- 您现在的位置：买卖IC网 > PDF目录9357 > MCP40D18T-502AE/LT (Microchip Technology)IC POT 7BIT 5K I2C SC-70-6 PDF资料下载
参数资料
| 型号： | MCP40D18T-502AE/LT |
| 厂商： | Microchip Technology |
| 文件页数： | 27/43页 |
| 文件大小： | 0K |
| 描述： | IC POT 7BIT 5K I2C SC-70-6 |
| 标准包装： | 3,000 |
| 接片： | 128 |
| 电阻（欧姆）： | 5k |
| 电路数： | 1 |
| 温度系数： | 标准值 150 ppm/°C |
| 存储器类型： | 易失 |
| 接口： | I²C |
| 电源电压： | 1.8 V ~ 5.5 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 6-TSSOP（5 引线），SC-88A，SOT-353 |
| 供应商设备封装： | SC-70-5 |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页当前第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页
2009 Microchip Technology Inc.
DS22152B-page 33
MCP40D17/18/19
5.0
SERIAL INTERFACE -
I2C MODULE
A 2-wire I2C serial protocol is used to write or read the
digital potentiometer’s wiper register. The I2C protocol
utilizes the SCL input pin and SDA input/output pin.
The I2C serial interface supports the following features:
Slave mode of operation
7-bit addressing
The following clock rate modes are supported:
- Standard mode, bit rates up to 100 kb/s
- Fast mode, bit rates up to 400 kb/s
Support Multi-Master Applications
The serial clock is generated by the Master.
The I2C Module is compatible with the Phillips I2C
specification. Philips only defines the field types, field
lengths, timings, etc. of a frame. The frame content
defines the behavior of the device. The frame content
for the MCP40D17, MCP40D18, and MCP40D19
devices are defined in this section of the data sheet.
FIGURE 5-1:
Typical Application I2C Bus
Configurations.
Refer to Section 2.0 “Typical Performance Curves”,
AC/DC Electrical Characteristics table for detailed input
threshold and timing specifications.
5.1
I2C I/O Considerations
I2C specifications require active low, passive high
functionality on devices interfacing to the bus. Since
devices may be operating on separate power supply
sources, ESD clamping diodes are not permitted. The
specification recommends using open drain transistors
tied to VSS (common) with a pull-up resistor. The
specification makes some general recommendations
on the size of this pull-up, but does not specify the
exact value since bus speeds and bus capacitance
impacts
the
pull-up
value
for
optimum
system
performance.
Common pull-up values range from 1 k
Ω to a maximum
of ~10 k
Ω. Power sensitive applications tend to choose
higher values to minimize current losses during
communication but these applications also typically
utilize lower VDD.
The SDA and SCL float (are not driving) when the
device is powered down.
A "glitch" filter is on the SCL and SDA pins when the pin
is an input. When these pins are an output, there is a
slew rate control of the pin that is independent of device
frequency.
5.1.1
SLOPE CONTROL
The device implements slope control on the SDA
output. The slope control is defined by the fast mode
specifications.
For Fast (FS) mode, the device has spike suppression
and Schmidt trigger inputs on the SDA and SCL pins.
Single I2C Bus Configuration
Host
Controller
Device 1
Device 3
Device n
Device 2
Device 4
相关PDF资料 |
PDF描述 |
|---|---|
| MCP40D18T-104AE/LT | IC POT 7BIT 100K I2C SC-70-6 |
| VI-B3D-MY-F1 | CONVERTER MOD DC/DC 85V 50W |
| MCP40D18T-103AE/LT | IC POT 7BIT 10K I2C SC-70-6 |
| VI-B6P-MV | CONVERTER MOD DC/DC 13.8V 150W |
| VI-B3B-MY-F4 | CONVERTER MOD DC/DC 95V 50W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MCP40D18T-502E/LT | 功能描述:数字电位计 IC 50k I2C sngl 7-bit volatile memory RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel |
| MCP40D18T-503AE/LT | 功能描述:数字电位计 IC 50k I2C single 7-bit Volatile memory RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel |
| MCP40D18T-503E/LT | 功能描述:数字电位计 IC 50k I2C sngl 7-bit volatile memory RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel |
| MCP40D19 | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:7-Bit Single I2C? (with Command Code) Digital POT with Volatile Memory in SC70 |
| MCP40D19-103AE/LT | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:7-Bit Single I2C? (with Command Code) Digital POT with Volatile Memory in SC70 |
发布紧急采购，3分钟左右您将得到回复。