- 您现在的位置：买卖IC网 > PDF目录2088 > MAX4409ETP+T (Maxim Integrated Products)IC AMP AUDIO .08W STER AB 20TQFN PDF资料下载
参数资料
| 型号： | MAX4409ETP+T |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 20/20页 |
| 文件大小： | 0K |
| 描述： | IC AMP AUDIO .08W STER AB 20TQFN |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 2,500 |
| 系列： | DirectDrive® |
| 类型： | AB 类 |
| 输出类型： | 耳机，2-通道（立体声） |
| 在某负载时最大输出功率 x 通道数量： | 80mW x 2 @ 16 欧姆 |
| 电源电压： | 1.8 V ~ 3.6 V |
| 特点： | 消除爆音，短路保护和热保护，关闭 |
| 安装类型： | 表面贴装 |
| 供应商设备封装： | 20-TQFN-EP（4x4） |
| 封装/外壳： | 20-WFQFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
MAX4409
80mW, DirectDrive, Stereo Headphone
Amplifier with Common-Mode Sense
_______________________________________________________________________________________
9
Detailed Description
The MAX4409 stereo headphone driver features Maxim’s
patented DirectDrive architecture, eliminating the large
output-coupling capacitors required by traditional single-
supply headphone drivers. The device consists of two
80mW Class AB headphone drivers, undervoltage lock-
out (UVLO)/shutdown control, charge-pump, and com-
prehensive click-and-pop suppression circuitry (see
Typical Application Circuit). The charge pump inverts the
positive supply (PVDD), creating a negative supply
(PVSS). The headphone drivers operate from these bipo-
lar supplies with their outputs biased about GND (Figure
1). The drivers have almost twice the supply range com-
pared to other 3V single-supply drivers, increasing the
available output power. The benefit of this GND bias is
that the driver outputs do not have a DC component typi-
cally VDD/2. Thus, the large DC-blocking capacitors are
unnecessary, improving frequency response while con-
serving board space and system cost.
The MAX4409 also features a common-mode voltage
sense input that corrects for mismatch between the
SGND of the device and the potential at the headphone
jack return. A low-power shutdown mode reduces sup-
ply current to 6A. The device features an undervoltage
lockout that prevents operation from an insufficient
power supply and click-and-pop suppression that elim-
inates audible transients on startup and shutdown.
Additionally, the MAX4409 features thermal overload
and short-circuit protection and can withstand
±8kV
ESD strikes on the output pins.
Common-Mode Sense
When the headphone jack is used as a line out to inter-
face between other equipment (notebooks, desktops,
and stereo receivers), potential differences between
the equipment grounds can create ground loops and
excessive ground current flow. The MAX4409 COM
input senses and corrects for the difference between
the headphone return and device ground. Connect
COM through a resistive voltage-divider between the
headphone jack return and SGND of the device (see
Typical Application Circuit). For optimum common-
mode rejection, use the same value resistors for R2 and
RIN, and R1 and RF. Improve DC CMRR by adding a
capacitor in between with SGND and R2 (see Typical
Application Circuit). If ground sensing is not required,
connect COM directly to SGND through a 5k
Ω resistor.
DirectDrive
Traditional single-supply headphone drivers have their
outputs biased about a nominal DC voltage (typically
half the supply) for maximum dynamic range. Large
coupling capacitors are needed to block this DC bias
from the headphone. Without these capacitors, a signif-
icant amount of DC current flows to the headphone,
resulting in unnecessary power dissipation and possi-
ble damage to both headphone and headphone driver.
Maxim’s patented DirectDrive architecture uses a
charge pump to create an internal negative supply volt-
age. This allows the outputs of the MAX4409 to be
biased about GND, almost doubling dynamic range
while operating from a single supply. With no DC com-
ponent, there is no need for the large DC-blocking
capacitors. Instead of two large (220F, typ) tantalum
capacitors, the MAX4409 charge pump requires two
small ceramic capacitors, thereby conserving board
space, reducing cost, and improving the frequency
response of the headphone driver. See the Output
Power vs. Charge-Pump Capacitance and Load
Resistance graph in the Typical Operating Char-
acteristics for details of the possible capacitor sizes.
There is a low DC voltage on the driver outputs due to
amplifier offset. However, the offset of the MAX4409 is
+VDD
-VDD
GND
VOUT
CONVENTIONAL DRIVER-BIASING SCHEME
DirectDrive BIASING SCHEME
VDD/2
VDD
GND
VOUT
Figure 1. Traditional Driver Output Waveform vs. MAX4409
Output Waveform
相关PDF资料 |
PDF描述 |
|---|---|
| MAX4410EUD+T | IC AMP AUDIO .08W STER 14TSSOP |
| MAX4411ETP+ | IC AMP AUDIO .08W STER AB 20TQFN |
| MAX44268EWL+T | IC COMPARATOR W/REF DUAL 9WLP |
| MAX44269EWL+T | IC COMPARATOR DUAL LP 9WLP |
| MAX4468EKA+T | IC PREAMP AUDIO MONO AB SOT23-8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX4409EUD | 制造商:Maxim Integrated Products 功能描述:80MW, DIRECTDRIVE, STEREO HEADPHONE AMPLIFIER - Bulk |
| MAX4409EUD+ | 制造商:Maxim Integrated Products 功能描述:AUD AMP HDPH 2CH STEREO 0.08W CLS-AB 14TSSOP - Rail/Tube |
| MAX4409EUD+T | 制造商:Maxim Integrated Products 功能描述:AUD AMP HDPH 2CH STEREO 0.08W CLS-AB 14TSSOP - Tape and Reel |
| MAX440C/D | 功能描述:多路器开关 IC RoHS:否 制造商:Maxim Integrated 通道数量: 开关数量: 开启电阻（最大值）: 开启时间（最大值）:40 ns 关闭时间（最大值）:10 ns 传播延迟时间: 工作电源电压:+/- 5 V 工作电源电流:40 mA 最大工作温度:+ 70 C 安装风格: 封装 / 箱体: |
| MAX440C/D DIE | 制造商:Maxim Integrated Products 功能描述: |
发布紧急采购，3分钟左右您将得到回复。