- 您现在的位置：买卖IC网 > PDF目录296460 > MAX16005DUE+ (MAXIM INTEGRATED PRODUCTS INC) 6-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO16 PDF资料下载
参数资料
| 型号： | MAX16005DUE+ |
| 厂商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分类： | 电源管理 |
| 英文描述： | 6-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO16 |
| 封装： | 5 X 4.40 MM, ROHS COMPLIANT, TSSOP-16 |
| 文件页数： | 26/26页 |
| 文件大小： | 280K |
| 代理商： | MAX16005DUE+ |
MAX16000–MAX16007
Low-Voltage, Quad-/Hex-/Octal-Voltage
P Supervisors
_______________________________________________________________________________________
9
PIN
MAX16003
MAX16004
MAX16005
TSSOP
MAX16005
TQFN
NAME
FUNCTION
16
20
2
16
TOL
Threshold Tolerance Input. Connect TOL to GND to select 5% threshold tolerance.
Connect TOL to VCC to select 10% threshold tolerance.
—
4
6
4
WDI
Watchdog Timer Input.
MAX16004: If WDI remains low or high for longer than the watchdog timeout period,
RESET is asserted and the timer is cleared. The timer also clears whenever a reset is
asserted or a rising or falling edge on WDI is detected. The watchdog timer enters a
startup period that allows 54s for the first transition to occur before a reset. Leave WDI
unconnected to disable the watchdog timer.
MAX16005: If WDI remains low or high for longer than the watchdog timeout period,
WDO is asserted. The timer clears whenever a rising or falling edge on WDI is detected.
Leave WDI unconnected to disable the watchdog timer. The MAX16005 does not have a
startup period.
MAX16004/MAX16005: The WDI open-state detector uses a small 100nA current.
Therefore, do not connect WDI to anything that will source or sink more than 50nA. Note
that the leakage current specification for most three-state drivers exceeds 50nA.
—10
11
9
MR
Active-Low Manual Reset Input. Pull MR low to assert RESET low. RESET remains low for
the reset timeout period after MR is deasserted. MR is pulled up to VCC through a 20k
resistor.
—
11
12
10
SRT
Set Reset Timeout Input. Connect a capacitor from SRT to GND to set the reset timeout
period. The reset timeout period can be calculated as follows:
Reset Timeout (s) = 2.06 x 106 (
) x CSRT (F). For the internal timeout period of 140ms
(min), connect SRT to VCC.
—16
14
12
RESET
Active-Low Reset Output. RESET asserts low when any of the monitored voltages falls
below its respective threshold or MR is asserted. RESET remains asserted for the reset
timeout period after all monitored voltages exceed their respective thresholds and MR is
deasserted. This open-drain output has a 30A internal pullup.
—
9
7
REF
Reference Output. The reference output voltage of 1.23V can source up to 40A.
—
10
8
WDO
Active-Low Watchdog Output. WDO asserts and stays low whenever any of the IN_ inputs
fall below their respective thresholds. WDO deasserts without a timeout delay when all
the IN_ inputs rise above their thresholds. When all the IN_ inputs rise above their
thresholds, WDO asserts low whenever the watchdog timer times out. WDO deasserts
after a valid WDI transition or if MR is pulled low. The watchdog timer begins counting
after the reset timeout period once MR goes high. Pull MARGIN low to deassert WDO.
——
—
EP
Exposed Pad. EP is internally connected to GND. Connect EP to the ground plane to
provide a low thermal resistance path from the IC junction to the PCB. Do not use as the
electrical connection to GND.
Pin Description (MAX16003/MAX16004/MAX16005) (continued)
相关PDF资料 |
PDF描述 |
|---|---|
| MAX16072RS30D3+ | POWER SUPPLY SUPPORT CKT, PBGA4 |
| MAX17004AETJ+ | 3.3 A DUAL SWITCHING CONTROLLER, 575 kHz SWITCHING FREQ-MAX, QCC32 |
| MAX177ENG | CMOS 10-Bit A/D Converter with Track-and-Hold |
| MAX207EEAG | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| MAX207ENG | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX16005ETE+ | 功能描述:监控电路 Quad/Hex/Octal Volt uP Supervisor RoHS:否 制造商:STMicroelectronics 监测电压数: 监测电压: 欠电压阈值: 过电压阈值: 输出类型:Active Low, Open Drain 人工复位:Resettable 监视器:No Watchdog 电池备用开关:No Backup 上电复位延迟（典型值）:10 s 电源电压-最大:5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:UDFN-6 封装:Reel |
| MAX16005ETE+T | 功能描述:监控电路 Quad/Hex/Octal Volt uP Supervisor RoHS:否 制造商:STMicroelectronics 监测电压数: 监测电压: 欠电压阈值: 过电压阈值: 输出类型:Active Low, Open Drain 人工复位:Resettable 监视器:No Watchdog 电池备用开关:No Backup 上电复位延迟（典型值）:10 s 电源电压-最大:5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:UDFN-6 封装:Reel |
| MAX16005EUE+ | 制造商:Maxim Integrated Products 功能描述: |
| MAX16006ATG | 制造商:Maxim Integrated Products 功能描述:LOW-VOLTAGE, QUAD-/HEX-/OCTAL-VOLTAGE MICROPR - Rail/Tube |
| MAX16006ATG+ | 功能描述:监控电路 Quad/Hex/Octal Volt uP Supervisor RoHS:否 制造商:STMicroelectronics 监测电压数: 监测电压: 欠电压阈值: 过电压阈值: 输出类型:Active Low, Open Drain 人工复位:Resettable 监视器:No Watchdog 电池备用开关:No Backup 上电复位延迟（典型值）:10 s 电源电压-最大:5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:UDFN-6 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。