参数资料
型号: MAX1409CAP+
厂商: Maxim Integrated Products
文件页数: 46/48页
文件大小: 0K
描述: IC DAS 16BIT LP 20-SSOP
产品培训模块: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
标准包装: 66
类型: 数据采集系统(DAS)
分辨率(位): 16 b
采样率(每秒): 60
数据接口: 串行
电压电源: 模拟和数字
电源电压: 2.7 V ~ 3.6 V
工作温度: 0°C ~ 70°C
安装类型: 表面贴装
封装/外壳: 20-SSOP(0.209",5.30mm 宽)
供应商设备封装: 20-SSOP
包装: 管件
MAX1407/MAX1408/MAX1409/MAX1414
Low-Power, 16-Bit Multichannel DAS with
Internal Reference,10-Bit DACs, and RTC
_______________________________________________________________________________________
7
Note 1: Single conversion.
Note 2: DNL and INL are measured between code 010hex and 3FFhex.
Note 3: Offset error is referenced to code 010hex.
Note 4: Output swing is a function of external gain-setting feedback resistors and REF voltage.
Note 5: Measured with no load on FOUT, DOUT, and the DAC amplifiers. SCLK is idle, and all digital inputs are at DGND or DVDD.
Note 6: SHDN stays high if the PLL is on.
Note 7: Actual worst-case performance is ±2.5LSB. Guaranteed limit of ±3.5LSB is due to production test limitation.
Note 8: Guaranteed by design. Not production tested.
TIMING CHARACTERISTICS (continued)
(MAX1407/MAX1408/MAX1409/MAX1414: AVDD = DVDD = 2.7V to 3.6V, TA = TMIN to TMAX, unless otherwise noted.)
PARAMETER
SYMBOL
CONDITIONS
MIN
TYP
MAX
UNITS
TYPICAL TIMING PARAMETERS
OUT1/OUT2 Turn-Off Time
Input impedance > 1M
(MAX1407/MAX1409/MAX1414 only)
100
s
Sleep Voltage Monitor Timeout
Period
tDSLP
The delay for the sleep voltage monitor
output, RESET, to go high after AVDD rises
above the reset threshold (+1.8V when bit
VM = 1 and +2.7V, when bit VM = 0); this is
largely driven by the startup of the 32kHz
oscillator
1.54
s
WU1 or WU2 Pulse Width
tWU
Minimum pulse width required to detect a
wake-up event
1s
Shutdown Deassert Delay
tDPU
The delay for SHDN to go high after a valid
wake-up event
1s
FOUT Turn-On Time
tDFON
The turn-on time for the high-frequency
clock; it is gated by an AND function with
three signals—the RESET signal, the internal
low voltage VDD monitor signal, and the
assertion of the PLL; the time delay is timed
from when the low-voltage monitor trips or
the RESET going high, whichever happens
later; FOUT always starts in the low state
31.25
ms
INT Delay
tDFI
The delay for INT to go low after the FOUT
clock output has been enabled; INT is used
as an interrupt signal to inform the P the
high-frequency clock has started
7.82
ms
FOUT Disable Delay
tDFOF
The delay after a shutdown command has
asserted and before FOUT is disabled; this
gives the microcontroller time to clean up
and go into Sleep mode properly
1.95
ms
SHDN Assertion Delay
tDPD
The delay after a shutdown command has
asserted and before SHDN is pulled low
(turning off the DC-DC converter) (Note 6)
2.93
ms
相关PDF资料
PDF描述
V110A28M300BL2 CONVERTER MOD DC/DC 28V 300W
NBXDBA014LN1TAG IC CLK XO 62.5/125MHZ 6CLCC
MS27508E16B6PA CONN RCPT 6POS BOX MNT W/PINS
MS27484T20F41S CONN PLUG 41POS STRAIGHT W/SCKT
V110A28M300BL CONVERTER MOD DC/DC 28V 300W
相关代理商/技术参数
参数描述
MAX1409CAP+ 功能描述:ADC / DAC多通道 16-Bit 60sps 1.35V Precision ADC RoHS:否 制造商:Texas Instruments 转换速率: 分辨率:8 bit 接口类型:SPI 电压参考: 电源电压-最大:3.6 V 电源电压-最小:2 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-40
MAX1409CAP+T 功能描述:ADC / DAC多通道 16-Bit 60sps 1.35V Precision ADC RoHS:否 制造商:Texas Instruments 转换速率: 分辨率:8 bit 接口类型:SPI 电压参考: 电源电压-最大:3.6 V 电源电压-最小:2 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-40
MAX1409CAP-T 功能描述:ADC / DAC多通道 RoHS:否 制造商:Texas Instruments 转换速率: 分辨率:8 bit 接口类型:SPI 电压参考: 电源电压-最大:3.6 V 电源电压-最小:2 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-40
MAX1409EAP 制造商:Maxim Integrated Products 功能描述:LOW-POWER, 16-BIT MULTICHANNEL DAS WITH INTER - Bulk
MAX140C/D 功能描述:模数转换器 - ADC RoHS:否 制造商:Texas Instruments 通道数量:2 结构:Sigma-Delta 转换速率:125 SPs to 8 KSPs 分辨率:24 bit 输入类型:Differential 信噪比:107 dB 接口类型:SPI 工作电源电压:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-32