- 您现在的位置：买卖IC网 > PDF目录17006 > MAX110EVC32-DIP (Maxim Integrated Products)EVAL KIT FOR MAX110 PDF资料下载
参数资料
| 型号： | MAX110EVC32-DIP |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 24/24页 |
| 文件大小： | 0K |
| 描述： | EVAL KIT FOR MAX110 |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 1 |
| ADC 的数量： | 1 |
| 位数： | 14 |
| 采样率（每秒）： | 50 |
| 数据接口： | 串行 |
| 输入范围： | ±VREF |
| 在以下条件下的电源（标准）： | 4.35mW @ 50SPS |
| 工作温度： | 0°C ~ 70°C |
| 已用 IC / 零件： | MAX110，MAX111 |
| 已供物品： | 2 板，CD |
MAX110/MAX111
Low-Cost, 2-Channel, ±14-Bit Serial ADCs
_______________________________________________________________________________________
9
_______________Detailed Description
The MAX110/MAX111 ADC converts low-frequency
analog signals to a 16-bit serial digital output (14 data
bits, a sign bit, and an overrange bit) using a first-order
sigma-delta loop (Figure 1). The differential input volt-
age is internally connected to a precision voltage-to-
current converter. The resulting current is integrated
and applied to a comparator. The comparator output
then drives an up/down counter and a 1-bit DAC. When
the DAC output is fed back to the integrator input, the
sigma-delta loop is completed.
During a conversion, the comparator output is a VREF-
to VREF+ square wave; its duty cycle is proportional to
the magnitude of the differential input voltage applied
to the ADC. The up/down counter clocks data in from
the comparator at the oversampling clock rate and
averages the pulse-width-modulated (PWM) square
wave to produce the conversion result. A 16-bit static
shift register stores the result at the end of the conver-
sion. Figure 2 shows the ADC waveforms for a differen-
tial analog input equal to 1/2 (VREF+ - VREF-). The
resulting comparator and 1-bit DAC outputs are high
for seven cycles and low for three cycles of the over-
sampling clock.
Since the analog input signal is integrated over many
clock cycles, much of the signal and quantization noise
is attenuated. The more clock cycles allowed during
each conversion, the greater the noise attenuation (see
Programming Conversion Time).
______________________________________________________________Pin Description
Clock Input / RC Oscillator Output. TTL/CMOS-compatible oversampling clock input
when RCSEL = GND. Connects to the internal RC oscillator when RCSEL = VDD. XCLK
must be connected to VDD or GND through a resistor (1M or less) when RC OSC
mode is selected.
XCLK
8
Serial Clock Input. TTL/CMOS-compatible clock input for serial-interface data I/O.
SCLK
9
Busy Output. Goes low at conversion start, and returns high at end of conversion.
BUSY
10
Positive Power-Supply Input—connect to +5V
VDD
6
RC Select Input. Connect to GND to select external clock mode. Connect to VDD to
select RC OSC mode. XCLK must be connected to VDD or GND through a resistor
(1M
or less) when RC OSC mode is selected.
RCSEL
7
Positive Reference Input
REF+
3
Negative Reference Input
REF-
2
Channel 1 Positive Analog Input
IN1+
1
FUNCTION
NAME
SSOP
6
7
8
4
5
3
2
PIN
1
DIP/SO
Chip-Select Input. Pull this input low to perform a control-word-write/data-read opera-
tion. A conversion begins when CS returns high, provided NO-OP is a 1. See the sec-
tion
Using the MAX110/MAX111 with SPI, QSPI, and MICROWIRE Serial Interfaces.
CS
11
9
Serial Data Output. High-impedance when CS is high.
DOUT
12
10
Serial Data Input. See
Control Register section.
DIN
13
11
Digital Ground
GND
16
12
MAX110 Negative Power-Supply Input—connect to -5V
VSS
Channel 2 Negative Analog Input
IN2-
18
14
Channel 2 Positive Analog Input
IN2+
19
15
Channel 1 Negative Analog Input
IN1-
20
16
No Connect—there is no internal connection to this pin
N.C.
4, 5, 14, 15
—
MAX111 Analog Ground
AGND
17
13
相关PDF资料 |
PDF描述 |
|---|---|
| 380LX153M016J022 | CAP ALUM 15000UF 16V 20% SNAP |
| SRR0603-221KL | INDUCTOR PWR 220UH 10% SHLD SMD |
| LGU2G221MELZ | CAP ALUM 220UF 400V 20% SNAP |
| MAX11040KEVKIT# | KIT EVAL FOR MAX11040 W/FMC CONN |
| 380LX221M200J202 | CAP ALUM 220UF 200V 20% SNAP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX110EVKIT | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Evaluation Kit for the MAX110/MAX111 |
| MAX110EVKIT-DIP | 功能描述:数据转换 IC 开发工具 MAC110/1 Eval Kit RoHS:否 制造商:Texas Instruments 产品:Demonstration Kits 类型:ADC 工具用于评估:ADS130E08 接口类型:SPI 工作电源电压:- 6 V to + 6 V |
| MAX110EWE | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Analog-to-Digital Converter， 15-Bit |
| MAX110-MAX111 | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Low-Cost, 2-Channel, 【14-Bit Serial ADCs |
| MAX110MJE | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Analog-to-Digital Converter， 15-Bit |
发布紧急采购，3分钟左右您将得到回复。