- 您现在的位置：买卖IC网 > PDF目录13556 > MAX1760HETB+T (Maxim Integrated Products)IC REG BST SYNC 3.3V/ADJ 10TDFN PDF资料下载
参数资料
| 型号： | MAX1760HETB+T |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 8/14页 |
| 文件大小： | 0K |
| 描述： | IC REG BST SYNC 3.3V/ADJ 10TDFN |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 2,500 |
| 类型： | 升压（升压） |
| 输出类型： | 两者兼有 |
| 输出数： | 1 |
| 输出电压： | 3.3V，2.5 V ~ 5.5 V |
| 输入电压： | 0.7 V ~ 5.5 V |
| PWM 型： | 混合物 |
| 频率 - 开关： | 1MHz |
| 电流 - 输出： | 800mA |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-WFDFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 10-TDFN-EP（3x3） |
0.8A, Low-Noise, 1MHz,
Step-Up DC-DC Converter
Table 1. Typical Available Output Current
NUMBER OF NiCd/NiMH
CELLS
1
INPUT VOLTAGE
(V)
1.2
2.4
OUTPUT VOLTAGE
(V)
3.3
3.3
OUTPUT CURRENT
(mA)
350
800
2
2.4
5.0
500
3
3.6
5.0
750
Table 2. Selecting the Operating Mode
CLK/SEL
0
1
External clock
500kHz to 1.2MHz
MODE
Normal operation
Forced PWM
Synchronized PWM
FEATURES
High efficiency at all loads. Fixed frequency at all but light loads.
Low noise, fixed frequency at all loads.
Low noise, fixed frequency at all loads.
output filter capacitor and the load. As the energy
stored in the inductor is depleted, the current ramps
down and the synchronous rectifier turns off. At light
loads, the device operates at fixed frequency or only as
needed to maintain regulation, depending on the
CLK/SEL setting (Table 2).
Normal Operation
Pulling CLK/SEL low selects the MAX1760 ’s normal
operating mode. In this mode, the device operates in
PWM when driving medium-to-heavy loads, and auto-
matically switches to PFM if the load requires less
power. PFM operation allows higher efficiency than
PWM under light-load conditions.
Forced-PWM Operation
When CLK/SEL is high, the MAX1760 operates in a low-
noise PWM-only mode. During forced-PWM operation,
the MAX1760 switches at a constant frequency (1MHz)
and modulates the MOSFET switch pulse width to con-
trol the power transferred per cycle to regulate the out-
put voltage. Switching harmonics generated by
fixed-frequency operation are consistent and easily fil-
tered. See the Noise Spectrum plot in the Typical
Operating Characteristics.
Synchronized-PWM Operation
The MAX1760 can be synchronized in PWM mode to an
external frequency of 500kHz to 1.2MHz by applying an
external clock signal to CLK/SEL. This allows interfer-
ence to be minimized in wireless applications. The syn-
chronous rectifier is active during synchronized-PWM
operation.
Synchronous Rectifier
The MAX1760 features an internal, P-channel synchro-
nous rectifier to enhance efficiency. Synchronous recti-
fication provides 5% improved efficiency over similar
nonsynchronous boost regulators. In PWM mode, the
synchronous rectifier is turned on during the second
half of each switching cycle. In low-power mode, an
internal comparator turns on the synchronous rectifier
when the voltage at LX exceeds the boost regulator
output, and turns it off when the inductor current drops
below 60mA. When setting output voltages greater than
4V, an external 0.5A Schottky diode must be connected
in parallel with the on-chip synchronous rectifier.
Low-Voltage Startup Oscillator
The MAX1760 uses a CMOS, low-voltage startup oscil-
lator for a 1.1V guaranteed minimum startup input volt-
age. At startup, the low-voltage oscillator switches the
N-channel MOSFET until the output voltage reaches
2.15V. Above this level, the normal boost-converter
feedback and control circuitry take over. Once the
device is in regulation, it can operate down to 0.7V
input since internal power for the IC is bootstrapped
from the output through OUT. Do not apply full load
until the output exceeds 2.3V.
Shutdown
The MAX1760 has a shutdown mode that reduces qui-
escent current to 0.1μA. During shutdown ( ON = high
on MAX1760, ON = low on MAX1760H), the reference
and all feedback and control circuitry are off. During
shutdown, the output voltage is one diode drop below
the input voltage.
8
_______________________________________________________________________________________
相关PDF资料 |
PDF描述 |
|---|---|
| EB63-S1R1560X | CONN EDGEBOARD DUAL 30POS 3A |
| VI-2TM-EX-F1 | CONVERTER MOD DC/DC 10V 75W |
| MAX859ESA+T | IC REG BOOST ADJ 60MA 8SOIC |
| MAX6760TARGD0+T | IC DETECT VOLT WINDOW 8-TDFN |
| MAX1760ETB+T | IC REG BST SYNC 3.3V/ADJ 10TDFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX1760HEUB | 功能描述:直流/直流开关转换器 0.8A Low-Noise 1MHz Step-Up RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| MAX1760HEUB+ | 功能描述:直流/直流开关转换器 0.8A Low-Noise 1MHz Step-Up RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| MAX1760HEUB+T | 功能描述:直流/直流开关转换器 0.8A Low-Noise 1MHz Step-Up RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| MAX1760HEUB-T | 功能描述:直流/直流开关转换器 0.8A Low-Noise 1MHz Step-Up RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| MAX17611GTL+ | 制造商:Maxim Integrated Products 功能描述:IMVP7 CPU AND GRAPHICS CONTROLLER - Rail/Tube |
发布紧急采购，3分钟左右您将得到回复。