- 您现在的位置：买卖IC网 > PDF目录2092 > MAX9875ERP+T (Maxim Integrated Products)IC AUDIO SUBSYSTEM 20UCSP PDF资料下载
参数资料
| 型号： | MAX9875ERP+T |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 9/30页 |
| 文件大小： | 0K |
| 描述： | IC AUDIO SUBSYSTEM 20UCSP |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 2,500 |
| 系列： | DirectDrive® |
| 类型： | D 类 |
| 输出类型： | 1-通道（单声道），带立体声耳机 |
| 在某负载时最大输出功率 x 通道数量： | 825mW x 1 @ 4 欧姆; 53mW x 2 @ 16 欧姆 |
| 电源电压： | 2.7 V ~ 5.25 V |
| 特点： | 消除爆音，差分输入，I²C，静音，短路和热保护，关机，音量控制 |
| 安装类型： | 表面贴装 |
| 供应商设备封装： | 20-UCSP |
| 封装/外壳： | 20-WFBGA，CSPBGA |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页当前第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页
MAX9875
Low RF Susceptibility, Mono Audio
Subsystem with DirectDrive Headphone Amplifier
______________________________________________________________________________________
17
Volume Control and Mute
The MAX9875 features three volume control registers
(see Table 4) allowing independent volume control of
mono speaker and stereo headphone amplifier outputs.
Each volume control register has 31 steps providing 0 to
75dB (typ) of attenuation and a mute function.
Class D Speaker Amplifier
The MAX9875 integrates a filterless Class D amplifier
that offers much higher efficiency than Class AB with-
out the typical disadvantages.
The high efficiency of a Class D amplifier is due to the
switching operation of the output stage transistors. In a
Class D amplifier, the output transistors act as current-
steering switches and consume negligible additional
power. Any power loss associated with the Class D out-
put stage is mostly due to the I2R loss of the MOSFET
on-resistance, and quiescent current overhead.
The theoretical best efficiency of a linear amplifier is
78%, however, that efficiency is only exhibited at peak
output power. Under normal operating levels (typical
music reproduction levels), efficiency falls below 30%,
whereas the MAX9875 still exhibits 70% efficiency
under the same conditions (Figure 3).
Ultra-Low EMI Filterless Output Stage
In traditional Class D amplifiers, the high dV/dt of the
rising and falling edge transitions results in increased
EMI emissions, which requires the use of external LC
filters or shielding to meet EN55022 electromagnetic-
interference (EMI) regulation standards. Limiting the
dV/dt normally results in decreased efficiency. Maxim’s
active emissions limiting circuitry actively limits the
dV/dt of the rising and falling edge transitions, provid-
ing reduced EMI emissions, while maintaining up to
87% efficiency.
In addition to active emission limiting, the MAX9875
features a spread-spectrum modulation mode that flat-
tens the wideband spectral components. Proprietary
techniques ensure that the cycle-to-cycle variation of
the switching period does not degrade audio reproduc-
tion or efficiency (see the
Typical Operating
Characteristics). Select spread-spectrum modulation
mode through the I2C interface (Table 6). In spread-
spectrum modulation mode, the switching frequency
varies randomly by ±60kHz around the center frequen-
cy (1.176MHz). The effect is to reduce the peak energy
at harmonics of the switching frequency. Above
10MHz, the wideband spectrum looks like white noise
for EMI purposes (see Figure 4).
Speaker Current Limit
Most applications will not enter current limit unless the
output is short circuited or connected incorrectly.
When the output current of the speaker amplifier
exceeds the current limit (1.5A, typ) the MAX9875 dis-
ables the outputs for approximately 250s. At the end of
250s, the outputs are re-enabled, if the fault condition
still exists, the MAX9875 will continue to disable and re-
enable the outputs until the fault condition is removed.
MAX9875 EFFICIENCY
vs. IDEAL CLASS EFFICIENCY
MAX9875
fig03
OUTPUT POWER (W)
EFFICIENCY
(%)
0.75
0.50
0.25
10
20
30
40
50
60
70
80
90
100
0
1.00
MAX9875
IDEAL CLASS AB
VDD = VPVDD = 3.7V (MAX9875)
VSUPPLY = 3.7V (IDEAL CLASS AB)
Figure 3. MAX9875 Efficiency vs. Class AB Efficiency
相关PDF资料 |
PDF描述 |
|---|---|
| MAX9877AERP+T | IC SUBSYSTEM MONO AUD 20MAXFILM |
| MAX9877EWP+TG45 | IC AUDIO SUBSYSTEM 20-WLP |
| MAX9879ERV+T | IC AUDIO SUBSYSTEM 30-UCSP |
| MAX987EUK-T | IC COMP MICRPWR R-R I/O SOT23-5 |
| MAX9888EWY+T | IC CODEC AUDIO FLEXSOUND 63WLP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX9877AERP+T | 功能描述:音频放大器 Audio Subsystem w/DirectDrive RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel |
| MAX9877AEWP+G45 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述: |
| MAX9877AEWP+TG45 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述: |
| MAX9877EBP+G45 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述: |
| MAX9877EBP+TG45 | 制造商:Maxim Integrated Products 功能描述: |
发布紧急采购，3分钟左右您将得到回复。