- 您现在的位置：买卖IC网 > PDF目录1842 > MAX5051AUI+T (Maxim Integrated Products)IC REG CTRLR PWM VM 28-TSSOP PDF资料下载
参数资料
| 型号： | MAX5051AUI+T |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 17/21页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR PWM VM 28-TSSOP |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 2,500 |
| PWM 型： | 电压模式 |
| 输出数： | 1 |
| 频率 - 最大： | 500kHz |
| 占空比： | 48% |
| 电源电压： | 11 V ~ 76 V |
| 降压： | 无 |
| 升压： | 是 |
| 回扫： | 是 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 是 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 28-SOIC（0.173"，4.40mm 宽）裸露焊盘 |
| 包装： | 带卷 (TR) |
Parallelable, Clamped Two-Switch
Power-Supply Controller IC
Integrating Fault Protection
The integrating fault protection feature allows transient
overcurrent conditions to be ignored for a programmable
#1
amount of time, giving the power supply time to behave
like a current source to the load. This can
RCOSC
SYNCIN
happen, for example, under load-current transients when
SYNCOUT
MAX5051
FLTINT
the control loop requests maximum current to keep the
output voltage from going out of regulation. The fault
integration time can be programmed externally by con-
necting a suitably sized capacitor to the FLTINT pin.
Under sustained overcurrent faults, the voltage across
this capacitor is allowed to ramp up towards the FLTINT
shutdown threshold (2.9V, typ). Once the threshold is
reached, the power supply shuts down. A high-value
bleed resistor connected in parallel with the FLTINT
capacitor allows it to discharge towards the restart
threshold (1.8V, typ). Once this threshold is reached, the
RCFF
CON
#2
RCOSC
STARTUP
UVLO
SYNCIN
supply restarts with a new soft-started cycle.
Note that cycle-by-cycle current limiting is provided at
SYNCOUT
MAX5051
FLTINT
all times by CS with a threshold of 154mV (typ). The
fault integration circuit works by forcing a 90μA current
out of FLTINT every time that the current-limit compara-
tor (Figure 1, CILIM) is tripped. Use the following formu-
la to calculate the value of the capacitor necessary for
the desired shutdown time of this circuit.
RCFF
CON
STARTUP
UVLO
C FLTINT = FLTINT SH
I t
0 . 9 V
where I FLTINT = 90μA, t SH is the desired fault integra-
tion time after the first shutdown cycle during which
current-limit events from the current-limit comparator
are ignored. For example, a 0.1μF capacitor gives a
fault integration time of 2.25ms.
Some testing may be required to fine-tune the actual
value of the capacitor. To calculate the required bleed
resistance R FLTINT , use the following formula:
Figure 7. Connection for Synchronized STARTUP of Two or
More MAX5051s
helps prevent startup conflicts when the secondaries of
the power supplies are paralleled. Connecting
SYNCOUT to SYNCIN is not necessary; however, when
used, this minimizes the ripple current though the input
bypass capacitors.
Applications Information
Isolated Telecom Power Supply
Figure 8 shows a complete design of an isolated syn-
chronously rectified power supply with a 36V to 72V
R FLTINT =
t RT
0 . 372 × C FLTINT
telecom voltage range. This power supply is fully pro-
tected and can sustain a continuous short circuit at its
output terminals. Figures 9 though 14 show some of the
where t RT is the desired recovery time.
Typically choose t RT = 10 x t SH . Typical values for t SH
range from a few hundred microseconds to a few mil-
liseconds.
Synchronizing Primary-Side STARTUP For
Parallel Operation
Figure 7 shows the connection diagram of two or more
MAX5051s for synchronized primary-side operation.
The common connection of STARTUP ensures all paral-
leled modules wakeup and shutdown in tandem. This
performance aspects of this power-supply design. This
circuit is available as a completely built and tested
evaluation kit.
______________________________________________________________________________________
17
相关PDF资料 |
PDF描述 |
|---|---|
| MAX5053BEUA+ | IC REG CTRLR BST ISO PWM 8-UMAX |
| MAX5059AUI+ | IC DRVR SYNC RECT 28-TSSOP |
| MAX5060ATI+ | IC REG CTRLR BUCK PWM CM 28-TQFN |
| MAX5065EAI+ | IC REG CTRLR BUCK PWM CM 28-SSOP |
| MAX5066AUI+T | IC REG CTRLR BUCK PWM CM 28TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX5051EUI+ | 制造商:Maxim Integrated Products 功能描述:- Rail/Tube |
| MAX5051EVKIT | 功能描述:电源管理IC开发工具 MAX5051 Eval Kit RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| MAX5052 | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Current-Mode PWM Controllers with an Error Amplifier for Isolated/Nonisolated Power Supplies |
| MAX5052AEUA | 功能描述:电流型 PWM 控制器 w/Error Amplifier RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
发布紧急采购，3分钟左右您将得到回复。