- 您现在的位置：买卖IC网 > PDF目录1840 > MAX1791EUB+T (Maxim Integrated Products)IC REG CTRLR BUCK PWM CM 10-UMAX PDF资料下载
参数资料
| 型号： | MAX1791EUB+T |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 13/20页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 10-UMAX |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 2,500 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 300kHz |
| 电源电压： | 5 V ~ 20 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 10-TFSOP，10-MSOP（0.118"，3.00mm 宽） |
| 包装： | 带卷 (TR) |
High-Efficiency, 10-Pin μMAX, Step-Down
Controllers for Notebooks
? i
? t
=
V BATT - V OUT
L
I PEAK
I PEAK
I LOAD
I LOAD = I PEAK /2
I LIMIT
0
ON-TIME
TIME
0
TIME
Figure 6. Pulse-Skipping/Discontinuous Crossover Point
rated for +0.5A, -0.9A source/sink capability and
swings from VL to GND.
The internal pulldown transistor that drives DL low is
robust, with a 1 ? typical on-resistance. This helps pre-
vent DL from being pulled up during the fast rise time of
the inductor node, due to capacitive coupling from the
drain to the gate of the low-side synchronous-rectifier
MOSFET. However, for high-current applications, some
combinations of high-and low-side FETS may cause
excessive gate-drain coupling, which can lead to poor
efficiency, EMI, and shoot-through currents.
An adaptive dead-time circuit monitors the DL output
and prevents the high-side FET from turning on until DL
is fully turned off. The dead time at the other edge (DH
turning off) is determined by a fixed 35ns (typ) internal
delay.
Low-Side Current-Limit Sensing (ILIM)
The current-limit circuit employs a unique “valley” cur-
rent-sensing algorithm that uses the on-state resistance
of the low-side MOSFET as a current-sensing element.
If the current-sense signal is below the current-limit
threshold (-100mV from CS to GND), the PWM is not
allowed to initiate a new cycle (Figure 7). The actual
peak current is greater than the current-limit threshold
Figure 7. “Valley” Current-Limit Threshold Point
sense voltage that appears at CS (Figure 8). Keep the
impedance at this mode low to avoid errors at CS.
POR and Soft-Start
Power-on reset (POR) occurs when V BATT rises above
approximately 2V, resetting the fault latch and soft-start
counter and preparing the PWM for operation. UVLO
circuitry inhibits switching until V VP rises above 4.1V,
whereupon an internal digital soft-start timer begins to
ramp up the maximum allowed current limit. The ramp
occurs in five steps: 20%, 40%, 60%, 80%, and 100%;
100% current is available after approximately 1.7ms.
Output Undervoltage Protection
The output UVLO function is similar to foldback current
limiting but employs a timer rather than a variable cur-
rent limit. The output undervoltage protection is
enabled 20ms after POR or when coming out of shut-
down. If the output is under 70% of the nominal value,
V P
DH
1.0k ?
by an amount equal to the inductor ripple current.
Therefore, the exact current-limit characteristic and
maximum load capability are a function of the MOSFET
MAX1762
MAX1791
CS
1.0k ?
V OUT
on-resistance, inductor value, and battery voltage.
If greater current-limit accuracy is desired, CS must be
connected to the junction of the low-side switch source
and a current-sense resistor to GND. The current limit
will be 0.1V/R SENSE , and the accuracy will be ±10%.
A resistive voltage-divider from the inductor’s switching
mode to ground can be used to adjust the current-limit
DL
Figure 8. Using a Resistive Voltage-Divider to Adjust Current-
Limit Sense Voltage to 200mV
______________________________________________________________________________________
13
相关PDF资料 |
PDF描述 |
|---|---|
| MAX1792EUA33+ | IC REG LDO 3.3V/ADJ .5A 8-UMAX |
| MAX1793EUE33+ | IC REG LDO 3.3V/ADJ 1A 16TSSOP |
| MAX1797EUA-T | IC REG BOOST SYNC FIX/ADJ 8UMAX |
| MAX1798EGP+T | IC POWER SUPPLY CDMA 20-QFN |
| MAX1801EKA+T | IC CNTRLR DC-DC SOT23-8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX1791EVKIT | 功能描述:DC/DC 开关控制器 Evaluation Kit for the MAX1791 MAX1762 RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| MAX1792EUA15 | 功能描述:低压差稳压器 - LDO 500mA RoHS:否 制造商:Texas Instruments 最大输入电压:36 V 输出电压:1.4 V to 20.5 V 回动电压（最大值）:307 mV 输出电流:1 A 负载调节:0.3 % 输出端数量: 输出类型:Fixed 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-20 |
| MAX1792EUA15+ | 功能描述:低压差稳压器 - LDO 500mA RoHS:否 制造商:Texas Instruments 最大输入电压:36 V 输出电压:1.4 V to 20.5 V 回动电压（最大值）:307 mV 输出电流:1 A 负载调节:0.3 % 输出端数量: 输出类型:Fixed 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-20 |
| MAX1792EUA15+T | 功能描述:低压差稳压器 - LDO 500mA RoHS:否 制造商:Texas Instruments 最大输入电压:36 V 输出电压:1.4 V to 20.5 V 回动电压（最大值）:307 mV 输出电流:1 A 负载调节:0.3 % 输出端数量: 输出类型:Fixed 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-20 |
| MAX1792EUA15-T | 功能描述:低压差稳压器 - LDO 500mA RoHS:否 制造商:Texas Instruments 最大输入电压:36 V 输出电压:1.4 V to 20.5 V 回动电压（最大值）:307 mV 输出电流:1 A 负载调节:0.3 % 输出端数量: 输出类型:Fixed 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-20 |
发布紧急采购，3分钟左右您将得到回复。