- 您现在的位置：买卖IC网 > PDF目录1846 > MAX724CCK (Maxim Integrated Products)IC REG MULTI CONFIG ADJ TO220-5 PDF资料下载
参数资料
| 型号： | MAX724CCK |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 11/13页 |
| 文件大小： | 0K |
| 描述： | IC REG MULTI CONFIG ADJ TO220-5 |
| 标准包装： | 50 |
| 类型： | 降压（降压），升压（升压），反相，回扫 |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 2.5 V ~ 35 V |
| 输入电压： | 8 V ~ 40 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 100kHz |
| 电流 - 输出： | 5A |
| 同步整流器： | 无 |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | 通孔 |
| 封装/外壳： | TO-220-5 |
| 包装： | 管件 |
| 供应商设备封装： | TO-220-5 |
5A/2A Step-Down, PWM,
Switch-Mode DC-DC Regulators
Compensation Network
A V(DC) = g M (400k ? ) ≈ 2000
f POLE = 1/[2 π (400k ? )]C C
-A V(MID) = g M / (2 π f C C )
A series RC network connected from V C to ground
compensates the MAX724/MAX726. Compensation
R C values are shown in the applications circuits. R C
and C C shape error-amplifier gain as follows: At DC,
R C and C C have no effect, so the error-amplifier's
gain is the product of its transconductance (approxi-
mately 5000 μ mhos) and an internal 400k ? load
90° PHASE SHIFT
f ZERO = 1 / (2 π R C C C )
A V(HI) = g M R C
FREQUENCY
impedance (r INT ) at V C . So at DC, A V(DC) = g M (r INT ) =
approximately 2000 μ mhos. R C and C C then add a
low-frequency pole and a high-frequency zero, as
shown in Figure 5.
Output Overshoot
The MAX724/MAX726 error-amplifier design minimizes
overshoot, but precautions against overshoot should
still be exercised in sensitive applications. Worst-case
overshoot typically occurs when recovering from an
Figure 5. Error-Amplifier Gain as Set by R C and C C at V C Pin
FEEDBACK RESISTOR
L F
TO LOAD
output short because V C slews down from its highest
voltage. This can be checked by simply shorting and
releasing the output.
Reduce objectional overshoot by increasing the com-
pensation resistor (to 3k ? or 4k ? ) at V C . This allows
the error-amplifier output, V C , to move more rapidly in
the negative direction. In some cases, loop stability
may suffer with a high-value compensation resistor. An
option, then, is to add output filter capacitance, which
reduces short-circuit recovery overshoot by limiting out-
MAIN FILTER CAP
C F
put rise time. Lowering the compensation capacitor to
below 0.05 μ F may also help by allowing V C to slew fur-
ther before the output rises too far.
Optional Output Filters
Though not shown in the application circuits in Figures
2, 7, and 8, additional filtering can easily be added to
Figure 6. Optional LC Output Filter
0.2 μ s would be needed to provide a narrow enough
duty cycle that could control current when the output is
shorted. Since 0.6 μ s is too long (at 100kHz), the f OSC
is lowered to 20kHz once FB (and hence the output)
drops below about 1.3V (see Frequency vs. V FB Voltage
graph in the Typical Operating Characteristics). This
way, the MAX724/MAX726's 0.6 μ s minimum t ON allows
a sufficiently small duty cycle (at the reduced f OSC ) so
that current can still be limited.
reduce output ripple to levels below 2%. It is more
effective to add an LC type filter rather than additional
output capacitance alone. A small-value inductor (2 μ H
to 10 μ H) and between 47 μ F and 220 μ F of filter capaci-
tance should suffice (Figure 6). Although the inductor
does not need to be of high quality (it is not switching),
it must still be rated for the full load current.
When an LC filter is added, do not move the connection
of the feedback resistor to the LC output. It should be left
connected to the main output filter capacitor (C1 in Figure
2). If the feedback connection is moved to the LC filter
point, the added phase shift may impact stability.
10
______________________________________________________________________________________
相关PDF资料 |
PDF描述 |
|---|---|
| MAX731CWE+T | IC REG BOOST 5V 0.2A 16SOIC |
| MAX732EWE+T | IC REG BOOST 12V 0.2A 16SOIC |
| MAX732EWE | IC REG BOOST 12V 0.2A 16SOIC |
| MAX734CSA-T | IC PROG SUPP FLASH MEM 12V 8SOIC |
| MAX738ACWE+ | IC REG BUCK 5V 0.75A 16SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX724CCM | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Current-Mode SMPS Controller |
| MAX724CKS | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Current-Mode SMPS Controller |
| MAX724ECK | 功能描述:直流/直流开关调节器 RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| MAX724ECK-SL | 功能描述:直流/直流开关调节器 RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| MAX724ECM | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Current-Mode SMPS Controller |
发布紧急采购，3分钟左右您将得到回复。