- 您现在的位置：买卖IC网 > PDF目录16408 > MC33886VWR2 (Freescale Semiconductor)IC H-BRIDGE 5.0A 20-HSOP PDF资料下载
参数资料
| 型号： | MC33886VWR2 |
| 厂商： | Freescale Semiconductor |
| 文件页数： | 8/28页 |
| 文件大小： | 0K |
| 描述： | IC H-BRIDGE 5.0A 20-HSOP |
| 标准包装： | 750 |
| 应用： | DC 电机控制器，H 桥式 |
| 评估套件： | 可供 |
| 输出数： | 1 |
| 电流 - 输出： | 5A |
| 电源电压： | 5 V ~ 40 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-SOIC（0.433"，11.00mm 宽）裸露焊盘 |
| 供应商设备封装： | 20-HSOP |
| 包装： | 带卷 (TR) |
| 配用： | KIT33886DHEVB-ND - KIT EVAL FOR MC33886 H-BRIDGE |
第1页第2页第3页第4页第5页第6页第7页当前第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
ELECTRICAL CHARACTERISTICS
DYNAMIC ELECTRICAL CHARACTERISTICS
DYNAMIC ELECTRICAL CHARACTERISTICS
Table 5. Dynamic Electrical Characteristics
Characteristics noted under conditions 5.0 V ? V+ ? 28 V and -40 ? C ? T A ? 125 ? C, unless otherwise noted. Typical values noted
reflect the approximate parameter mean at T A = 25 ? C under nominal conditions, unless otherwise noted.
Characteristic
Symbol
Min
Typ
Max
Unit
TIMING CHARACTERISTICS
PWM Frequency (20)
f PWM
–
–
10
kHz
Maximum Switching Frequency During Active Current Limiting
f MAX
–
–
20
kHz
Output ON Delay (22)
t d (ON)
? s
V+ = 14 V
Output OFF Delay (22)
V+ = 14 V
t D (OFF)
–
–
–
–
18
18
? s
Output Rise and Fall Time
t F , t R
? s
V+ = 14 V, I OUT = 3.0 A
2.0
5.0
8.0
Output Latch-OFF Time
Output Blanking Time
Output FET Body Diode Reverse Recovery Time (24)
t A
t B
t RR
15
12
100
20.5
16.5
–
26
21
–
? s
? s
ns
Disable Delay Time
t D (DISABLE)
–
–
8.0
? s
Short-circuit / Overtemperature Turn- OFF Time (26)
Power-OFF Delay Time
t FAULT
t POD
–
–
4.0
1.0
–
5.0
? s
ms
Notes
20. The outputs can be PWM controlled from an external source. This is typically done by holding one input high while applying a PWM
pulse train to the other input. The maximum PWM frequency obtainable is a compromise between switching losses and switching
frequency. Refer to Typical Switching Waveforms, Figures 10 through 17 , pp. 11–12 .
21. The Maximum Switching Frequency during active current limiting is internally implemented. The internal control produces a constant
OFF-time PWM of the output. The output load current effects the Maximum Switching Frequency.
22. Output Delay is the time duration from the midpoint of the IN1 or IN2 input signal to the 10% or 90% point (dependent on the transition
direction) of the OUT1 or OUT2 signal. If the output is transitioning High-to-Low, the delay is from the midpoint of the input signal to the
90% point of the output response signal. If the output is transitioning Low-to-High, the delay is from the midpoint of the input signal to
23. Rise Time is from the 10% to the 90% level and Fall Time is from the 90% to the 10% level of the output signal. See Figure 6 , page 9 .
24. Parameter is guaranteed by design but not production tested.
25. Disable Delay Time is the time duration from the midpoint of the D (disable) input signal to 10% of the output tri-state response. See
26. Increasing currents will become limited at I LIM . Hard shorts will breach the I SCH or I SCL limit, forcing the output into an immediate tri-
state latch-OFF. See Figures 8 and 9 , page 10 . Active current limiting will cause junction temperatures to rise. A junction temperature
above 160 ? C will cause the active current limiting to progressively “fold-back” (or decrease) to 2.5 A typical at 175 ? C where thermal
33886
Analog Integrated Circuit Device Data ?
8
Freescale Semiconductor
相关PDF资料 |
PDF描述 |
|---|---|
| MC33886DHR2 | IC H-BRIDGE 5.0A 20-HSOP |
| ACC06DRYH | CONN EDGECARD 12POS .100 DIP SLD |
| ACC07DRXN | CONN EDGECARD 14POS .100 DIP SLD |
| ACC07DRXH | CONN EDGECARD 14POS .100 DIP SLD |
| ACC06DRES | CONN EDGECARD 12POS .100 EYELET |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MC33887APVW | 功能描述:马达/运动/点火控制器和驱动器 H-BRIDGE W/LD CURNT FDBK RoHS:否 制造商:STMicroelectronics 产品:Stepper Motor Controllers / Drivers 类型:2 Phase Stepper Motor Driver 工作电源电压:8 V to 45 V 电源电流:0.5 mA 工作温度:- 25 C to + 125 C 安装风格:SMD/SMT 封装 / 箱体:HTSSOP-28 封装:Tube |
| MC33887APVW-PB | 制造商:Freescale Semiconductor 功能描述: |
| MC33887APVWR2 | 功能描述:马达/运动/点火控制器和驱动器 H-BRIDGE W/LD CURNT FDBK RoHS:否 制造商:STMicroelectronics 产品:Stepper Motor Controllers / Drivers 类型:2 Phase Stepper Motor Driver 工作电源电压:8 V to 45 V 电源电流:0.5 mA 工作温度:- 25 C to + 125 C 安装风格:SMD/SMT 封装 / 箱体:HTSSOP-28 封装:Tube |
| MC33887AVW | 功能描述:开关 IC - 各种 H-BRIDGE W/LD CURNT FDBK RoHS:否 制造商:Fairchild Semiconductor 开启电阻（最大值）: 电源电压-最大:4.4 V 电源电压-最小:2.5 V 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:WLCSP-9 封装:Reel |
| MC33887AVWR2 | 功能描述:马达/运动/点火控制器和驱动器 H-BRIDGE W/LD CURNT FDBK RoHS:否 制造商:STMicroelectronics 产品:Stepper Motor Controllers / Drivers 类型:2 Phase Stepper Motor Driver 工作电源电压:8 V to 45 V 电源电流:0.5 mA 工作温度:- 25 C to + 125 C 安装风格:SMD/SMT 封装 / 箱体:HTSSOP-28 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。