- 您现在的位置：买卖IC网 > PDF目录45191 > MB90F362SPMT 16-BIT, FLASH, 24 MHz, MICROCONTROLLER, PQFP48 PDF资料下载
参数资料
| 型号： | MB90F362SPMT |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 16-BIT, FLASH, 24 MHz, MICROCONTROLLER, PQFP48 |
| 封装： | PLASTIC, LQFP-48 |
| 文件页数： | 7/59页 |
| 文件大小： | 623K |
| 代理商： | MB90F362SPMT |
第1页第2页第3页第4页第5页第6页当前第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页
MB90360 Series
15
10. Connection of unused pins of A/D converter if A/D converter is used
Connect unused pins of A/D converter to AVCC
= VCC, AVSS = AVR = VSS.
11. Notes on energization
To prevent the internal regulator circuit from malfunctioning, set the voltage rise time during energization at
50
s or more (0.2 V to 2.7 V)
12. Stabilization of power supply voltage
A sudden change in the power supply voltage may cause the device to malfunction even within the specified
VCC power supply voltage operating guarantee range. Therefore, the VCC power supply voltage should be stabi-
lized.
For reference, the power supply voltage should be controlled so that VCC ripple variations (peak-to-peak value)
at commercial frequencies (50 Hz to 60 Hz) fall below 10
% of the standard VCC power supply voltage and the
coefficient of transient fluctuation does not exceed 0.1 V/ms at instantaneous power switching.
13. Initialization
In the device, there are internal registers which are initialized only by a power-on reset. To initialize these registers,
turn on the power again.
14. Notes on using CAN function
To use CAN function, please set ’1’ to DIRECT bit of CAN direct mode register (CDMR) .
If DIRECT bit is set to ’0’ (initial value) , wait states will be performed when accessing CAN registers.
Note : Please refer to Hardware Manual of MB90360 series for detail of CAN Direct Mode Register.
15. Flash security function
The security bit is located in the area of the flash memory.
If protection code 01H is written in the security bit, the flash memory is in the protected state by security.
Therefore, please do not write 01H in this address if you do not use the security function.
Please refer to following table for the address of the security bit.
16. Correspondence with
+105 °C or more
If used exceeding TA
= +105 °C, please contact Fujitsu for reliability limitations.
Flash memory size
Address for security bit
MB90F362
MB90F362S
MB90F362T
MB90F362TS
MB90F367
MB90F367S
MB90F367T
MB90F367TS
Embedded 512 Kbit Flash Memory
FF0001H
相关PDF资料 |
PDF描述 |
|---|---|
| MB90F395HPMT | 16-BIT, FLASH, 24 MHz, MICROCONTROLLER, PQFP120 |
| MB90F428GAPFV | 16-BIT, FLASH, 16 MHz, MICROCONTROLLER, PQFP100 |
| MB90428GBPF | 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP100 |
| MB90428GCPF | 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP100 |
| MB90427GCPFV | 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP100 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MB90F362TESPMCRGE1 | 制造商:FUJI 功能描述:Pb Free |
| MB90F362TESPMCR-GE1 | 制造商:FUJITSU 功能描述:MCU 16BIT 16LX 64K FLASH 48LQFP 制造商:FUJITSU 功能描述:MCU, 16BIT, 16LX, 64K FLASH, 48LQFP, Controller Family/Series:F2MC-16LX, Core Si |
| MB90F362TESPMCR-G-JNE1 | 制造商:FUJITSU 功能描述: |
| MB90F362TESPMCR-GN9E1 | 功能描述:IC MCU 16BIT 制造商:cypress semiconductor corp 系列:F2MC-16LX MB90360E 零件状态:在售 核心处理器:F2MC-16LX 核心尺寸:16-位 速度:24MHz 连接性:CAN，LIN，UART/USART 外设:DMA，POR，WDT I/O 数:36 程序存储容量:64KB（64K x 8） 程序存储器类型:闪存 EEPROM 容量:- RAM 容量:3K x 8 电压 - 电源（Vcc/Vdd）:3 V ~ 5.5 V 数据转换器:A/D 16x8/10b 振荡器类型:外部 工作温度:-40°C ~ 105°C（TA） 标准包装:250 |
| MB90F367TPMCR-GE1 | 制造商:FUJITSU 功能描述: |
发布紧急采购，3分钟左右您将得到回复。