- 您现在的位置：买卖IC网 > PDF目录19374 > MAX6639YAEE+T (Maxim Integrated)IC TEMP MONITOR 2CH 16-QSOP PDF资料下载
参数资料
| 型号： | MAX6639YAEE+T |
| 厂商： | Maxim Integrated |
| 文件页数： | 19/22页 |
| 文件大小： | 0K |
| 描述： | IC TEMP MONITOR 2CH 16-QSOP |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 2,500 |
| 功能： | 风扇控制，温度监控器 |
| 传感器类型： | 内部和外部 |
| 感应温度： | 0°C ~ 150°C，外部传感器 |
| 拓扑： | ADC，PWM 发生器，转速计计数器 |
| 输出类型： | I²C?/SMBus? |
| 输出警报： | 是 |
| 输出风扇： | 是 |
| 电源电压： | 3 V ~ 3.6 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-SSOP（0.154"，3.90mm 宽） |
| 供应商设备封装： | 16-QSOP |
| 包装： | 带卷 (TR) |
MAX6639/MAX6639F
2-Channel Temperature Monitor with Dual,
Automatic, PWM Fan-Speed Controller
μ V
° C
= 0 . 453
μ V Ω
Effect of Series Resistance
Series resistance in a sense diode contributes addition-
al errors. For nominal diode currents of 10μA and
100μA, change in the measured voltage is:
Δ V M = R S (100μA - 10μA) = 90μA x R S
Since 1°C corresponds to 198.6μV, series resistance
contributes a temperature offset of:
90
Ω
198 . 6
° C
Assume that the diode being measured has a series
resistance of 3 Ω . The series resistance contributes an
offset of:
ADC Noise Filtering
The integrating ADC has inherently good noise rejec-
tion, especially of low-frequency signals such as
60Hz/120Hz power-supply hum. Micropower operation
places constraints on high-frequency noise rejection.
Lay out the PCB carefully with proper external noise fil-
tering for high-accuracy remote measurements in elec-
trically noisy environments.
Filter high-frequency electromagnetic interference
(EMI) at DXP and DXN with an external 2200pF capaci-
tor connected between the two inputs. This capacitor
can be increased to approximately 3300pF (max),
including cable capacitance. A capacitance higher
than 3300pF introduces errors due to the rise time of
the switched-current source.
Twisted Pairs and Shielded Cables
3 Ω × 0 . 453
° C
Ω
= 1 . 36 ° C
For remote-sensor distances longer than 8in, or in par-
ticularly noisy environments, a twisted pair is recom-
mended. Its practical length is 6ft to 12ft (typ) before
The effects of the ideality factor and series resistance
are additive. If the diode has an ideality factor of 1.002
and series resistance of 3 Ω , the total offset can be cal-
culated by adding error due to series resistance with
error due to ideality factor:
1.36°C - 2.13°C = -0.77°C
for a diode temperature of +85°C.
In this example, the effect of the series resistance and
the ideality factor partially cancel each other.
For best accuracy, the discrete transistor should be a
small-signal device with its collector connected to GND
and base connected to DXN. Table 12 lists examples of
discrete transistors that are appropriate for use with the
MAX6639.
The transistor must be a small-signal type with a rela-
tively high forward voltage; otherwise, the ADC input
voltage range can be violated. The forward voltage at
the highest expected temperature must be greater than
0.25V at 10μA, and at the lowest expected temperature,
the forward voltage must be less than 0.95V at 100μA.
Large-power transistors must not be used. Also, ensure
that the base resistance is less than 100 Ω . Tight speci-
fications for forward current gain (50 < ? < 150, for
example) indicate that the manufacturer has good
process controls and that the devices have consistent
V BE characteristics.
Maxim Integrated
noise becomes a problem, as tested in a noisy elec-
tronics laboratory. For longer distances, the best solu-
tion is a shielded twisted pair like that used for audio
microphones. For example, Belden #8451 works well
for distances up to 100ft in a noisy environment.
Connect the twisted pair to DXP and DXN and the
shield to ground, and leave the shield’s remote end
unterminated. Excess capacitance at DXN or DXP limits
practical remote-sensor distances (see the Typical
Operating Characteristics).
For very long cable runs, the cable’s parasitic capaci-
tance often provides noise filtering, so the recommend-
ed 2200pF capacitor can often be removed or reduced
in value. Cable resistance also affects remote-sensor
accuracy. A 1 Ω series resistance introduces about
+1/2°C error.
PCB Layout Checklist
1) Place the MAX6639 as close as practical to the
remote diode. In a noisy environment, such as a
computer motherboard, this distance can be 4in to
8in, or more, as long as the worst noise sources
(such as CRTs, clock generators, memory buses,
and ISA/PCI buses) are avoided.
2) Do not route the DXP/DXN lines next to the deflection
coils of a CRT. Also, do not route the traces across a
fast memory bus, which can easily introduce +30°C
error, even with good filtering. Otherwise, most noise
sources are fairly benign.
19
相关PDF资料 |
PDF描述 |
|---|---|
| VJ1206A150JBBAT4X | CAP CER 15PF 100V 5% NP0 1206 |
| MAX6648YMUA+T | IC SENSOR REMOTE SMBUS 8UMAX |
| VJ1206A150JBCAT4X | CAP CER 15PF 200V 5% NP0 1206 |
| 1140-221K-RC | CHOKE RF HI CURR 220UH 10% RAD |
| LT3755EMSE-2#TRPBF | IC LED DRVR HP CONS CURR 16-MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX663C/D | 功能描述:低压差稳压器 - LDO RoHS:否 制造商:Texas Instruments 最大输入电压:36 V 输出电压:1.4 V to 20.5 V 回动电压（最大值）:307 mV 输出电流:1 A 负载调节:0.3 % 输出端数量: 输出类型:Fixed 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-20 |
| MAX663CJA | 功能描述:低压差稳压器 - LDO RoHS:否 制造商:Texas Instruments 最大输入电压:36 V 输出电压:1.4 V to 20.5 V 回动电压（最大值）:307 mV 输出电流:1 A 负载调节:0.3 % 输出端数量: 输出类型:Fixed 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-20 |
| MAX663CPA | 功能描述:低压差稳压器 - LDO 5V Prog uPower Voltage Regulator RoHS:否 制造商:Texas Instruments 最大输入电压:36 V 输出电压:1.4 V to 20.5 V 回动电压（最大值）:307 mV 输出电流:1 A 负载调节:0.3 % 输出端数量: 输出类型:Fixed 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-20 |
| MAX663CPA+ | 功能描述:低压差稳压器 - LDO 5V Prog uPower Voltage Regulator RoHS:否 制造商:Texas Instruments 最大输入电压:36 V 输出电压:1.4 V to 20.5 V 回动电压（最大值）:307 mV 输出电流:1 A 负载调节:0.3 % 输出端数量: 输出类型:Fixed 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-20 |
| MAX663CSA | 功能描述:低压差稳压器 - LDO 5V Prog uPower Voltage Regulator RoHS:否 制造商:Texas Instruments 最大输入电压:36 V 输出电压:1.4 V to 20.5 V 回动电压（最大值）:307 mV 输出电流:1 A 负载调节:0.3 % 输出端数量: 输出类型:Fixed 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-20 |
发布紧急采购，3分钟左右您将得到回复。