- 您现在的位置：买卖IC网 > PDF目录201871 > MCP25050-E/SL SPECIALTY MICROPROCESSOR CIRCUIT, PDSO14 PDF资料下载
参数资料
| 型号： | MCP25050-E/SL |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | SPECIALTY MICROPROCESSOR CIRCUIT, PDSO14 |
| 封装： | 0.150 INCH, PLASTIC, SOIC-14 |
| 文件页数： | 43/64页 |
| 文件大小： | 1232K |
| 代理商： | MCP25050-E/SL |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页当前第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页
MCP2502X/5X
DS21664C-page 50
2003 Microchip Technology Inc.
REGISTER 8-1:
CONFIGURATION REGISTER
8.4
Reset
The MCP2502X/5X differentiates between two kinds of
reset:
Power-on Reset (POR)
External RST reset
Some registers are not affected in any reset condition.
Their status is unknown on POR and unchanged in any
other reset. Most other registers are reset to a reset
state on Power-on Reset (POR), on RST and on RST
during SLEEP. They are not affected by a wake-up from
SLEEP, which is viewed as the resumption of normal
operation. A simplified block diagram of the on-chip
reset circuit is shown in Figure 8-3. The MCP2502X/5X
has a RST noise filter in the RST reset path. The filter
will detect and ignore small pulses.
8.4.1
POWER-ON RESET
A Power-on Reset pulse is generated on-chip when
VDD rise is detected (in the range of 1.5V to 2.1V). If the
RST input on the GP7 pin is selected, the RST pin may
be tied through a series resistor to VDD, eliminating the
need for external RC components usually required for
a Power-on Reset. A maximum rise time for VDD is
specified in Section 9.0 “Electrical Characteristics”
of this document.
When the device starts normal operation (exits the
reset condition), device operating parameters (voltage,
frequency, temperature, etc.) must be met to ensure
proper operation. For additional information, refer to
AN607, “Power-up Troubleshooting”, DS00607).
U-0
R/W-x
—
—R
R
bit 13
bit 8
R/W-x
R/W
R
RSTEN
FOSC1
FOSC0
bit 7
bit 0
bit 13-11
Unimplemented: Read as '0'
bit 10-3
Reserved: do not attempt to modify
bit 2
RSTEN: Enable RST input on GP7
1
=RST input Enabled
0
=RST input Disabled
bit 1-0
FOSC1:FOSC0: Oscillator Selection bits
11
= HS oscillator
10
= Reserved for Test (EC oscillator)
01
= XT oscillator
00
= LP oscillator
Legend:
R = Readable bit
W = Writable bit
U = Unimplemented bit, read as ‘0’
- n = Value at POR
‘1’ = Bit is set
‘0’ = Bit is cleared
x = Bit is unknown
相关PDF资料 |
PDF描述 |
|---|---|
| MCP25050-I/P | SPECIALTY MICROPROCESSOR CIRCUIT, PDIP14 |
| MCP25050T-I/SL | SPECIALTY MICROPROCESSOR CIRCUIT, PDSO14 |
| MSP430F412IPMR | 16-BIT, FLASH, 8 MHz, RISC MICROCONTROLLER, PQFP64 |
| MB90F548GLSPF | 16-BIT, FLASH, 16 MHz, MICROCONTROLLER, PQFP100 |
| M3727GM6-XXXSP | 8-BIT, MROM, 8.1 MHz, MICROCONTROLLER, PDIP42 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MCP25050-I | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:CAN I/O Expander Family |
| MCP25050I/P | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:CAN I/O Expander Family |
| MCP25050-I/P | 功能描述:网络控制器与处理器 IC Mixed signal Expandr RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流（最大值）:595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray |
| MCP25050-I/P | 制造商:Microchip Technology Inc 功能描述:Communication IC |
| MCP25050I/SL | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:CAN I/O Expander Family |
发布紧急采购，3分钟左右您将得到回复。