![](http://datasheet.mmic.net.cn/110000/MC56F8025VLD_datasheet_3506335/MC56F8025VLD_9.png)
Award-Winning Development Environment
56F8035/56F8025 Data Sheet, Rev. 6
Freescale Semiconductor
9
security systems, switched-mode power supply, power management, and medical monitoring
applications.
The 56800E core is based on a dual Harvard-style architecture consisting of three execution units
operating in parallel, allowing as many as six operations per instruction cycle. The MCU-style
programming model and optimized instruction set allow straightforward generation of efficient, compact
DSP and control code. The instruction set is also highly efficient for C compilers to enable rapid
development of optimized control applications.
The 56F8035/56F8025 supports program execution from internal memories. Two data operands can be
accessed from the on-chip data RAM per instruction cycle. The 56F8035/56F8025 also offers up to 35
General-Purpose Input/Output (GPIO) lines, depending on peripheral configuration.
The 56F8035 Digital Signal Controller includes 64KB of Program Flash and 8KB of Unified
Data/Program RAM. The 56F8025 Digital Signal Controller includes 32KB of Program Flash and 4KB of
Unified Data/Program RAM. Program Flash memory can be independently bulk erased or erased in pages.
Program Flash page erase size is 512 Bytes (256 Words).
A full set of programmable peripherals — PWM, ADCs, QSCI, QSPI, I2C, PITs, Quad Timers, DACs,
and analog comparators — supports various applications. Each peripheral can be independently shut down
to save power. Any pin in these peripherals can also be used as General Purpose Input/Outputs (GPIOs).
1.3 Award-Winning Development Environment
Processor ExpertTM (PE) provides a Rapid Application Design (RAD) tool that combines easy-to-use
component-based software application creation with an expert knowledge system.
The CodeWarrior Integrated Development Environment is a sophisticated tool for code navigation,
compiling, and debugging. A complete set of evaluation modules (EVMs), demonstration board kit and
development system cards will support concurrent engineering. Together, PE, CodeWarrior and EVMs
create a complete, scalable tools solution for easy, fast, and efficient development.
1.4 Architecture Block Diagram
illustrates how the 56800E system buses communicate with internal memories and the IPBus Bridge and
the internal connections between each unit of the 56800E core. Figure 1-2 shows the peripherals and
control blocks connected to the IPBus Bridge. Figures 1-3, 1-4, 1-5, 1-6, and 1-7 detail how the device’s I/O pins are muxed. The figures do not show the on-board regulator and power and ground signals. Please
those of other peripherals.
1.4.1
PWM, TMR and ADC Connections
Figure 1-6 shows the over-limit and under-limit connections from the ADC to the PWM and the
connections to the PWM from the TMR and GPIO. These signals can control the PWM outputs in a similar
manner as the PWM generator. See the 56F802x and 56F803x Peripheral Reference Manual for