- 您现在的位置：买卖IC网 > PDF目录10440 > MAX13331GEE/V+ (Maxim Integrated Products)IC AMP STEREO HEADPHONE 16-QSOP PDF资料下载
参数资料
| 型号： | MAX13331GEE/V+ |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 15/15页 |
| 文件大小： | 0K |
| 描述： | IC AMP STEREO HEADPHONE 16-QSOP |
| 其它有关文件： | Automotive Product Guide |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 100 |
| 系列： | DirectDrive® |
| 类型： | AB 类 |
| 输出类型： | 耳机，2-通道（立体声） |
| 在某负载时最大输出功率 x 通道数量： | 135mW x 2 @ 32 欧姆 |
| 电源电压： | 4 V ~ 5.5 V |
| 特点： | 消除爆音，短路保护，关机 |
| 安装类型： | 表面贴装 |
| 供应商设备封装： | 16-QSOP |
| 封装/外壳： | 16-SSOP（0.154"，3.90mm 宽） |
| 包装： | 管件 |
MAX13330/MAX13331
Automotive DirectDrive Headphone Amplifiers
with Output Protection and Diagnostics
_______________________________________________________________________________________
9
Low-Frequency Response
In addition to the cost and size disadvantages of the DC-
blocking capacitors required by conventional head-
phone amplifiers, these capacitors limit the amplifier’s
low-frequency response and can distort the audio signal:
1) The impedance of the headphone load and the DC-
blocking capacitor form a highpass filter with the -3dB
point set by:
where RL is the impedance of the headphone and
COUT is the value of the DC-blocking capacitor. The
highpass filter is required by conventional single-
ended, single power-supply headphone amplifiers to
block the midrail DC-bias component of the audio sig-
nal from the headphones. The drawback to the filter is
that it can attenuate low-frequency signals. Larger val-
ues of COUT reduce this effect but result in physically
larger, more expensive capacitors. Figure 2 shows the
relationship between the size of COUT and the resulting
low-frequency attenuation. Note that the -3dB point for
a 16
Ω headphone with a 100F blocking capacitor is
100Hz, well within the normal audio band, resulting in
low-frequency attenuation of the reproduced signal.
2) The voltage coefficient of the DC-blocking capacitor
contributes distortion to the reproduced audio signal as
the capacitance value varies and the function of the
voltage across the capacitor changes. The reactance
of the capacitor dominates at frequencies below the
-3dB point and the voltage coefficient appears as fre-
quency-dependent distortion. Figure 3 shows the
THD+N introduced by two different capacitor dielectric
types. Note that below 100Hz, THD+N increases rapid-
ly. The combination of low-frequency attenuation and
frequency-dependent distortion compromises audio
reproduction in portable audio equipment that empha-
sizes low-frequency effects such as in multimedia lap-
tops, MP3, CD, and DVD players. By eliminating the
DC-blocking capacitors through DirectDrive technolo-
gy, these capacitor-related deficiencies are eliminated.
Charge Pump
The MAX13330/MAX13331 feature a low-noise charge
pump. The 2.2MHz (typ) switching frequency is well
beyond the audio range. It does not interfere with the
audio signals and avoids AM band interference. The
switch drivers feature a controlled switching speed that
minimizes noise generated by turn-on and turn-off tran-
sients. By limiting the switching speed of the charge
pump, the di/dt noise caused by the parasitic bond
wire and trace inductance is minimized. Although not
typically required, additional high-frequency noise
attenuation can be achieved by increasing the value of
C2 (see the
Typical Application Circuits).
f
RC
Hz
dB
LOUT
=
××
()
3
1
2
π
0
-30
10
100
1k
10k
100k
LOW-FREQUENCY ROLLOFF
(RL = 16
Ω)
-24
-27
-12
-15
-18
-21
-6
-9
-3
FREQUENCY (Hz)
ATTENUATION
(dB)
DirectDrive
330
μF
220
μF
100
μF
33
μF
Figure 2. Low-Frequency Attenuation for Common DC-Blocking
Capacitor Values
ADDITIONAL THD+N DUE
TO DC-BLOCKING CAPACITORS
FREQUENCY (Hz)
THD+N
(%)
10k
1k
100
0.001
0.01
0.1
1
10
0.0001
10
100k
TANTALUM
ALUM/ELEC
Figure 3. Distortion Contributed by DC-Blocking Capacitors
相关PDF资料 |
PDF描述 |
|---|---|
| MS3102C28-16P | CONN RCPT 20POS BOX MNT W/PINS |
| MS27497E10F13P | CONN RCPT 13POS WALL MNT W/PINS |
| MS3100E18-9S | CONN RCPT 7POS WALL MNT W/SCKT |
| MAX13330GEE/V+ | IC AMP STEREO HEADPHONE 16-QSOP |
| VE-JND-MY-B1 | CONVERTER MOD DC/DC 85V 50W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX13335EEVKIT# | 功能描述:放大器 IC 开发工具 MAX13335E Eval Kit RoHS:否 制造商:International Rectifier 产品:Demonstration Boards 类型:Power Amplifiers 工具用于评估:IR4302 工作电源电压:13 V to 23 V |
| MAX13335EEVKIT+ | 功能描述:放大器 IC 开发工具 MAX13335E Eval Kit RoHS:否 制造商:International Rectifier 产品:Demonstration Boards 类型:Power Amplifiers 工具用于评估:IR4302 工作电源电压:13 V to 23 V |
| MAX13335EGEE/V+ | 功能描述:音频放大器 Differential Audio Input Amplifier RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel |
| MAX13335EGEE/V+T | 功能描述:音频放大器 Differential Audio Input Amplifier RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel |
| MAX13336EGEE/V+ | 功能描述:音频放大器 Differential Audio Input Amplifier RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。