- 您现在的位置：买卖IC网 > PDF目录359132 > MC33701 (飞思卡尔半导体(中国)有限公司) 1.5 A Switch-Mode Power Supply with Linear Regulator(1.5 A开关方式电源，带线性稳压器) PDF资料下载
参数资料
| 型号： | MC33701 |
| 厂商： | 飞思卡尔半导体(中国)有限公司 |
| 英文描述： | 1.5 A Switch-Mode Power Supply with Linear Regulator(1.5 A开关方式电源，带线性稳压器) |
| 中文描述： | 1.5开关模式电源，线性稳压器（1.5 A的开关方式电源，带线性稳压器） |
| 文件页数： | 16/24页 |
| 文件大小： | 841K |
| 代理商： | MC33701 |
33701
16
Go to: www.freescale.com
Figure 12. Inverted Power Up/Down Sequence in +5.0 V
Supply System
Standard Power Sequencing
When the power supply IC operates in the Standard Power
Sequencing mode, the switcher output provides the core
voltage for the microprocessor. This situation and operating
conditions are illustrated in
Figure 10
and
Figure 11
.
Table 2
,
page 15, shows the Power Sequencing mode selection.
Inverted Power Sequencing
When the power supply IC is operating in the Inverted Power
Sequencing mode, the linear regulator (LDO) output provides
the core voltage for the microprocessor, as illustrated in
Figure 12
.
Table 2
shows the Power Sequencing mode
selection.
33701 POWER SEQUENCING
Requirements
1. I/O supply voltage not to exceed core voltage by more than
2.0 V.
2. Core supply voltage not to exceed I/O voltage by more
than 0.4 V.
Methods of Control
The 33701 has several methods of monitoring and
controlling the regulator output voltages, as described in the
paragraphs below. Power sequencing control is also achieved
through the intrinsic operation of the regulators. The EN1 and
EN2 pins can be used to disable the power sequencing (refer to
Table 2
, page 15.
Intrinsic Operation
For both the LDO and switcher, whenever the output voltage
is below the regulation point, the LDO external Pass FET will be
on or the Buck High-Side FET will be on at a duty cycle
controlled by the switcher. Because these devices are FETs,
current can flow in either direction, balancing the voltages via
the common supply pin. The ability to maintain the FETs on will
depend on the available gate voltage, and thus the size of the
boost regulator storage capacitor.
Standard Power Sequencing Control
Comparators monitor voltage differences between the LDO
(LDO pin) and the switcher (V
OUT
pin) outputs as follows:
1.
LDO > V
OUT
+ 1.8 V, turn off LDO.
The LDO can be
forced off. This occurs whenever the LDO output voltage
exceeds the switcher output voltage by more than 1.8 V.
2.
LDO > V
OUT
+ 1.9 V, shunt LDO to ground.
If turning off
the LDO is insufficient and the LDO output voltage
exceeds the switcher output voltage by more than 1.9 V,
a 1.0
shunt FET is turned on that discharges the LDO
load capacitor to ground. The shunt FET is used for
switcher output shorts to ground and for power down in
case of V
IN1
≠
V
IN2
with the switcher output falling faster
than the LDO.
3.
LDO < V
OUT
+ 1.7 V, cancel (1) and (2) above, re-enable
LDO.
Normal operation resumes when the LDO output
voltage is less than 1.7 V above the switcher output
voltage.
4.
LDO < V
OUT
- 0.2 V, turn off switcher.
The switcher can
be forced off. This occurs whenever the LDO is less than
V
OUT
- 0.2 V.
5.
LDO < V
OUT
- 0.3 V, turn on Sync (LS) FET and 1.0
V
OUT
sink FET.
The Buck High-Side FET is forced off and
the Sync FET is forced on. This occurs when the switcher
output voltage exceeds the LDO output by more than
300 mV.
6.
LDO > V
OUT
, reset (4) and (5) above.
Normal operation
resumes when LDO > V
OUT
.
V = 2.0 V
Max. Lead
V = 0.4 V
Max. Lag
V = 0.4 V
Max. Lag
V Start-Up
3.3 V I/O Voltage (V
OUT
)
1.8 V Core Voltage(V
LDO
)
5.0 V Input Supply
V = 2.0 V
Max. Lead
F
Freescale Semiconductor, Inc.
For More Information On This Product,
n
.
相关PDF资料 |
PDF描述 |
|---|---|
| MC33702 | 3.0 A Switch-Mode Power Supply with Linear Regulator(3.0 A开关方式电源，带线性稳压器) |
| MC33742 | System Basis Chip (SBC) with Enhanced High-Speed CAN Transceiver(带增强型高速CAN收发器的系统基片) |
| MC33790 | Two-Channel Distributed System Interface (DSI) Physical Interface Device(2通道分布式系统接口（DSI）物理接口) |
| MC33793 | Distributed System Interface (DSI) Sensor Interface(分布式系统接口（DSI）传感器接口) |
| MC33794 | Electric Field Imaging Device(电场成像设备) |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MC33720 | 制造商:PRIVATE LABEL 功能描述:AXIAL FAN, 254MM, 125VAC, 1A, Supply Voltage:125VAC, Flow Rate - Imperial:935cu. |
| MC33730EK | 功能描述:开关变换器、稳压器与控制器 SW MODE P/S W/ MULT REG RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel |
| MC33730EKR2 | 功能描述:开关变换器、稳压器与控制器 SW MODE P/S W/ MULT REG RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel |
| MC3373P | 制造商:Motorola Inc 功能描述: |
| MC33742DW | 功能描述:网络控制器与处理器 IC SBC-E-HS RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流（最大值）:595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray |
发布紧急采购，3分钟左右您将得到回复。