- 您现在的位置：买卖IC网 > PDF目录17146 > MC33342PG (ON Semiconductor)IC CTRLR BATTERY FAST CHRG 8DIP PDF资料下载
参数资料
| 型号： | MC33342PG |
| 厂商： | ON Semiconductor |
| 文件页数： | 8/16页 |
| 文件大小： | 0K |
| 描述： | IC CTRLR BATTERY FAST CHRG 8DIP |
| 产品变化通告： | Product Obsolescence 14/Apr/2010 |
| 标准包装： | 50 |
| 功能： | 充电管理 |
| 电池化学： | 镍镉（NiCd）、镍金属氢化物（NiMH） |
| 电源电压： | 3.25 V ~ 18 V |
| 工作温度： | -25°C ~ 85°C |
| 安装类型： | 通孔 |
| 封装/外壳： | 8-DIP（0.300"，7.62mm） |
| 供应商设备封装： | 8-PDIP |
| 包装： | 管件 |
| 其它名称： | MC33342PGOS |
MC33340, MC33342
switching between the fast and trickle modes as the lower
temperature limit is crossed. The amount of temperature rise
to overcome the hysteresis is determined by the thermistor’s
rate of resistance change or sensitivity at the under
temperature trip point. The required resistance change is:
by removing and reconnecting the battery pack or by cycling
the power supply voltage.
If the charger does not require either the time or
temperature backup features, they can both be easily
disabled. This is accomplished by biasing the t3/T ref Low
) +
in
+ 44 mV
D R(T
Low
3 T
High
VH(T)
I
30 m A
+ 1.46 k
input to a voltage greater than t2/T sen , and by grounding the
t1/T ref High input. Under these conditions, the Time/Temp
Select comparator output is low, indicating that the
The resistance change approximates a thermal hysteresis
of 2 ° C with a 10 k W thermistor operating at 0 ° C. The under
temperature fast charge inhibit feature can be disabled by
biasing the t3/T ref Low input to a voltage that is greater than
that present at t2/T sen , and less than V CC ? 0.7 V. Under
extremely cold conditions, it is possible that the thermistor
resistance can become too high, allowing the t2/T sen input
to go above V CC ? 0.7 V, and activate the timer. This
condition can be prevented by placing a resistor in parallel
with the thermistor. Note that the time/temperature
threshold of V CC ? 0.7 V is a typical value at room
temperature. Refer to the Electrical Characteristics table
and to Figure 4 for additional information.
The upper comparator senses the presence of an over
temperature condition. When the upper temperature limit is
exceeded, the comparator output sets the Overtemperature
Latch and the charger is switched to trickle mode. Once the
latch is set, the charger cannot be returned to fast charge,
even after the temperature falls below the limit. This feature
prevents the battery pack from being continuously
temperature cycled and overcharged. The latch can be reset
temperature mode is selected, and that the t2/T sen input is
biased within the limits of an artificial temperature window.
Charging of battery packs that are used in portable power
tool applications typically use temperature as the only
means for fast charge termination. The MC33340/342 can
be configured in this manner by constantly resetting the ? D V
detection logic. This is accomplished by biasing the V sen
input to ≈ 1.5 V from a two resistor divider that is connected
between the positive battery pack terminal and ground. The
V sen Gate output is also connected to the V sen input. Now,
each time that the Sample Timer causes the V sen output to go
low, the V sen input will be pulled below the undervoltage
threshold of 1.0 V. This causes a reset of the ? D V logic every
1.38 seconds, thus disabling detection.
Operating Logic
The order of events in the charging process is controlled
by the logic circuitry. Each event is dependent upon the input
conditions and the chosen method of charge termination. A
table summary containing all of the possible operating
modes is shown in Table 2.
Table 1. FAST CHARGE BACKUP TERMINATION TIME/TEMPERATURE LIMIT
Backup
Programming Inputs
Time Limit
Termination
Mode
Time
Time
Time
Time
Time
Time
Time
Temperature
t3/T ref Low
(Pin 5)
Open
Open
Open
Open
GND
GND
GND
0 V to V CC ? 0.7 V
t2/T sen
(Pin 6)
Open
Open
GND
GND
Open
Open
GND
0 V to V CC ? 0.7 V
t1/T ref High
(Pin 7)
Open
GND
Open
GND
Open
GND
Open
0 V to V CC ? 0.7 V
Fast Charge
(Minutes)
283
247
212
177
141
106
71
Timer Disabled
http://onsemi.com
8
相关PDF资料 |
PDF描述 |
|---|---|
| 18R473C | INDUCTOR RADIAL 47UH 1.65A |
| MRJ0070DF-A | C/A MRJ21/MRJ21 GBE ANGL CMR 7M |
| EEM08DTAD-S664 | CONN EDGECARD 16POS R/A .156 SLD |
| LM3423MHBKBSTEV/NOPB | BOARD EVAL BUCK BOOST LM3423 |
| EEM06DRST-S288 | CONN EDGECARD 12POS .156 EXTEND |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MC33348D-006 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| MC33348D-2R2 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| MC33350SN-7T1 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| MC33351ADTB-001 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| MC33351DTB-001 | 制造商:ON Semiconductor 功能描述: |
发布紧急采购，3分钟左右您将得到回复。