- 您现在的位置：买卖IC网 > PDF目录20165 > MAX6957ATL+T (Maxim Integrated)IC DRVR DSPL LED 40-TQFN PDF资料下载
参数资料
| 型号： | MAX6957ATL+T |
| 厂商： | Maxim Integrated |
| 文件页数： | 7/25页 |
| 文件大小： | 0K |
| 描述： | IC DRVR DSPL LED 40-TQFN |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 2,500 |
| 显示器类型： | LED |
| 配置： | 7、16、20 段 |
| 接口： | 4 线串行 |
| 电流 - 电源： | 180µA |
| 电源电压： | 2.5 V ~ 5.5 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 40-WFQFN 裸露焊盘 |
| 供应商设备封装： | 40-TQFN-EP（6x6） |
| 包装： | 带卷 (TR) |
4-Wire-Interfaced, 2.5V to 5.5V, 20-Port and
28-Port LED Display Driver and I/O Expander
P4 TO P31
INTENSITY
TEST
CONFIGURATION
INTENSITY REGISTERS
TEST REGISTER
PORT REGISTERS
MASK REGISTER
LED DRIVERS
OR GPIO
LED DRIVERS AND GPIO
PORT CHANGE
DETECTOR
CONFIGURATION
REGISTERS
R/W
DATA
CE
8
SEGMENT OR
GPIO DATA
R/W
8
COMMAND
REGISTER DECODE
8
DATA BYTE
COMMAND BYTE
8
CS
D0
D1
D2
D3
D4
D5
D6
D7
D8
D9
D10
D11
D12
D13
D14
D15
DIN
D0
D1
D2
D3
D4
D5
D6
D7
D8
D9
D10
D11
D12
D13
D14
D15
DOUT
SCLK
Figure 1. MAX6957 Functional Diagram
Shutdown
When the MAX6957 is in shutdown mode, all ports are
forced to inputs, and the pullup current sources are
turned off. Data in the port and control registers remain
unaltered so port configuration and output levels are
restored when the MAX6957 is taken out of shutdown.
The display driver can still be programmed while in
shutdown mode. For minimum supply current in shut-
down mode, logic inputs should be at GND or V+
potential. Shutdown mode is exited by setting the S bit
in the configuration register (Table 6). Shutdown mode
is temporarily overridden by the display test function.
Serial Interface
The MAX6957 communicates through an SPI-compati-
ble 4-wire serial interface. The interface has three
inputs, Clock (SCLK), Chip Select ( CS ), and Data In
(DIN), and one output, Data Out (DOUT). CS must be
low to clock data into or out of the device, and DIN
must be stable when sampled on the rising edge of
SCLK. DOUT provides a copy of the bit that was input
15.5 clocks earlier, or upon a query it outputs internal
register data, and is stable on the rising edge of SCLK.
Note that the SPI protocol expects DOUT to be high
impedance when the MAX6957 is not being
accessed; DOUT on the MAX6957 is never high
impedance. Go to www.maxim-ic.com/an1879 for
ways to convert DOUT to tri-state, if required.
SCLK and DIN may be used to transmit data to other
peripherals, so the MAX6957 ignores all activity on
SCLK and DIN except between the fall and subsequent
rise of CS.
_______________________________________________________________________________________
7
相关PDF资料 |
PDF描述 |
|---|---|
| IDT71V424YL15PH | IC SRAM 4MBIT 15NS 44TSOP |
| T95R337M016CSSL | CAP TANT 330UF 16V 20% 2824 |
| VI-24V-EV-F3 | CONVERTER MOD DC/DC 5.8V 150W |
| T95R337K016CSSL | CAP TANT 330UF 16V 10% 2824 |
| GSA43DTAN | CONN EDGECARD 86POS R/A .125 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX6958AAEE | 功能描述:LED显示驱动器 3-5.5V 4-Digit 9-Seg LED Display Driver RoHS:否 制造商:Micrel 数位数量:5 片段数量: 安装风格:SMD/SMT 封装 / 箱体:PLCC-44 工作电源电压:4.75 V to 11 V 最大电源电流:10 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装:Tube |
| MAX6958AAEE+ | 功能描述:LED显示驱动器 3-5.5V 4-Digit 9-Seg LED Display Driver RoHS:否 制造商:Micrel 数位数量:5 片段数量: 安装风格:SMD/SMT 封装 / 箱体:PLCC-44 工作电源电压:4.75 V to 11 V 最大电源电流:10 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装:Tube |
| MAX6958AAEE+T | 功能描述:LED显示驱动器 3-5.5V 4-Digit 9-Seg LED Display Driver RoHS:否 制造商:Micrel 数位数量:5 片段数量: 安装风格:SMD/SMT 封装 / 箱体:PLCC-44 工作电源电压:4.75 V to 11 V 最大电源电流:10 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装:Tube |
| MAX6958AAEE-T | 功能描述:LED显示驱动器 3-5.5V 4-Digit 9-Seg LED Display Driver RoHS:否 制造商:Micrel 数位数量:5 片段数量: 安装风格:SMD/SMT 封装 / 箱体:PLCC-44 工作电源电压:4.75 V to 11 V 最大电源电流:10 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装:Tube |
| MAX6958AAPE | 功能描述:LED显示驱动器 RoHS:否 制造商:Micrel 数位数量:5 片段数量: 安装风格:SMD/SMT 封装 / 箱体:PLCC-44 工作电源电压:4.75 V to 11 V 最大电源电流:10 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。