- 您现在的位置：买卖IC网 > PDF目录5066 > MAX845EUA (Maxim Integrated Products)IC DRVR XFRMR CMOS PCMCIA 8UMAX PDF资料下载
参数资料
| 型号： | MAX845EUA |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 6/16页 |
| 文件大小： | 0K |
| 描述： | IC DRVR XFRMR CMOS PCMCIA 8UMAX |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 50 |
| 应用： | 变压器驱动器，PCMCIA |
| 输入电压： | 3.3V，5V |
| 输出数： | 1 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-TSSOP，8-MSOP（0.118"，3.00mm 宽） |
| 供应商设备封装： | 8-uMAX |
| 包装： | 管件 |
Isolated Transformer Driver
for PCMCIA Applications
V IN
5V
C1
0.1μF
0.01μF
1N4148
1N4148
3.3V
SUPPLY
ON / OFF
4
SD
6
V CC
D1
1
MBR0520
1CT : 1.3CT
5V @ 150mA
ISO OUTPUT
C2
0.33μF
6
V CC
D1
1
MAX845
MAX845
FREQUENCY
SELECT
3
FS
GND1 GND2
2 7
D2
8
MBR0520
ISO
GND
GND1
D2
GND2
8
2
7
SEE FIGURE 11
FOR RECTIFIER
CONFIGURATIONS
Figure 3. 5V to Isolated 5V Application Circuit
The MAX845 is a versatile transformer driver, capable
of driving a center-tapped transformer primary from a
5V or 3.3V DC power supply (Figures 3 and 4). The
secondary can be wound to provide any isolated volt-
age needed at power levels up to 750mW with a 5V
supply or up to 500mW with a 3.3V supply. Figure 3
shows a typical 5V to isolated 5V application circuit that
delivers up to 150mA of isolated 5V power.
3.3V Supply
Any of the application circuits shown may be converted
to 3.3V operation by changing the turns ratio of the trans-
former and operating the MAX845 from a boost supply,
as shown in Figure 4. In normal operation, whenever one
of the MAX845 outputs goes low, the other goes to
approximately double the supply voltage. Since the cir-
cuit is symmetrical, the two outputs can be combined
with diodes, lightly filtered, then used to power the
MAX845, and possibly other light loads as well.
The diodes on the primary side may be any fast-switch-
ing small-signal diodes, such as the 1N914, 1N4148, or
CMPD2838. The value of the primary filter capacitor is
not critical and can be very small, since it only needs to
supply current to the MAX845 during the break-before-
make interval.
The transformer could be any of the same ones used for
5V operation, but for optimum performance it should
have fewer primary turns, as the ET product required is
now only 3.3V-μs. For a given power level, the currents
Figure 4. 3.3V Input to Isolated Output Application Circuit
will be higher at 3.3V, so transformer winding resistance
will be more critical and efficiencies will be lower. The
MAX845 output current must still be limited to 200mA
(see Absolute Maximum Ratings), so the available out-
put power will be less than with a 5V power source.
Low-Noise Power Supply
The MAX845 topology is inherently low noise, in that
either one or the other of the two power devices is on at
any given time. By alternating between two identical
states with one side on and the other off, the input cur-
rent is nearly constant and secondary output power is
available at all times. There is an intentional break-
before-make action to prevent any possibility of both
power switches conducting at the same time. During
this 100ns non-overlap interval, the input current goes
to zero. This adds a small high-frequency component
to the input current waveform. This ripple current can
easily be absorbed by a small input bypass capacitor
(0.33μF) from V CC to ground. Figure 5 shows a low-
noise bias supply using the MAX845 transformer driver.
When using the two-diode push-pull (Figure 11a)
rectifier or the four-diode bridge (Figure 11b), the out-
put voltage tends to be more constant than in most
alternative topologies. As described above, the circuit
alternates between two identical states that both pro-
vide power to the load. The only part of the cycle that
produces output ripple is the 100ns non-overlap inter-
val, which can easily be filtered by a small ceramic
output capacitor (0.33μF).
6
_______________________________________________________________________________________
相关PDF资料 |
PDF描述 |
|---|---|
| GCC70DCST-S288 | CONN EDGECARD 140POS .100 EXTEND |
| X5328S8I-2.7T1 | IC SUPERVISOR CPU 32K EE 8-SOIC |
| HCC36DRYH | CONN EDGECARD 72POS DIP .100 SLD |
| X5328S8I-2.7A | IC SUPERVISOR CPU 32K EE 8-SOIC |
| MAX845EUA-T | IC DRVR XFRMR CMOS PCMCIA 8UMAX |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX845EUA+ | 功能描述:功率驱动器IC Isolated Transformer Driver for PCMCIA RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube |
| MAX845EUA+T | 功能描述:功率驱动器IC Isolated Transformer Driver for PCMCIA RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube |
| MAX845EUA-LF | 制造商:Maxim Integrated Products 功能描述:- Rail/Tube |
| MAX845EUA-T | 功能描述:功率驱动器IC RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube |
| MAX845EVKIT-MM | 功能描述:功率驱动器IC Evaluation Kit for the MAX845 RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。