |
| 标准包装： | 36 |
| 频率： | 0.1Hz ~ 20MHz |
| 电源电压： | 4.75 V ~ 5.25 V |
| 电流 - 电源： | 45mA |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 20-SOIC（0.295"，7.50mm 宽） |
| 包装： | 管件 |
| 供应商设备封装： | 20-SOIC W |
| 安装类型： | 表面贴装 |
High-Frequency Waveform Generator
Layout Considerations
Realizing the full performance of the MAX038 requires
careful attention to power-supply bypassing and board
layout. Use a low-impedance ground plane, and con-
nect all five GND pins directly to it. Bypass V+ and V-
directly to the ground plane with 1F ceramic capaci-
tors or 1F tantalum capacitors in parallel with 1nF
ceramics. Keep capacitor leads short (especially with
the 1nF ceramics) to minimize series inductance.
If SYNC is used, DV+ must be connected to V+, DGND
must be connected to the ground plane, and a second
1nF ceramic should be connected as close as possible
between DV+ and DGND (pins 16 and 15). It is not
necessary to use a separate supply or run separate
traces to DV+. If SYNC is disabled, leave DV+ open.
Do not open DGND.
Minimize the trace area around COSC (and the ground
plane area under COSC) to reduce parasitic capaci-
tance, and surround this trace with ground to prevent
coupling with other signals. Take similar precautions
with DADJ, FADJ, and IIN. Place CF so its connection
to the ground plane is close to pin 6 (GND).
Applications Information
Frequency Synthesizer
Figure 6 shows a frequency synthesizer that produces
accurate and stable sine, square, or triangle waves with
a frequency range of 8kHz to 16.383MHz in 1kHz incre-
ments. A Motorola MC145151 provides the crystal-con-
trolled oscillator, the ÷N circuit, and a high-speed phase
detector. The manual switches set the output frequency;
opening any switch increases the output frequency.
Each switch controls both the ÷N output and an
MX7541 12-bit DAC, whose output is converted to a cur-
rent by using both halves of the MAX412 op amp. This
current goes to the MAX038 IIN pin, setting its coarse
frequency over a very wide range.
Fine frequency control (and phase lock) is achieved
from the MC145151 phase detector through the differ-
ential amplifier and lowpass filter, U5. The phase detec-
tor compares the ÷N output with the MAX038 SYNC
output and sends differential phase information to U5.
U5’s single-ended output is summed with an offset into
the FADJ input. (Using the DAC and the IIN pin for
coarse frequency control allows the FADJ pin to have
very fine control with reasonably fast response to
switch changes.)
A 50MHz, 50
Ω lowpass filter in the output allows pas-
sage of 16MHz square waves and triangle waves with
reasonable fidelity, while stopping high-frequency
noise generated by the ÷N circuit.
Package Information
For the latest package outline information, go to
www.maxim-ic.com/packages.
Revision History
Pages changed at Rev 7: 13, 16
Chip Topography
TRANSISTOR COUNT: 855
SUBSTRATE CONNECTED TO GND
V+
PDI
SYNC
AO
DADJ
PDO
FADJ
0.118"
(2.997mm)
0.106"
(2.692mm)
A1
COSC
GND
IIN
GND
DGND
DV+
GND
REF
V-
OUT
MAX038
16
Maxim Integrated
相关PDF资料 |
PDF描述 |
|---|---|
| MAX1002CAX+T | IC ADC 6BIT 60MSPS DUAL 36-SSOP |
| MAX1003CAX | IC ADC DUAL 6-BIT 90MSPS 36-SSOP |
| MAX1011CEG+ | IC ADC 6BIT 90MSPS 24-QSOP |
| MAX105ECS+T | IC ADC 6BIT 800MSPS DL 80TQFP |
| MAX1063AEEG+ | IC ADC 10BIT 250KSPS 24-QSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX038CWP+ | 功能描述:时钟发生器及支持产品 RoHS:否 制造商:Silicon Labs 类型:Clock Generators 最大输入频率:14.318 MHz 最大输出频率:166 MHz 输出端数量:16 占空比 - 最大:55 % 工作电源电压:3.3 V 工作电源电流:1 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:QFN-56 |
| MAX038CWP+T | 功能描述:时钟发生器及支持产品 RoHS:否 制造商:Silicon Labs 类型:Clock Generators 最大输入频率:14.318 MHz 最大输出频率:166 MHz 输出端数量:16 占空比 - 最大:55 % 工作电源电压:3.3 V 工作电源电流:1 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:QFN-56 |
| MAX038CWP-T | 功能描述:时钟发生器及支持产品 RoHS:否 制造商:Silicon Labs 类型:Clock Generators 最大输入频率:14.318 MHz 最大输出频率:166 MHz 输出端数量:16 占空比 - 最大:55 % 工作电源电压:3.3 V 工作电源电流:1 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:QFN-56 |
| MAX038EPP | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:High-Frequency Waveform Generator |
| MAX038EVKIT | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Evaluation Kit for the MAX038 |
发布紧急采购，3分钟左右您将得到回复。