- 您现在的位置：买卖IC网 > PDF目录10260 > MAX9767ETJ+ (Maxim Integrated Products)IC AMP AUDIO .75W STER AB 32TQFN PDF资料下载
参数资料
| 型号： | MAX9767ETJ+ |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 10/33页 |
| 文件大小： | 0K |
| 描述： | IC AMP AUDIO .75W STER AB 32TQFN |
| 标准包装： | 60 |
| 类型： | AB 类 |
| 输出类型： | 2 通道（立体声） |
| 在某负载时最大输出功率 x 通道数量： | 750mW x 2 @ 4 欧姆 |
| 电源电压： | 2.7 V ~ 5.5 V |
| 特点： | 消除爆音，麦克风，静音，短路保护和热保护，关机 |
| 安装类型： | 表面贴装 |
| 供应商设备封装： | 32-TQFN-EP（5x5） |
| 封装/外壳： | 32-WFQFN 裸露焊盘 |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页
MAX9765/MAX9766/MAX9767
750mW Audio Amplifiers with Headphone Amp,
Microphone Preamp, and Input Mux
18
______________________________________________________________________________________
mode, this waveform shapes the frequency spectrum,
minimizing the amount of audible components present
at the headphone. In speaker mode, the BTL amplifiers
start up in the same fashion as in headphone mode.
When entering shutdown, both amplifier outputs ramp
to GND quickly and simultaneously. The devices can
also be connected to a standby power source that
ensures that the device undergoes its full shutdown
cycle even after power has been removed. The value of
the capacitor on the BIAS pin affects the click-and-pop
energy. For optimum click/pop performance, use a 1F
capacitor.
Standby Power Supply (SVDD)
The MAX9765/MAX9766/MAX9767 feature a system
that provides clickless power-down when power is
removed from the device. SVDD is an optional sec-
ondary supply that powers the device through its shut-
down cycle when VDD is removed. During this cycle,
the amplifier output DC level slowly ramps to GND,
ensuring clickless power-down. If clickless power-down
is required, connect SVDD to either a secondary power
supply that is always on, or connect a reservoir capaci-
tor from SVDD to GND. SVDD does not need to be con-
nected to either a secondary power supply or reservoir
capacitor for normal device operation. If click-and-pop
suppression during power-down is not required, con-
nect SVDD to VDD directly.
The clickless power-down cycle only occurs when the
device is in headphone mode. The speaker mode is
inherently clickless, the differential architecture cancels
the DC shift across the speaker. The MAX9765/
MAX9766/MAX9767 BTL outputs are pulled to GND
quickly and simultaneously, resulting in no audible
components. If the MAX9765/MAX9766/MAX9767 are
only used as speaker amplifiers, then reservoir capaci-
tors or secondary supplies are not necessary.
When using a reservoir capacitor, a 220F capacitor
provides optimum charge storage for the shutdown
cycle for all conditions. If a smaller reservoir capacitor
is desired, decrease the size of CBIAS. A smaller CBIAS
causes the output DC level to decay at a faster rate,
increasing the audible content at the speaker, but
reducing the duration of the shutdown cycle.
Digital Interface
The MAX9765/MAX9766 feature an I2C/SMBus-compat-
ible 2-wire serial interface consisting of a serial data
line (SDA) and a serial clock line (SCL). SDA and SCL
facilitate bidirectional communication between the
MAX9765/MAX9766 and the master at clock rates up to
400kHz. Figure 3 shows the 2-wire interface timing dia-
gram. The MAX9765/MAX9766 are transmit/receive
slave-only devices, relying upon a master to generate a
clock signal. The master (typically a microcontroller) ini-
tiates data transfer on the bus and generates SCL to
permit that transfer.
A master device communicates to the MAX9765/
MAX9766 by transmitting the proper address followed
by a command and/or data words. Each transmit
sequence is framed by a START (S) or REPEATED
START (Sr) condition and a STOP (P) condition. Each
word transmitted over the bus is 8 bits long and is
always followed by an acknowledge clock pulse.
The MAX9765/MAX9766 SDA and SCL amplifiers are
open-drain outputs requiring a pullup resistor to gener-
ate a logic-high voltage. Series resistors in line with
SDA and SCL are optional. These series resistors pro-
tect the input stages of the devices from high-voltage
spikes on the bus lines, and minimize crosstalk and
undershoot of the bus signals.
Bit Transfer
One data bit is transferred during each SCL clock
cycle. The data on SDA must remain stable during the
high period of the SCL clock pulse. Changes in SDA
while SCL is high are control signals (see the START
and STOP Conditions section). SDA and SCL idle high
when the I2C bus is not busy.
START and STOP Conditions
When the serial interface is inactive, SDA and SCL idle
high. A master device initiates communication by issu-
ing a START condition. A START condition is a high-to-
low transition on SDA with SCL high. A STOP condition
is a low-to-high transition on SDA while SCL is high
(Figure 4). A START condition from the master signals
the beginning of a transmission to the MAX9765/
MAX9766. The master terminates transmission by issu-
ing the STOP condition; this frees the bus. If a REPEAT-
ED START condition is generated instead of a STOP
MAX9765
MAX9766
R1
680k
Ω
R2
10k
Ω
HPS
OUTL+
OUTR+
R3
47k
Ω
3V
10k
Ω
Figure 2. HPS Configuration Circuit
相关PDF资料 |
PDF描述 |
|---|---|
| MS27468E11F98P | CONN RCPT 6POS JAM NUT W/PINS |
| MAX4367ETA+T | IC AMP AUDIO PWR .33W MONO 8TDFN |
| MS27505E11F13PA | CONN RCPT 13POS BOX MNT W/PINS |
| LTC1407ACMSE-1#TRPBF | IC ADC 14BIT 3MSPS SAMPLE 10MSOP |
| MAX9762ETI+T | IC AMP AUDIO PWR 3W MONO 28TQFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX9767ETJ+ | 功能描述:音频放大器 Integrated Circuits (ICs) RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel |
| MAX9767ETJ+T | 功能描述:音频放大器 Integrated Circuits (ICs) RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel |
| MAX9767ETJ-T | 功能描述:音频放大器 RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel |
| MAX9768BETG+ | 功能描述:音频放大器 10W Mono Class D Speaker RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel |
| MAX9768BETG+T | 功能描述:音频放大器 10W Mono Class D Speaker RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。