- 您现在的位置：买卖IC网 > PDF目录10422 > MCP2021P-330E/MD (Microchip Technology)IC TXRX LIN ON-BOARD VREG 8DFN PDF资料下载
参数资料
| 型号： | MCP2021P-330E/MD |
| 厂商： | Microchip Technology |
| 文件页数： | 45/52页 |
| 文件大小： | 0K |
| 描述： | IC TXRX LIN ON-BOARD VREG 8DFN |
| 产品培训模块： | Microchip MCP20xx LIN Transceiver Overview |
| 标准包装： | 91 |
| 系列： | * |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页当前第45页第46页第47页第48页第49页第50页第51页第52页
2005-2012 Microchip Technology Inc.
DS22018F-page 5
MCP2021/2/1P/2P
1.0
DEVICE OVERVIEW
The MCP2021/2/1P/2P provides a physical interface
between a microcontroller and a LIN half-duplex bus. It
is intended for automotive and industrial applications
with serial bus speeds up to 20 Kbaud.
The MCP2021/2/1P/2P provides a half-duplex, bidirec-
tional communications interface between a microcon-
troller and the serial network bus. This device will
translate the CMOS/TTL logic levels to LIN-level logic,
and vice versa.
The LIN specification 2.0 requires that the trans-
ceiver(s) of all nodes in the system be connected via
the LIN pin, referenced to ground, and with a maximum
external termination resistance load of 510
Ω from LIN
bus to battery supply. The 510
Ω corresponds to 1 Mas-
ter and 16 Slave nodes.
The MCP2021/2/1P/2P-500 provides a +5V, 50 mA,
regulated power output. The regulator uses an LDO
design, is short-circuit protected, and will turn the
regulator output off if it falls below 3.5V.
The
MCP2021/2/1P/2P
also
includes
thermal-
shutdown protection.
The regulator is specifically designed to operate in the
automotive environment and will survive +43V load
dump transients, double-battery jumps, and reverse
battery connections when a reverse blocking diode is
used. The other members of the MCP2021/2/1P/2P-
330 family output +3.3V at 50 mA with a turn-off voltage
of
2.5V.
(See
MCP2021/2 wakes from Power-Down mode on a
dominant level on LBUS. MCP2021P/2P wakes at a
transition from recessive level to dominant level on
LBUS.
1.1
Optional External Protection
1.1.1
REVERSE BATTERY PROTECTION
An external reverse-battery-blocking diode should be
used to provide polarity protection (see Figure 1-6).
1.1.2
TRANSIENT VOLTAGE
PROTECTION (LOAD DUMP)
An external 43V transient suppressor (TVS) diode,
between VBB and ground, with a 50
Ω transient protec-
tion resistor (RTP) in series with the battery supply and
the VBB pin protect the device from power transients
(see Figure 1-6) and ESD events. While this protection
is optional, it is considered good engineering practice.
The resistor value is chosen according to Equation 1-1.
EQUATION 1-1:
1.2
Internal Protection
1.2.1
ESD PROTECTION
For component-level ESD ratings, please refer to the
1.2.2
GROUND LOSS PROTECTION
The LIN Bus specification states that the LIN pin must
transition to the recessive state when ground is discon-
nected. Therefore, a loss of ground effectively forces
the LIN line to a hi-impedance level.
1.2.3
THERMAL PROTECTION
The thermal protection circuit monitors the die temper-
ature and is able to shut down the LIN transmitter and
voltage regulator if it detects a thermal overload.
There are three causes for a thermal overload. A ther-
mal shut down can be triggered by any one, or a com-
bination of, the following thermal overload conditions:
Voltage regulator overload
LIN bus output overload
Increase in die temperature due to increase in
environmental temperature
Driving the TXD and checking the RXD pin makes it
possible to determine whether there is a bus contention
(i.e., Rx = low, Tx = high) or a thermal overload condi-
tion (i.e., Rx = high, Tx = low).
RTP <= (VBBmin - 5.5) / 250 mA.
5.5V = VUVLO + 1.0V,
250 mA is the peak current at Power-On when
VBB = 5.5V
相关PDF资料 |
PDF描述 |
|---|---|
| MCP2021T-500E/MD | IC LIN TXRX ON-BOARD VREG 8DFN |
| MCP2021T-330E/MD | IC LIN TXRX ON-BOARD VREG 8DFN |
| MCP2021-500E/MD | IC LIN TXRX ON-BOARD VREG 8DFN |
| MCP2021-330E/MD | IC LIN TXRX ON-BOARD VREG 8DFN |
| MS3106A24-2P | CONN PLUG 7POS STRAIGHT W/PINS |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MCP2021P-500E/MD | 功能描述:LIN 收发器 LIN Transceiver with Vreg and LIN RoHS:否 制造商:NXP Semiconductors 工作电源电压: 电源电流: 最大工作温度: 封装 / 箱体:SO-8 |
| MCP2021P-500E/SN | 功能描述:LIN 收发器 LIN Transceiver with Vreg and LIN RoHS:否 制造商:NXP Semiconductors 工作电源电压: 电源电流: 最大工作温度: 封装 / 箱体:SO-8 |
| MCP2021PT | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:LIN Transceiver with Voltage Regulator |
| MCP2021PT-330E/MD | 功能描述:LIN 收发器 LIN Transceiver with Vreg and LIN RoHS:否 制造商:NXP Semiconductors 工作电源电压: 电源电流: 最大工作温度: 封装 / 箱体:SO-8 |
| MCP2021PT-330E/SN | 功能描述:LIN 收发器 LIN Transceiver with Vreg and LIN RoHS:否 制造商:NXP Semiconductors 工作电源电压: 电源电流: 最大工作温度: 封装 / 箱体:SO-8 |
发布紧急采购，3分钟左右您将得到回复。