- 您现在的位置：买卖IC网 > PDF目录1838 > MAX16974AUE/V+ (Maxim Integrated Products)IC REG BUCK SYNC 5V/ADJ 16TSSOP PDF资料下载
参数资料
| 型号： | MAX16974AUE/V+ |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 11/19页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC 5V/ADJ 16TSSOP |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 96 |
| 类型： | 降压（降压） |
| 输出类型： | 两者兼有 |
| 输出数： | 1 |
| 输出电压： | 5V，1 V ~ 10 V |
| 输入电压： | 3.5 V ~ 28 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 260kHz ~ 2.2MHz |
| 电流 - 输出： | 2A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-TSSOP（0.173"，4.40mm）裸露焊盘 |
| 包装： | 管件 |
| 供应商设备封装： | 16-TSSOP-EP |
High-Voltage, 2.2MHz, 2A Automotive Step-
Down Converter with Low Operating Current
Linear Regulator Output (BIAS)
The device includes a 5V linear regulator, V BIAS, that
provides power to the internal circuitry. Connect a 1 F F
ceramic capacitor from BIAS to GND. If the output
voltage is set between 3.0V and 5.6V, the internal lin-
ear regulator only provides power until the output is in
regulation. The internal linear regulator turns off once the
output is in regulation and load current is below 50mA,
allowing the output to provide power to the device.
External Clock Input (FSYNC)
The device synchronizes to an external clock signal
applied at FSYNC. The signal at FSYNC must have a
10% shorter period than the internal clock period for
proper synchronization. The internal clock signal takes
over if the externally applied signal has a frequency
lower than the internal clock frequency.
Adjustable Reset Level
The device features a programmable reset threshold
using a resistive divider between OUT, RESETI, and
GND. Connect RESETI to GND for the internal threshold.
RES asserts low when the output voltage falls to 85% of
its programmed level. RES deasserts when the output
voltage goes above 90% of its set voltage.
Some microprocessors have a wide input voltage range
(5V to 3.3V) and can operate during device dropout. Use
a resistive divider at RESETI to adjust the reset activation
level ( RES goes low) to lower levels. The reference volt-
age at RESETI is 1.2V (typ).
The device also offers a capacitor-programmable reset
timeout period. Connect a capacitor from CRES to GND
to adjust the reset timeout period. When the output volt-
age goes out of regulation, RES asserts low, and the
reset timing capacitor discharges with a 1mA pulldown
current. Once the output is back in regulation, the reset
timing capacitor recharges with 10 F A (typ) current. RES
stays low until the voltage at CRES reaches 1.25V (typ).
Dropout Operation
The device has an effective maximum duty cycle to help
refresh the BST capacitor when continuously operated
in dropout. When the high-side switch is on for three
consecutive clock cycles, the device forces the high-
side switch off during the final 35% of the fourth clock
cycle. When the high-side switch is off, the LX node
is pulled low by current flowing through the external
Schottky diode. This increases the voltage across the
BST capacitor. To ensure that the inductor has enough
current to pull LX to ground, an internal load sinks cur-
rent from V OUT when the device is close to dropout and
when the external load is small. Once the input voltage
is increased above the dropout region, the device con-
tinues to regulate without restarting.
If the device has neither external clock nor external load,
the effective maximum duty cycle is 92% when operating
deep into dropout. This effective maximum duty cycle is
influenced by the external load and by the external syn-
chronized clock, if any.
System Enable (EN)
An enable-control input (EN) activates the device from its
low-power shutdown mode. EN is compatible with inputs
from automotive battery level down to 3.3V. The high-
voltage compatibility allows EN to be connected to SUP,
KEY/KL30, or the INH pin of a CAN transceiver.
EN turns on the internal regulator. Once V BIAS is above
the internal lockout level, V UVL = 3.05V (typ), the con-
troller activates and the output voltage ramps up within
2048 cycles of the switching frequency.
A logic-low at EN shuts down the device. During shut-
down, the internal linear regulator and gate drivers turn
off. Shutdown is the lowest power state and reduces the
quiescent current to 5 F A (typ). Drive EN high to bring the
device out of shutdown.
Overvoltage Protection
The device includes an overvoltage protection
circuit that protects the device when there is an over-
voltage condition at the output. If the output voltage
increases by more than 10% of its set voltage, the device
stops switching. The device resumes regulation once the
overvoltage condition is removed.
Overload Protection
The overload protection circuitry is activated when the
device is in current limit and V OUT is below the reset
threshold. Under these conditions the device enters a
soft-start mode. If the overcurrent condition is removed
before the soft-start mode is over, the device regulates
the output voltage to its set value. Otherwise, the soft-
start cycle repeats until the overcurrent condition is
removed.
_______________________________________________________________________________________ _ 11
相关PDF资料 |
PDF描述 |
|---|---|
| MAX16975AEE/V+ | IC REG BUCK SYNC 5V/ADJ 16QSOP |
| MAX16976AEE/V+ | IC REG BUCK 5V/ADJ 0.6A 16QSOP |
| MAX16977SAUE/V+ | IC BUCK SYNC ADJ 2A 16TSSOP |
| MAX1697REUT#TG16 | IC REG SWITCHED CAP INV SOT23-6 |
| MAX16998DAUA/V+ | IC TIMER WATCHDOG 8UMAX |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX16974EVKIT+ | 功能描述:电源管理IC开发工具 MAX16974 Eval Kit RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| MAX16975AAEE/V+ | 功能描述:直流/直流开关转换器 28V 1A 2MHz Step Down RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| MAX16975AAEE/V+T | 功能描述:直流/直流开关转换器 28V 1A 2MHz Step Down RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| MAX16975AEE/V+ | 功能描述:直流/直流开关转换器 28V 1A 2MHz Step Down RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| MAX16975AEE/V+T | 功能描述:直流/直流开关转换器 28V 1A 2MHz Step Down RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
发布紧急采购，3分钟左右您将得到回复。