参数资料
型号: MCP1640T-I/MC
厂商: Microchip Technology
文件页数: 12/32页
文件大小: 0K
描述: IC REG BOOST SYNC ADJ 0.1A 8DFN
标准包装: 3,300
类型: 升压(升压)
输出类型: 可调式
输出数: 1
输出电压: 2 V ~ 5.5 V
输入电压: 0.8 V ~ 5.5 V
频率 - 开关: 500kHz
电流 - 输出: 100mA
同步整流器:
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 8-VFDFN 裸露焊盘
包装: 带卷 (TR)
供应商设备封装: 8-DFN(3x2)
MCP1640/B/C/D
4.2
Functional Description
Figure 4-1 depicts the functional block diagram of the
The MCP1640/B/C/D is a compact, high-efficiency,
fixed frequency, step-up DC-DC converter that
provides an easy-to-use power supply solution for
applications powered by either one-cell, two-cell, or
three-cell alkaline, NiCd, or NiMH, or one-cell Li-Ion or
Li-Polymer batteries.
VOUT
MCP1640/B/C/D.
VIN
INTERNAL
BIAS
DIRECTION
CONTROL
I ZERO
SW
EN
GATE DRIVE
AND
SHUTDOWN
CONTROL
.3V
0V
SOFT-START
I LIMIT
LOGIC
I SENSE
GND
OSCILLATOR
SLOPE
COMP.
S
PWM/PFM
LOGIC
1.21V
FB
EA
FIGURE 4-1:
MCP1640/B/C/D Block Diagram.
4.2.1
LOW-VOLTAGE START-UP
50% of its nominal value. Once the output voltage
The MCP1640/B/C/D is capable of starting from a low
input voltage. Start-up voltage is typically 0.65V for a
3.3V output and 1 mA resistive load.
When enabled, the internal start-up logic turns the
rectifying P-Channel switch on until the output
capacitor is charged to a value close to the input
voltage. The rectifying switch is current-limited during
this time. After charging the output capacitor to the
input voltage, the device starts switching. If the input
voltage is below 1.6V, the device runs open-loop with a
fixed duty cycle of 70% until the output reaches 1.6V.
During this time, the boost switch current is limited to
DS22234B-page 12
reaches 1.6V, normal closed-loop PWM operation is
initiated.
The MCP1640/B/C/D charges an internal capacitor
with a very weak current source. The voltage on this
capacitor, in turn, slowly ramps the current limit of the
boost switch to its nominal value. The soft-start
capacitor is completely discharged in the event of a
commanded shutdown or a thermal shutdown.
There is no undervoltage lockout feature for the
MCP1640/B/C/D. The device will start up at the lowest
possible voltage and run down to the lowest possible
voltage. For typical battery applications, this may result
in “motor-boating” (emitting a low-frequency tone) for
deeply discharged batteries.
? 2011 Microchip Technology Inc.
相关PDF资料
PDF描述
MAX6800UR32D2+T IC RESET MPU LOW PWR SOT23-3
MCP1640DT-I/MC IC REG BOOST SYNC ADJ 0.1A 8DFN
MAX6805US38D2+T IC RESET MPU LOW PWR SOT143-4
MAX6805US38D1+T IC RESET MPU LOW PWR SOT143-4
MCP1640CT-I/MC IC REG BOOST SYNC ADJ 0.1A 8DFN
相关代理商/技术参数
参数描述
MCP1643-I/MC 制造商:Microchip Technology Inc 功能描述:
MCP1643-I/MS 制造商:Microchip Technology Inc 功能描述: 制造商:Microchip Technology Inc 功能描述:0.65V-5V INPUT LED DRIVER
MCP1643T-I/MC 制造商:Microchip Technology Inc 功能描述:0.65V-5V INPUT LED DRIVER - Tape and Reel 制造商:Microchip Technology Inc 功能描述:IC REG BOOST SYNC 8DFN 制造商:Microchip Technology Inc 功能描述:0.65V-5V input LED Driver, 8 DFN 2x3x0.9mm T/R
MCP1643T-I/MS 制造商:Microchip Technology Inc 功能描述:0.65V-5V INPUT LED DRIVER - Tape and Reel 制造商:Microchip Technology Inc 功能描述:IC REG BOOST SYNC 8MSOP 制造商:Microchip Technology Inc 功能描述:0.65V-5V input LED Driver, 8 MSOP 3x3mm T/R
MCP1650 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:750 kHz Boost Controller