- 您现在的位置：买卖IC网 > PDF目录17146 > MC33342PG (ON Semiconductor)IC CTRLR BATTERY FAST CHRG 8DIP PDF资料下载
参数资料
| 型号： | MC33342PG |
| 厂商： | ON Semiconductor |
| 文件页数： | 6/16页 |
| 文件大小： | 0K |
| 描述： | IC CTRLR BATTERY FAST CHRG 8DIP |
| 产品变化通告： | Product Obsolescence 14/Apr/2010 |
| 标准包装： | 50 |
| 功能： | 充电管理 |
| 电池化学： | 镍镉（NiCd）、镍金属氢化物（NiMH） |
| 电源电压： | 3.25 V ~ 18 V |
| 工作温度： | -25°C ~ 85°C |
| 安装类型： | 通孔 |
| 封装/外壳： | 8-DIP（0.300"，7.62mm） |
| 供应商设备封装： | 8-PDIP |
| 包装： | 管件 |
| 其它名称： | MC33342PGOS |
MC33340, MC33342
1.6
V max
? D V
70
dV
1.5
1.4
1.3
1.2
1.1
1.0
0
T max
Voltage
Temperature
Relative Pressure
40 80 120
dt
60
50
40
30
20
10
160
CHARGE INPUT PERCENT OF CAPACITY
Figure 9. Typical Charge Characteristics for NiCd and NiMh Batteries
OPERATING DESCRIPTION
The MC33340/342 starts up in the fast charge mode when
power is applied to V CC . A change to the trickle mode can
occur as a result of three possible conditions. The first is if
the V sen input voltage is above 2.0 V or below 1.0 V. Above
2.0 V indicates that the battery pack is open or disconnected,
while below 1.0 V indicates the possibility of a shorted or
defective cell. The second condition is when the
MC33340/342 detects a fully charged battery by measuring
a negative slope in battery voltage. The MC33340/342
recognize a negative voltage slope after the preset holdoff
time (t hold ) has elapsed during a fast charge cycle. This
indicates that the battery pack is fully charged. The third
condition is either due to the battery pack being out of a
programmed temperature range, or that the preset timer
period has been exceeded.
There are three conditions that will cause the controller to
return from trickle to fast charge mode. The first is if the V sen
input voltage moved to within the 1.0 to 2.0 V range from
initially being either too high or too low. The second is if the
battery pack temperature moved to within the programmed
temperature range, but only from initially being too cold.
Third is by cycling V CC off and then back on causing the
internal logic to reset. A concise description of the major
circuit blocks is given below.
Negative Slope Voltage Detection
A representative block diagram of the negative slope
voltage detector is shown in Figure 10. It includes a
Synchronous Voltage to Frequency Converter, a Sample
Timer, and a Ratchet Counter. The V sen pin is the input for
the Voltage to Frequency Converter (VFC), and it connects
to the rechargeable battery pack terminals through a
resistive voltage divider. The input has an impedance of
approximately 6.0 M W and a maximum voltage range of
?1.0 V to V CC + 0.6 V or 0 V to 10 V, whichever is lower.
The 10 V upper limit is set by an internal zener clamp that
provides protection in the event of an electrostatic discharge.
The VFC is a charge?balanced synchronous type which
generates output pulses at a rate of F V = V sen (24 kHz).
The Sample Timer circuit provides a 95 kHz system clock
signal (SCK) to the VFC. This signal synchronizes the F V
output to the other Sample Timer outputs used within the
detector. At 1.38 second intervals the V sen Gate output goes
low for a 33 ms period. This output is used to momentarily
interrupt the external charging power source so that a precise
voltage measurement can be taken. As the V sen Gate goes
low, the internal Preset control line is driven high for 11 ms.
During this time, the battery voltage at the V sen input is
allowed to stabilize and the previous F V count is preloaded.
At the Preset high?to?low transition, the Convert line goes
high for 22 ms. This gates the F V pulses into the ratchet
counter for a comparison to the preloaded count. Since the
Convert time is derived from the same clock that controls the
VFC, the number of F V pulses is independent of the clock
frequency. If the new sample has more counts than were
preloaded, it becomes the new peak count and the cycle is
repeated 1.38 seconds later. If the new sample has two fewer
counts, a less than peak voltage event has occurred, and a
register is initialized. If two successive less than peak
voltage events occur, the ? D V ‘AND’ gate output goes high
and the Fast/Trickle output is latched in a low state,
signifying that the battery pack has reached full charge
status.
http://onsemi.com
6
相关PDF资料 |
PDF描述 |
|---|---|
| 18R473C | INDUCTOR RADIAL 47UH 1.65A |
| MRJ0070DF-A | C/A MRJ21/MRJ21 GBE ANGL CMR 7M |
| EEM08DTAD-S664 | CONN EDGECARD 16POS R/A .156 SLD |
| LM3423MHBKBSTEV/NOPB | BOARD EVAL BUCK BOOST LM3423 |
| EEM06DRST-S288 | CONN EDGECARD 12POS .156 EXTEND |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MC33348D-006 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| MC33348D-2R2 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| MC33350SN-7T1 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| MC33351ADTB-001 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| MC33351DTB-001 | 制造商:ON Semiconductor 功能描述: |
发布紧急采购，3分钟左右您将得到回复。