- 您现在的位置：买卖IC网 > PDF目录1839 > MAX1744AUB/V+ (Maxim Integrated Products)IC REG CTRLR BUCK PWM 10-UMAX PDF资料下载
参数资料
| 型号： | MAX1744AUB/V+ |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 7/15页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM 10-UMAX |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 50 |
| PWM 型： | 控制器 |
| 输出数： | 1 |
| 频率 - 最大： | 330kHz |
| 占空比： | 100% |
| 电源电压： | 4.5 V ~ 36 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 10-TFSOP，10-MSOP（0.118"，3.00mm 宽） |
| 包装： | 管件 |
High-Voltage, Step-Down DC-DC
Controllers in μMAX
Pin Description
NAME
PIN
MAX1744
MAX1745
FUNCTION
1
2
3
4
GND
VL
REF
3/5
GND
VL
REF
—
Ground
5V Linear Regulator Output. VL provides power to the internal circuitry and can supply up
to 1mA to an external load. Bypass VL to GND with 4.7μF or greater capacitor.
1.25V Reference Output. REF can supply up to 100μA to an external load. Bypass REF to
GND with a 0.1μF or greater ceramic capacitor.
3.3V or 5V Selection. Connect 3/5 to GND to set the output voltage to 3.3V. Connect 3/5 to
VL to set the output voltage to 5V.
Feedback Input for Adjustable Output Operation. Connect to an external voltage-divider
4
—
FB
between the output and FB to set the output voltage. The regulation voltage threshold is
1.25V.
Sense Input for Fixed 5V or 3.3V Output Operation (MAX1744) and Negative Current-Sense
5
OUT
OUT
Input (MAX1744/5). OUT is connected to an internal voltage-divider (MAX1744). OUT does
not supply current.
Current-Sense Input. Connect the current-sense resistor between CS and OUT. External
6
CS
CS
MOSFET is turned off when the voltage across the resistor is equal to or greater than the
current limit trip level (100mV).
Active-Low Shutdown Input. Connect SHDN to IN for normal operation. Drive SHDN to low
7
SHDN
SHDN
to shut the part off. In shutdown mode, the reference, output, external MOSFET, and
internal regulators are turned off.
High-Side Linear Regulator Output. VH provides a regulated output voltage that is 5V below
8
VH
VH
IN. The external P-channel MOSFET gate is driven between IN and VH. Bypass VH to IN
with a 4.7μF or greater capacitor (see the Capacitor Selection section).
9
10
EXT
IN
EXT
IN
Gate Drive for External P-Channel MOSFET. EXT swings between IN and VH.
Positive Supply Input. Bypass IN to GND with a 0.47μF or greater ceramic capacitor.
Detailed Description
The MAX1744/MAX1745 are high-voltage step-down
DC-DC converter controllers. These devices offer high
efficiency over a wide range of input/output voltages
and currents, making them optimal for use in applica-
tions such as telecom, automotive, and industrial con-
trol. Using an external P-channel MOSFET and
current-sense resistor allows design flexibility and
improved efficiency. The MAX1744/MAX1745 automati-
cally switch from PWM operation at medium and heavy
loads to pulse-skipping operation at light loads to
improve light-load efficiency. The low 90μA quiescent
current further optimizes these parts for applications
where low input current is critical. Operation to 100%
duty cycle allows the lowest possible dropout voltage,
which allows a wider input voltage variation. The small
size, high switching frequency, and low parts count
minimize the required circuit board area and compo-
nent cost. Figure 1 shows the MAX1744 typical applica-
tion circuit.
Operating Modes
When delivering low output currents, the MAX1744/
MAX1745 operate in discontinuous-conduction mode.
Current through the inductor starts at zero, rises as
high as the current limit, then ramps down to zero dur-
ing each cycle (Figure 3). The switch waveform exhibits
ringing, which occurs at the resonant frequency of the
inductor and stray capacitance, due to residual energy
trapped in the core when the commutation diode (D1 in
Figure 1) turns off.
When delivering medium-to-high output currents, the
MAX1744/MAX1745 operate in PWM continuous-con-
duction mode (Figure 4). In this mode, current always
flows through the inductor and never ramps to zero.
The control circuit adjusts the switch duty cycle to
maintain regulation without exceeding the peak switch-
ing current set by the current-sense resistor.
_______________________________________________________________________________________
7
相关PDF资料 |
PDF描述 |
|---|---|
| MAX1747EUP+ | IC CHRG-PUMP TRPL TFTLCD 20TSSOP |
| MAX17480GTL+T | IC CTRLR SERIAL VID 40-TQFN |
| MAX17482GTL+ | IC CTLR PWM DUAL IMVP-6.5 40TQFN |
| MAX1748EUE+T | IC DC-DC CONV TRPL LCD 16-TSSOP |
| MAX17497AATE+T | IC OFF-LINE CONVERTER 16TQFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX1744EUB | 功能描述:DC/DC 开关控制器 Step-Down DC/DC Controller RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| MAX1744EUB/V+ | 功能描述:DC/DC 开关控制器 Step-Down DC/DC Controller RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| MAX1744EUB/V+T | 功能描述:DC/DC 开关控制器 Step-Down DC/DC Controller RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| MAX1744EUB+ | 功能描述:DC/DC 开关控制器 Step-Down DC/DC Controller RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| MAX1744EUB+ | 制造商:Maxim Integrated Products 功能描述:CONTROLLER STEP DOWN DC-DC 1744 制造商:Maxim Integrated Products 功能描述:CONTROLLER, STEP DOWN, DC-DC, 1744 |
发布紧急采购，3分钟左右您将得到回复。