- 您现在的位置：买卖IC网 > PDF目录2091 > MAX9720AEUE+T (Maxim Integrated Products)IC AMP AUDIO .05W STER 16TSSOP PDF资料下载
参数资料
| 型号： | MAX9720AEUE+T |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 5/21页 |
| 文件大小： | 0K |
| 描述： | IC AMP AUDIO .05W STER 16TSSOP |
| 标准包装： | 2,500 |
| 系列： | DirectDrive®, SmartSense™ |
| 类型： | AB 类 |
| 输出类型： | 耳机，2-通道（立体声） |
| 在某负载时最大输出功率 x 通道数量： | 50mW x 2 @ 32 欧姆 |
| 电源电压： | 1.8 V ~ 3.6 V |
| 特点： | 消除爆音，短路保护和热保护，关闭 |
| 安装类型： | 表面贴装 |
| 供应商设备封装： | 16-TSSOP |
| 封装/外壳： | 16-TSSOP（0.173"，4.40mm 宽） |
| 包装： | 带卷 (TR) |
Mode Selection (MODE_)
SmartSense is controlled by the two mode select
inputs, MODE1 and MODE2. Table 1 shows the operat-
ing modes in relation to the status of the MODE_ inputs.
When MODE1 = MODE2 = low, the device is in low-
power shutdown mode. When MODE1 = high and
MODE2 = low, the device is in forced mono mode. The
right channel is disabled, OUTR goes high impedance,
and the stereo audio input is mixed, and the audio sig-
nal is reproduced on OUTL. SmartSense is disabled in
this mode. When MODE1 = low and MODE2 = high, the
device is in forced stereo mode, and SmartSense is
disabled. When the device detects the presence of a
short BEFORE forced stereo mode is selected, the
device remains in mono mode (Figure 5). When
MODE1 = MODE2 = high, the device is in automatic
detection mode; the operating mode of the device is
determined by SmartSense.
MODE1 is also used to execute a host-controlled
SmartSense routine and reset the ALERT output. On the
rising edge of MODE1, the device invokes a
SmartSense routine. The falling edge of MODE1 resets
the ALERT output to its idle state.
Automatic Detection Mode
A fault condition is defined as a short (under 4
) on
either amplifier output to ground. SmartSense automati-
cally detects and disables the shorted output. The
mixer/attenuator combines the two stereo inputs (INL
and INR), attenuates the resultant signal by a factor of
2, and redirects the audio playback to the remaining
active channel. This allows for full reproduction of a
stereo signal through a single headphone while main-
taining optimum headroom. The mixed mono signal is
output only on the properly loaded channel. If both out-
puts are shorted then both outputs go into a high-
impedance state and no audio playback occurs. In
automatic detection mode (MODE1 = MODE2 = high),
any of the following events trigger a SmartSense test
sequence:
HPS rises above 0.8 x VDD, indicating a headphone
jack has been inserted into the socket.
The 180mA high-side (sourcing) overcurrent thresh-
old is approached, and the output is near GND.
The die temperature exceeds the thermal limit
(+140°C).
Power or shutdown is cycled.
MAX9720
50mW, DirectDrive, Stereo Headphone
Amplifier with SmartSense and Shutdown
______________________________________________________________________________________
13
M1 = L
M2 = L
?
M1 = H
M2 = L
?
M1 = L
M2 = H
?
SHORT
DETECTED
?
STATUS
CHANGE
?
SHDN
SmartSense
FORCED MONO
FORCED STEREO
MONO MODE
STATUS
CHANGE
?
STATUS
CHANGE
?
STATUS
CHANGE
?
STEREO MODE
STATUS
CHANGE
?
N
Y
MAX9720
Figure 5. SmartSense Flow Diagram
MODE1
MODE2
SmartSense
OPERATING
MODE
High
Enabled
Automatic
detection mode
Low
Disabled
Shutdown
High
Low
Disabled
Forced left mono
Low
High
Disabled
Forced stereo
High
Enabled
Host controlled
X
—
Reset ALERT
Table 1. MAX9720 Operating Modes
相关PDF资料 |
PDF描述 |
|---|---|
| MAX97220DETE+ | IC AUDIO AMP HEADPHONE 16TQFN |
| MAX9722AETE+G | IC AMP AUDIO .13W STER AB 16TQFN |
| MAX9723CETE+ | IC AMP AUDIO .06W STER AB 16TQFN |
| MAX9724AEUD+ | IC AMP AUDIO .045W STER 14TSSOP |
| MAX9724DETC+ | IC AMP AUDIO .063W STER 12TQFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX9720BEBE | 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述: |
| MAX9720BEBE+ | 制造商:Maxim Integrated Products 功能描述:AUD AMP HDPH 2CH STEREO 0.05W CLS-AB 16UCSP - Rail/Tube |
| MAX9720BEBE+T | 功能描述:音频放大器 50mW DirectDrive Headphone Amplifier RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel |
| MAX9720BEBE-T | 功能描述:音频放大器 RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel |
| MAX9720BEUE | 制造商:Maxim Integrated Products 功能描述:50MW, DIRECTDRIVE, STEREO HEADPHONE AMPLIFIER - Rail/Tube |
发布紧急采购，3分钟左右您将得到回复。