- 您现在的位置：买卖IC网 > PDF目录1838 > MAX1637EEE (Maxim Integrated Products)IC REG CTRLR BUCK PWM CM 16-QSOP PDF资料下载
参数资料
| 型号： | MAX1637EEE |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 11/20页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 16-QSOP |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 100 |
| PWM 型： | 电流模式，混合 |
| 输出数： | 1 |
| 频率 - 最大： | 338kHz |
| 占空比： | 96% |
| 电源电压： | 3.15 V ~ 5.5 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 16-SSOP（0.154"，3.90mm 宽） |
| 包装： | 管件 |
Miniature, Low-Voltage,
Precision Step-Down Controller
Idle Mode
When SKIP is low, idle-mode circuitry automatically
Table 3. SKIP PWM Table
optimizes efficiency throughout the load-current range.
Idle mode dramatically improves light-load efficiency
by reducing the effective frequency, subsequently
reducing switching losses. It forces the peak inductor
current to ramp to 30% of the full current limit, deliver-
ing extra energy to the output and allowing subsequent
cycles to be skipped. Idle mode transitions seamlessly
to fixed-frequency PWM operation as load current
increases (Table 3).
Fixed-Frequency Mode
When SKIP is high, the controller always operates in
SKIP
Low
Low
High
High
LOAD
CURRENT
Light
Heavy
Light
Heavy
MODE
Idle
PWM
PWM
PWM
DESCRIPTION
Pulse-skipping, discontin-
uous inductor current
Constant frequency PWM,
continuous inductor current
Constant frequency PWM,
continuous inductor current
Constant frequency PWM,
continuous inductor current
fixed-frequency PWM mode for lowest noise. Each pulse
from the oscillator sets the main PWM latch that turns on
the high-side switch for a period determined by the duty
factor (approximately V OUT / V IN ). As the high-side switch
turns off, the synchronous rectifier latch is set; 60ns later,
the low-side switch turns on. The low-side switch stays on
until the beginning of the next clock cycle.
In PWM mode, the controller operates as a fixed-fre-
quency, current-mode controller in which the duty fac-
tor is set by the input/output voltage ratio. PWM mode
( SKIP = high) forces two changes on the PWM con-
troller. First, it disables the minimum-current compara-
tor, ensuring fixed-frequency operation. Second, it
changes the detection threshold for reverse-current
limit from 0mV to -100mV, allowing the inductor current
to reverse at light loads. This results in fixed-frequency
operation and continuous inductor-current flow. PWM
mode eliminates discontinuous-mode inductor ringing
and improves cross-regulation of transformer-coupled,
multiple-output supplies.
V CC
R1
R2
The current-mode feedback system regulates the peak
inductor-current value as a function of the output volt-
age error signal. In continuous-conduction mode, the
average inductor current is nearly the same as the
peak current, so the circuit acts as a switch-mode
transconductance amplifier. This pushes the second
output LC filter pole, normally found in a duty-factor-
controlled (voltage-mode) PWM, to a higher frequency.
To preserve inner-loop stability and eliminate regenera-
tive inductor-current “staircasing,” a slope-compensa-
tion ramp is summed into the main PWM comparator to
make the apparent duty factor less than 50%.
The relative gains of the voltage-sense and current-
sense inputs are weighted by the values of the current
sources that bias four differential input stages in the
main PWM comparator (Figure 4). The voltage sense
into the PWM has been conditioned by an integrated
component of the feedback voltage, yielding excellent
DC output voltage accuracy. See the Output Voltage
Accuracy section for details.
TO PWM
LOGIC
UNCOMPENSATED
CC
FB
HIGH-SPEED
LEVEL TRANSLATOR
AND BUFFER
I1
I2
I3
I4
V BIAS
OUTPUT DRIVER
REF
CSH
CSL
SLOPE COMPENSATION
Figure 4. Main PWM Comparator Functional Diagram
______________________________________________________________________________________
11
相关PDF资料 |
PDF描述 |
|---|---|
| MAX1638EAG+T | IC STEP-DWN CTRLR HI-SPD 24-SSOP |
| MAX1639ESE+T | IC REG CTRLR BUCK PWM CM 16-SOIC |
| MAX1641EEE+ | IC SW-MODE CUR SOURCE ADJ 16QSOP |
| MAX1644EAE-T | IC REG BUCK SYNC ADJ 2A 16SSOP |
| MAX1651CSA | IC REG CTRLR BUCK PWM 8-SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX1637EEE+ | 功能描述:DC/DC 开关控制器 Mini Precision Step Down RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| MAX1637EEE+T | 功能描述:DC/DC 开关控制器 Mini Precision Step Down RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| MAX1637EEE-T | 功能描述:DC/DC 开关控制器 RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| MAX1637EVKIT | 制造商:Maxim Integrated Products 功能描述:MINIATURE, LOW-VOLTAGE, PRECISION STEP-DOWN C - Bulk |
| MAX1638BEAG | 制造商:MAX 功能描述: 制造商:Maxim Integrated Products 功能描述: |
发布紧急采购，3分钟左右您将得到回复。