- 您现在的位置：买卖IC网 > PDF目录80431 > MB9AF311LPMC 32-BIT, FLASH, 40 MHz, RISC MICROCONTROLLER, PQFP64 PDF资料下载
参数资料
| 型号： | MB9AF311LPMC |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 32-BIT, FLASH, 40 MHz, RISC MICROCONTROLLER, PQFP64 |
| 封装： | 0.65 MM PITCH, PLASTIC, LQFP-64 |
| 文件页数： | 99/114页 |
| 文件大小： | 1357K |
| 代理商： | MB9AF311LPMC |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页当前第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页
85
ATmega48PA/88PA/168PA [DATASHEET]
9223F–AVR–04/14
15.5.3 Using the Output Compare Unit
Since writing TCNT0 in any mode of operation will block all compare matches for one timer clock cycle, there are risks
involved when changing TCNT0 when using the output compare Unit, independently of whether the Timer/Counter is
running or not. If the value written to TCNT0 equals the OCR0x value, the compare match will be missed, resulting in
incorrect waveform generation. Similarly, do not write the TCNT0 value equal to BOTTOM when the counter is
downcounting.
The setup of the OC0x should be performed before setting the data Direction register for the port pin to output. The easiest
way of setting the OC0x value is to use the force output compare (FOC0x) strobe bits in normal mode. The OC0x registers
keep their values even when changing between waveform generation modes.
Be aware that the COM0x1:0 bits are not double buffered together with the compare value. Changing the COM0x1:0 bits will
take effect immediately.
15.6
Compare Match Output Unit
The compare output mode (COM0x1:0) bits have two functions. The waveform generator uses the COM0x1:0 bits for
defining the output compare (OC0x) state at the next compare match. Also, the COM0x1:0 bits control the OC0x pin output
source. Figure 15-4 shows a simplified schematic of the logic affected by the COM0x1:0 bit setting. The I/O registers,
I/O bits, and I/O pins in the figure are shown in bold. Only the parts of the general I/O port control registers (DDR and PORT)
that are affected by the COM0x1:0 bits are shown. When referring to the OC0x state, the reference is for the internal OC0x
register, not the OC0x pin. If a system reset occur, the OC0x register is reset to “0”.
Figure 15-4. Compare Match Output Unit, Schematic
The general I/O port function is overridden by the output compare (OC0x) from the waveform generator if either of the
COM0x1:0 bits are set. However, the OC0x pin direction (input or output) is still controlled by the data direction register
(DDR) for the port pin. The data direction register bit for the OC0x pin (DDR_OC0x) must be set as output before the OC0x
value is visible on the pin. The port override function is independent of the waveform generation mode.
The design of the output compare pin logic allows initialization of the OC0x state before the output is enabled. Note that
some COM0x1:0 bit settings are reserved for certain modes of operation (see Section 15.9 “Register Description” on page
DA
T
A
BUS
0
1
Q
D
COMnx1
COMnx0
FOCn
OCnx
Waveform
Generator
Q
D
PORT
Q
D
DDR
OCnx
Pin
clkI/O
相关PDF资料 |
PDF描述 |
|---|---|
| MB9AF312NBGL | 32-BIT, FLASH, 40 MHz, RISC MICROCONTROLLER, PBGA112 |
| MB9BF506NBGL | 32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PBGA112 |
| MSP430G2333IRHB32 | 16-BIT, FLASH, 16 MHz, RISC MICROCONTROLLER, PQCC32 |
| M38003E6FS | 8-BIT, UVPROM, 8 MHz, MICROCONTROLLER, CQCC64 |
| M38802M2-XXXFS | 8-BIT, MROM, 8 MHz, MICROCONTROLLER, CQCC64 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MB9AF312KPMC1-G-JNE2 | 功能描述:ARM? Cortex?-M3 FM3 MB9A310K Microcontroller IC 32-Bit 40MHz 160KB (160K x 8) FLASH 52-LQFP (10x10) 制造商:cypress semiconductor corp 系列:FM3 MB9A310K 包装:托盘 零件状态:有效 核心处理器:ARM? Cortex?-M3 核心尺寸:32-位 速度:40MHz 连接性:CSIO，I2C，LIN，UART/USART，USB 外设:DMA，LVD，POR，PWM，WDT I/O 数:36 程序存储容量:160KB（160K x 8） 程序存储器类型:闪存 EEPROM 容量:- RAM 容量:16K x 8 电压 - 电源（Vcc/Vdd）:2.7 V ~ 5.5 V 数据转换器:A/D 8x12b 振荡器类型:内部 工作温度:-40°C ~ 105°C（TA） 封装/外壳:52-LQFP 供应商器件封装:52-LQFP（10x10） 标准包装:160 |
| MB9AF312KPMC-ES-E1 | 制造商:FUJITSU 功能描述: |
| MB9AF312KPMC-G-JNE1 | 制造商:FUJITSU 功能描述: |
| MB9AF312KPMC-G-JNE2 | 功能描述:ARM? Cortex?-M3 FM3 MB9A310K Microcontroller IC 32-Bit 40MHz 160KB (160K x 8) FLASH 48-LQFP (7x7) 制造商:cypress semiconductor corp 系列:FM3 MB9A310K 包装:托盘 零件状态:有效 核心处理器:ARM? Cortex?-M3 核心尺寸:32-位 速度:40MHz 连接性:CSIO，I2C，LIN，UART/USART，USB 外设:DMA，LVD，POR，PWM，WDT I/O 数:36 程序存储容量:160KB（160K x 8） 程序存储器类型:闪存 EEPROM 容量:- RAM 容量:16K x 8 电压 - 电源（Vcc/Vdd）:2.7 V ~ 5.5 V 数据转换器:A/D 8x12b 振荡器类型:内部 工作温度:-40°C ~ 105°C（TA） 封装/外壳:48-LQFP 供应商器件封装:48-LQFP（7x7） 标准包装:250 |
| MB9AF312KQN-ES-AWE2 | 制造商:FUJITSU 功能描述: |
发布紧急采购，3分钟左右您将得到回复。