- 您现在的位置：买卖IC网 > PDF目录15533 > MAX17015BETP+ (Maxim Integrated Products)IC BATT CHARGER 1.2MHZ 20-TQFN PDF资料下载
参数资料
| 型号： | MAX17015BETP+ |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 9/22页 |
| 文件大小： | 0K |
| 描述： | IC BATT CHARGER 1.2MHZ 20-TQFN |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 75 |
| 功能： | 充电管理 |
| 电池化学： | 多化学 |
| 电源电压： | 8 V ~ 26 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-WFQFN 裸露焊盘 |
| 供应商设备封装： | 20-TQFN-EP（4x4） |
| 包装： | 管件 |
1.2MHz, Low-Cost,
High-Performance Chargers
Pin Description
PIN
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
—
NAME
DCIN
AGND
CSIP
CSIN
IINP
BATT/FB
ACOK
CSSP
CSSN
ISET
PGND
DLO
LDO
BST
DHI
LX
ACIN
V AA
CC
VCTL
BP
FUNCTION
Charger Bias Supply Input. Bypass DCIN with a 1μF capacitor to PGND.
Analog Ground
Output Current-Sense Positive Input. Connect a current-sense resistor from CSIP to CSIN.
Output Current-Sense Negative Input
Input Current-Monitor Output. IINP sources the current proportional to the current sensed across
CSSP and CSSN. The transconductance from (CSSP - CSSN) to IINP is 2.8μA/mV. See the Analog
Input Current-Monitor Output section to configure the current monitor for a particular gain setting.
Battery Voltage Feedback Input. For the MAX17015B, connect a resistor voltage-divider from the
battery output to FB (see Figure 1).
AC Detect Output. This open-drain output is high impedance when ACIN is lower than V AA /2.
Connect a 10k pullup resistor from LDO to ACOK .
Input Current Sense for Positive Input. Connect a current-sense resistor from CSSP to CSSN.
Input Current-Sense Negative Input
Dual Mode ? Input for Setting Maximum Charge Current. ISET can be configured either with a
resistor voltage-divider or with a PWM signal from 128Hz to 500kHz. If there is no clock edge
within 20ms, ISET defaults to analog input mode. Pull ISET to AGND to shut down the charger. In
the MAX17015B, when the adapter is absent, drive ISET above 1V to enable IINP during battery
discharge. When the adapter is reinserted, ISET must be released to the correct control level within
300ms.
Power Ground Connection for MOSFET Drivers
Low-Side Power-MOSFET Driver Output. Connect to low-side n-channel MOSFET gate.
Linear-Regulator Output. LDO provides the power to the MOSFET drivers. LDO is the output of the 5.4V
linear regulator supplied from DCIN. Bypass LDO with a 4.7μF ceramic capacitor from LDO to PGND.
High-Side Driver Supply. Connect a 0.68μF capacitor from BST to LX.
High-Side Power-MOSFET Driver Output. Connect to high-side n-channel MOSFET gate.
High-Side Driver Source Connection. Connect a 0.68μF capacitor from BST to LX.
AC Adapter Detect Input. ACIN is the input to an uncommitted comparator.
4.2V Voltage Reference and Device Power-Supply Input. Bypass V AA with a 1μF capacitor to AGND.
Voltage Regulation Loop-Compensation Point. Connect a 0.01μF capacitor from CC to AGND.
Battery Voltage Adjust Input. VCTL sets the number of cells and adjusts the voltage per cell. The
adjustment range is 4.2V to 4.4V per cell. See the Setting Charge Voltage section .
Backside Paddle. Connect the backside paddle to analog ground.
Dual Mode is a trademark of Maxim Integrated Products, Inc.
_______________________________________________________________________________________
9
相关PDF资料 |
PDF描述 |
|---|---|
| MAX17006BETP+ | IC BATT CHARGER 1.2MHZ 20-TQFN |
| V48C48C75BL3 | CONVERTER MOD DC/DC 48V 75W |
| MAX8731AETI+T | IC SMBUS LVL2 BATT CHRGR 28TQFN |
| V48C48C75BL2 | CONVERTER MOD DC/DC 48V 75W |
| V48C48C75B3 | CONVERTER MOD DC/DC 48V 75W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX17015BETP+ | 功能描述:电池管理 1.2MHz High-Perf Charger RoHS:否 制造商:Texas Instruments 电池类型:Li-Ion 输出电压:5 V 输出电流:4.5 A 工作电源电压:3.9 V to 17 V 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:VQFN-24 封装:Reel |
| MAX17015BETP+T | 功能描述:电池管理 1.2MHz High-Perf Charger RoHS:否 制造商:Texas Instruments 电池类型:Li-Ion 输出电压:5 V 输出电流:4.5 A 工作电源电压:3.9 V to 17 V 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:VQFN-24 封装:Reel |
| MAX17015ETP+ | 功能描述:电池管理 1.2MHz High-Perf Charger RoHS:否 制造商:Texas Instruments 电池类型:Li-Ion 输出电压:5 V 输出电流:4.5 A 工作电源电压:3.9 V to 17 V 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:VQFN-24 封装:Reel |
| MAX17015ETP+T | 功能描述:电池管理 1.2MHz High-Perf Charger RoHS:否 制造商:Texas Instruments 电池类型:Li-Ion 输出电压:5 V 输出电流:4.5 A 工作电源电压:3.9 V to 17 V 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:VQFN-24 封装:Reel |
| MAX17015ETP+TG51 | 功能描述:电池管理 RoHS:否 制造商:Texas Instruments 电池类型:Li-Ion 输出电压:5 V 输出电流:4.5 A 工作电源电压:3.9 V to 17 V 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:VQFN-24 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。