- 您现在的位置：买卖IC网 > PDF目录1840 > MAX1809ETI+ (Maxim Integrated Products)IC DDR TERMINATION 28-TQFN PDF资料下载
参数资料
| 型号： | MAX1809ETI+ |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 6/17页 |
| 文件大小： | 0K |
| 描述： | IC DDR TERMINATION 28-TQFN |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 60 |
| 应用： | 转换器，DDR |
| 输入电压： | 3 V ~ 5.5 V |
| 输出数： | 1 |
| 输出电压： | 1.1 V ~ 5.5 V |
| 工作温度： | 0°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-SSOP（0.154"，3.90mm 宽） |
| 供应商设备封装： | 16-QSOP |
| 包装： | 管件 |
3A, 1MHz, DDR Memory Termination Supply
Pin Description
PIN (QFN)
1, 5, 10, 11, 12,
22, 24, 26, 28
2, 4
PIN (QSOP)
—
2, 4
NAME
N.C.
IN
FUNCTION
No Connection. Not internally connected.
Supply Voltage Input for the Internal PMOS Power Switch. Not internally
connected. Externally connect all pins for proper operation.
Inductor Connection. Connection for the drains of the PMOS power switch
3, 18, 19, 23, 25
3, 14, 16
LX
and NMOS synchronous-rectifier switch. Connect the inductor from this
node to the output filter capacitor and load. Not internally connected.
Externally connect all pins for proper operation.
6
7
8
9
13, backside pad,
corner tabs
14
15
16
17, 20, 21
5
6
7
8
9
10
11
12
13, 15
SS
EXTREF
TOFF
FB
GND
REF
GND
V CC
PGND
Soft-Start. Connect a capacitor from SS to GND to limit inrush current
during startup.
External Reference Input. Feedback input regulates to V EXTREF . The PWM
controller remains off until EXTREF is greater than REF.
Off-Time Select Input. Sets the PMOS power switch constant-off-time.
Connect a resistor from TOFF to GND to adjust the PMOS switch off-time.
Feedback Input. Connect directly to output for fixed-voltage operation or to
a resistive-divider for adjustable operating modes.
Analog Ground. Connect exposed backside pad and corner tabs to analog
GND.
Reference Output. Bypass REF to GND with a 1μF capacitor.
Tie to GND (pin 13 QFN; pin 9 QSOP)
Analog Supply Voltage Input. Supplies internal analog circuitry. Bypass
V CC with a 10 ? and 2.2μF low-pass filter (see Figure 1).
Power Ground. Internally connected to the internal NMOS synchronous-
rectifier switch.
Shutdown Control Input. Drive SHDN low to disable the reference, control
27
1
SHDN
circuitry, and internal MOSFETs. Drive high or connect to V CC for normal
operation.
Detailed Description
The MAX1809 synchronous, current-mode, constant-
off-time, PWM DC-DC converter steps down input volt-
ages of 3V to 5.5V to an adjustable output voltage from
1.1V to V IN , as set by the voltage applied at EXTREF. It
sources and sinks up to 3A of output current. Internal
switches composed of a 90m ? PMOS power switch
and a 70m ? NMOS synchronous-rectifier switch
improve efficiency, reduce component count, and elim-
inate the need for an external Schottky diode across
the synchronous switch.
The MAX1809 operates in a constant-off-time mode
under all loads. A single resistor-programmable con-
stant-off-time control sets switching frequencies up to
1MHz, allowing the user to optimize performance trade-
offs in efficiency, switching noise, component size, and
cost.
When power is drawn from a regulated supply, con-
stant-off-time PWM architecture essentially provides
constant-frequency operation. This architecture has the
inherent advantage of quick response to line and load
transients. The MAX1809 ’ s current-mode, constant-off-
time PWM architecture regulates the output voltage by
changing the PMOS switch on-time relative to the con-
stant off-time.
Constant-Off-Time Operation
In the constant-off-time architecture, the FB voltage
comparator turns the PMOS switch on at the end of
each off-time, keeping the device in continuous-con-
duction mode. The PMOS switch remains on until the
6
_______________________________________________________________________________________
相关PDF资料 |
PDF描述 |
|---|---|
| MAX1810ESA | IC REG SMART CARD NETWORK 8-SOIC |
| MAX1811ESA+T | IC CHARGER USB LI+ 8-SOIC |
| MAX1812EUB+ | IC SW USB DUAL W/FB 10-UMAX |
| MAX1817EUB | IC REG BOOST 125MA DL 10UMAX |
| MAX1818EUT25#TG16 | IC REG LDO 2.5V/ADJ .5A SOT23-6 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX1809ETI+ | 功能描述:电压模式 PWM 控制器 3A 1MHz DDR Memory Termination Supply RoHS:否 制造商:Texas Instruments 输出端数量:1 拓扑结构:Buck 输出电压:34 V 输出电流: 开关频率: 工作电源电压:4.5 V to 5.5 V 电源电流:600 uA 最大工作温度:+ 125 C 最小工作温度:- 40 C 封装 / 箱体:WSON-8 封装:Reel |
| MAX1809ETI+T | 功能描述:电压模式 PWM 控制器 3A 1MHz DDR Memory Termination Supply RoHS:否 制造商:Texas Instruments 输出端数量:1 拓扑结构:Buck 输出电压:34 V 输出电流: 开关频率: 工作电源电压:4.5 V to 5.5 V 电源电流:600 uA 最大工作温度:+ 125 C 最小工作温度:- 40 C 封装 / 箱体:WSON-8 封装:Reel |
| MAX1809ETI-T | 功能描述:直流/直流开关转换器 RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| MAX180ACPL | 功能描述:数据转换系统 RoHS:否 制造商:Texas Instruments 转换速率:0.001 MSPs 分辨率:24 bit 最大工作温度:+ 125 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel |
| MAX180ACPL+ | 功能描述:数据转换系统 12-Bit 8Ch 100ksps 5.08V- Precision ADC RoHS:否 制造商:Texas Instruments 转换速率:0.001 MSPs 分辨率:24 bit 最大工作温度:+ 125 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。