参数资料
型号: MAX1744AUB/V+
厂商: Maxim Integrated Products
文件页数: 8/15页
文件大小: 0K
描述: IC REG CTRLR BUCK PWM 10-UMAX
产品培训模块: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
标准包装: 50
PWM 型: 控制器
输出数: 1
频率 - 最大: 330kHz
占空比: 100%
电源电压: 4.5 V ~ 36 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 125°C
封装/外壳: 10-TFSOP,10-MSOP(0.118",3.00mm 宽)
包装: 管件
High-Voltage, Step-Down DC-DC
Controllers in μMAX
INPUT
4.5V TO 36V
C2
4.7 μ F
LOW ESR
0.47 μ F
C3
4.7 μ F
D2
ON
5V
OFF
3.3V
IN
SHDN
3/5
VH
EXT
P M1
FAIRCHILD
NDS9407
L1
22 μ H
R SENSE
40m Ω
OUT
MAX1744
CS
3.3V OR 5V
2A
VL
REF
GND
OUT
D1
NIHON
EC2IQ506
C1
220 μ F
Figure 1. Typical Application Circuit
100% Duty Cycle and Dropout
The MAX1744/MAX1745 operate with a duty cycle up to
100%. This feature extends the input voltage range by
turning the MOSFET on continuously when the supply
voltage approaches the output voltage. This services
the load when conventional switching regulators with
less than 100% duty cycle would fail. Dropout voltage is
defined as the difference between the input and output
voltages when the input is low enough for the output to
drop out of regulation. Dropout depends on the
MOSFET drain-to-source on-resistance, current-sense
resistor, and inductor series resistance, and is propor-
tional to the load current:
Dropout voltage=
?
I OUT x ? R DS(ON) + R SEN SE + R INDUCTOR ??
Regulation Control Scheme
The MAX1744/MAX1755 have a unique operating
scheme that allows PWM operation at medium and high
current, with automatic switching to pulse-skipping
mode at lower currents to improve light-load efficiency.
Figure 2 shows the simplified block diagram.
Under medium- and heavy-load operation, the inductor
current is continuous and the part operates in PWM
mode. In this mode, the switching frequency is set by
either the 1μs minimum on-time or the 2μs minimum off-
time, depending on the duty cycle. The duty cycle is
approximately the output voltage divided by the input
voltage. If the duty cycle is less than 33%, the minimum
on-time controls the frequency; and the frequency is
approximately f ≈ 1MHz ? D, where D is the duty cycle.
If the duty cycle is greater than 33%, the off-time sets the
frequency; and the frequency is approximately f ≈ 500kHz
? (1 - D).
In both cases, the voltage is regulated by the error
comparator. For low duty cycles (<33%), the MOSFET
is turned on for the minimum on-time, causing fixed-on-
time operation. During the MOSFET on-time, the output
voltage rises. Once the MOSFET is turned off, the volt-
age drops to the regulation threshold (set by the inter-
nal voltage-divider for the MAX1745 and by the external
voltage-divider for the MAX1744), at which time another
cycle is initiated. For high duty cycles (>33%), the
MOSFET remains off for the minimum off-time, causing
fixed-off-time operation. In this case, the MOSFET
remains on until the output voltage rises to the regula-
tion threshold. Then the MOSFET turns off for the mini-
mum off-time, initiating another cycle.
By switching between fixed-on-time and fixed-off-time
operation, the MAX1744/MAX1745 can operate at high
input-output ratios, yet still operate up to 100% duty
cycle for low dropout. Note that when transitioning from
fixed-on-time to fixed-off-time operation, the output volt-
age drops slightly due to the output ripple voltage. In
fixed-on-time operation, the minimum output voltage is
regulated, but in fixed-off-time operation, the maximum
output voltage is regulated. Thus, as the input voltage
drops below approximately three times the output volt-
age, a decrease in line regulation can be expected.
The drop in voltage is approximately V DROP ≈ V RIPPLE / 2.
At light output loads, the inductor current is discontinu-
ous, causing the MAX1744/MAX1745 to operate at
8
_______________________________________________________________________________________
相关PDF资料
PDF描述
MAX1747EUP+ IC CHRG-PUMP TRPL TFTLCD 20TSSOP
MAX17480GTL+T IC CTRLR SERIAL VID 40-TQFN
MAX17482GTL+ IC CTLR PWM DUAL IMVP-6.5 40TQFN
MAX1748EUE+T IC DC-DC CONV TRPL LCD 16-TSSOP
MAX17497AATE+T IC OFF-LINE CONVERTER 16TQFN
相关代理商/技术参数
参数描述
MAX1744EUB 功能描述:DC/DC 开关控制器 Step-Down DC/DC Controller RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK
MAX1744EUB/V+ 功能描述:DC/DC 开关控制器 Step-Down DC/DC Controller RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK
MAX1744EUB/V+T 功能描述:DC/DC 开关控制器 Step-Down DC/DC Controller RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK
MAX1744EUB+ 功能描述:DC/DC 开关控制器 Step-Down DC/DC Controller RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK
MAX1744EUB+ 制造商:Maxim Integrated Products 功能描述:CONTROLLER STEP DOWN DC-DC 1744 制造商:Maxim Integrated Products 功能描述:CONTROLLER, STEP DOWN, DC-DC, 1744