参数资料
型号: MAX3320TEAP
厂商: Maxim Integrated Products
文件页数: 10/12页
文件大小: 0K
描述: IC TXRX RS232 250KBPS SD 20-SSOP
产品培训模块: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
标准包装: 66
类型: 收发器
驱动器/接收器数: 2/2
规程: RS232
电源电压: 3 V ~ 5.5 V
安装类型: 表面贴装
封装/外壳: 20-SSOP(0.209",5.30mm 宽)
供应商设备封装: 20-SSOP
包装: 管件
产品目录页面: 1407 (CN2011-ZH PDF)
其它名称: 153656
Q1153656
MAX3320A/B/L/T
3V to 5.5V, up to 250kbps True RS-232 Transceiver
with 4A AutoShutdown Plus and Power-On Reset
_______________________________________________________________________________________
7
reducing supply current to 4A. This occurs if the RS-232
cable is disconnected or the connected peripheral trans-
mitters turn off. The system turns on again when a valid
transition occurs at any RS-232 receiver or transmitter
input. As a result, the system saves power without
changes to the existing BIOS or operating system. The
INVALID output is high when the receivers are active.
Since INVALID indicates the receiver inputs’ condition, it
can be used in any mode (Figure 2).
Tables 1 and 2 and Figure 2 summarize the MAX3320’s
operating modes. FORCEON and FORCEOFF override
the automatic circuitry and force the transceiver into its
normal operating state or into its low-power standby
state. When neither control is asserted, the IC enters
AutoShutdown Plus mode and selects between these
states automatically, based on the last receiver or
transmitter input edge received.
When shut down, the device’s charge pumps turn off,
V+ decays to VCC , V- decays to ground, and the trans-
mitter outputs turn off (high impedance). The time
required to exit shutdown is typically 25s (Figure 3a).
Software-Controlled Shutdown
If direct software control is desired, use INVALID to indi-
cate DTR or Ring Indicator signal. Connect FORCEOFF
and FORCEON together to bypass the AutoShutdown
Plus feature so the line acts like a SHDN input.
Power-On Reset
In addition to issuing a reset to the microprocessor (P)
during power-up, power-down, and brownout condi-
tions, the MAX3320 is relatively immune to short-
duration, negative-going VCC transitions (glitches).
Typically, a VCC transient that goes 100mV below the
reset threshold and lasts 20s or less does not cause a
reset pulse (see
Typical Operating Characteristics).
Additional bypass capacitance mounted as close as
possible to the VCC pin provides additional transient
immunity.
Table 2. INVALID Truth Table
MAX3320
+0.3V
-0.3V
INVALID
R_IN
INVALID ASSERTED IF BOTH RECEIVER INPUTS ARE BETWEEN +0.3V AND -0.3V FOR
AT LEAST 90
s.
90s
TIMER
R
Figure 2a. INVALID Functional Diagram, INVALID Low
+2.7V
-2.7V
R_IN
INVALID DEASSERTED IF EITHER RECEIVER INPUT HAS BEEN BETWEEN +2.7V
AND -2.7V FOR LESS THAN 90
s.
INVALID
90s
TIMER
R
Figure 2b. INVALID Functional Diagram, INVALID High
AUTOSHDN
R_IN
T_IN
R
S
30sec
TIMER
EDGE
DETECT
EDGE
DETECT
FORCEOFF
FORCEON
Figure 2c. AutoShutdown Plus Logic
POWERDOWN*
AUTOSHDN
FORCEOFF
FORCEON
* POWERDOWN IS ONLY AN INTERNAL SIGNAL.
IT CONTROLS THE OPERATIONAL STATUS OF
THE TRANSMITTERS AND THE POWER SUPPLIES.
Figure 2d. Power-Down Logic
Yes
RS-232 SIGNAL PRESENT AT
RECEIVER INPUT
No
L
H
INVALID
OUTPUT
相关PDF资料
PDF描述
MS27656P15F37P CONN RCPT 37POS WALL MNT W/PINS
MS27467E15F37P CONN PLUG 37POS STRAIGHT W/PINS
MAX3316EUP+T TXRX RS232 2.5V 460KBPS 20TSSOP
MAX202EUE+ IC TXRX RS-232 W/CAP 16TSSOP
MAX3318EUP+T IC TXRX RS232 460KBPS 20-TSSOP
相关代理商/技术参数
参数描述
MAX3320TEAP+ 功能描述:RS-232接口集成电路 3-5.5V 250kbps Transceiver RoHS:否 制造商:Exar 数据速率:52 Mbps 工作电源电压:5 V 电源电流:300 mA 工作温度范围:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体:LQFP-100 封装:
MAX3320TEAP+T 功能描述:RS-232接口集成电路 3-5.5V 250kbps Transceiver RoHS:否 制造商:Exar 数据速率:52 Mbps 工作电源电压:5 V 电源电流:300 mA 工作温度范围:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体:LQFP-100 封装:
MAX3320TEAP-T 功能描述:RS-232接口集成电路 RoHS:否 制造商:Exar 数据速率:52 Mbps 工作电源电压:5 V 电源电流:300 mA 工作温度范围:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体:LQFP-100 封装:
MAX3322EEUP 功能描述:RS-232接口集成电路 RoHS:否 制造商:Exar 数据速率:52 Mbps 工作电源电压:5 V 电源电流:300 mA 工作温度范围:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体:LQFP-100 封装:
MAX3322EEUP+ 功能描述:RS-232接口集成电路 Transceiver For Multidrop Aps RoHS:否 制造商:Exar 数据速率:52 Mbps 工作电源电压:5 V 电源电流:300 mA 工作温度范围:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体:LQFP-100 封装: